Why does my Redmi phone factory reset and won t turn on? Stayed at MI all the time

First of all, you must be clear about why your phone does not turn on.

There are two kinds of problems with the phone not turning on: hardware or software, and system. If there is an external force, such as being dropped, pressed, flooded, overheated, etc., it must be a hardware problem.

If you have some software, delete some system files, or can't boot after flashing, this is generally a software or system problem. Understand the problem** problem and solve it. There are two situations in which the phone does not turn on, and the solutions are as follows.

The phone is on and responds but can't be turned on normally:

This is the most common situation where your phone won't turn on. When the phone is turned on, there is a vibration and sound, but the screen is dark; After the mobile phone is turned on, it has been stuck in the logo interface and cannot enter the operation interface; There is also the fact that the mobile phone can enter the normal interface but there is no response when you click on anything, etc., which is the most common manifestation of abnormal boot.

First things first: check your phone's battery. The reaction when the phone is turned on proves that the battery is still working, and in addition to the aging of the battery and water ingress, the battery problem can be ruled out.

If the battery is aging, you can try it with the same type of battery, and if it can be turned on normally, then replace it with a battery; If it is water, turn on the device when the water has not yet dried, it will cause a short circuit in the battery, and the phone will only run for a while, and the battery will be damaged due to a short circuit, you can wait for a day or two for the phone to completely dry and change the battery.

Then: check your phone screen. Under the destruction of external forces, the screen fails, especially some mobile phones themselves are soldered, which is particularly prone to "fake not booting" caused by the screen.

Although only a slight fall, but the mobile phone screen is no longer responsive due to the disconnection of the line, at this time you can tap the phone, a few more shots, if the mobile phone screen will flash from time to time, this proves that the mobile phone is only a certain line of problems, you can disassemble the machine after finding the disconnected solder joint to re-weld, or go to the repair point for repair. Especially when the phone vibrates and sounds normally when it is turned on, but the screen does not respond. This is especially the case for consideration.

Again: Check if you can enter recovery, consider flashing. Both of the above are hardware problems, but the phone can't be turned on completely normally, because there are many software or system problems.

If the phone is just stuck in the logo screen or can not be operated when booted into the interface, then check whether the phone can enter recovery, press and hold the power button + volume down key, if the phone enters the following screen, and can move the cursor by moving the volume + and - keys of the mobile phone, then the phone can be solved by flashing.

Solution: 1. Enter the recovery mode (press and hold the volume down button + power button when the split reed is turned off), note that after entering the recovery menu mode, the volume down button is "Select", and the upper button is "OK".

2. In this state, press the "Volume Down Button" to select Recovery, and then press the "Volume Up Source Stool Button" to confirm.

3. After seeing the Android picture, press the power button to enter the menu.

4. Press the "Volume Down Button", select "Wipe Data Factory Reset", and then press the "Volume Up Button" to confirm.

5. Select Yes, confirm, and wait for completion.

6. In this step, press the power button to see the background action**, and then press it again to see the wiping data layer. If you are afraid of crashing, you can click to confirm, restart it after completion, and you can enter the system.

1. Press and hold the power button and the volume down button at the same time in the shutdown state, and let go of the button after lighting up the screen, and you will see three options;

2. At this time, the volume down button is the selection key, the volume up button is the OK key, press the volume down button to move the cursor to "recovery mode" and then press the volume up button to confirm;

3. Wait for a while, a green Android robot lying on the ground will appear, and finally press the power button to enter;

4. Press the power button again, and the menu will appear;

5. At this time, the volume up button is the confirmation key, and the volume down button is selected to "wipe data factory reset" to confirm, and a menu will appear after confirmation, select "yes"."Are you sure;

6. Go back, select "wipe cache partition", OK, select "yes".", after the end of the waiting progress bar, bow your head or press back, select "Reboot System Now", and the phone will start to restart automatically.