Whether the computer is infected with a virus or the monitor is broken

Updated on number 2024-08-05
14 answers
  1. Anonymous users2024-02-15

    It should be a hardware problem.,The biggest possibility is the graphics card.,If it's a virus, it will rarely affect the display.,The most obvious thing is that the hard disk reads are enlarged.。 There is also a possibility that there is a problem with the display, and the problem I had before is very similar to your problem, mine is that the graphics card is broken, and then I took it to fix it, and this phenomenon is gone.

  2. Anonymous users2024-02-14

    It shouldn't be a problem with the graphics card!If it's a problem with the graphics card, why is it that your machine is always fine for a few days! It should be in the middle"Orange August".

    In addition to the common harm, viruses can also cause mainstream antivirus software and personal firewalls to be unable to open, and even cause the system to appear "blue screen", automatic restart, crash and other conditions during anti-virus operation! Rising "Orange August Special Extraction Removal Tool" **Address:

    It is recommended that you restart your computer, press and hold the F8 key, select "Safe Mode", and use this tool to kill viruses after entering.

    Then use the Trojan to kill the customer in safe mode.

  3. Anonymous users2024-02-13

    There is a magnetic field interference around.

    The power supply voltage is unstable3Please check the monitor, graphics card driver.

    Increase the refresh rate by 75Hz

  4. Anonymous users2024-02-12

    If it is too jitter, there are two possibilities.

    1. Magnetic field interference.

    2 Refresh rate. Personally, I think it's a hardware problem, you check if the wiring of the monitor is loose, or the connector part of the plug and the cable is aging, and then check whether the graphics card is secure. There is also whether the graphics card driver is installed normally, and whether the version of the graphics card driver is official.

    Or refresh or resize the resolution too high.

  5. Anonymous users2024-02-11

    I've never seen a poisoned display break.

  6. Anonymous users2024-02-10

    Check that the graphics card is plugged in. Whether there is looseness.

  7. Anonymous users2024-02-09

    Please determine what screen you are using on your laptop, if it is an LCD, there may be several situations.

    1.The screen is broken or rotten (including the backlight tube is broken, if the backlight tube is damaged alone, you look at the screen carefully when you turn it on, there is still an image, but the screen is very dark and you can't see clearly.) )。

    Solution, if it is within the warranty period, please get the customer service replacement or call the customer service to request a door-to-door replacement.

    2.The high line connecting the screen to the motherboard is damaged or detached. The treatment method is the same as 1

    3.The transformer plate of the screen is damaged, causing the backlight to not light up. The treatment method is the same as 1

    4.It's likely that you've accidentally touched a shortcut for screen switching. However, this situation is rarely when the device is turned on, but it is possible.

    If it's convenient, connect an external monitor, and press fn+f after powering it on? (f?represents the button that has a screen switch icon on it) to see if you can light up the screen.

    5.The resolution set by the system is too high. However, in this case, the screen will not light up only after entering the system, and the shirt will light up when it is turned on.

    If it is an LED screen, please try LCD Step 4, if the situation is not restored, please take it directly to customer service or call customer service.

  8. Anonymous users2024-02-08

    Analysis: You only need to move the host to send it for repair. If you have a certain hands-on ability, it is recommended to do it yourself, reinstall the system first, and then completely disinfect the virus.

    2) Set the CD to boot: press the DEL key (the notebook is generally F2 or the hotkey prompted at the bottom of the screen) to enter the CMOS after booting, and set the optical drive (CD-ROM or ***-ROM) as the first boot item in the Boot tab (or Startups) (the old motherboard needs to enter the Advanced BIOS Features tab, press Enter at "1st Boot Device", and then select CD ***-ROM), Press F10 again to save and exit the reboot. Insert the system disc into the optical drive in time when you restart the computer.

    3) Clone and install the system: After the disc is successfully started, the function menu will be displayed, at this time, select "Install the system to the first partition of the hard disk" in the menu, press enter to confirm and follow the prompts, or after entering the PE system, run the "one-click installation system" on the desktop, the computer will automatically run the GHOST software to automatically load the GHO file and clone and install it to the C area, the whole process basically does not require manual intervention, until the last entry into the system desktop.

  9. Anonymous users2024-02-07

    Hello, the monitor has no storage function, it will not be infected with computer viruses, and you can use it with confidence.

    If there is a virus in the computer, use anti-virus software to check and kill it.

    Method: If you are satisfied, please like it

  10. Anonymous users2024-02-06

    No, the display will not be poisoned, it belongs to the hardware configuration, but others can increase some output through software viruses, etc., to destroy your hardware facilities.

  11. Anonymous users2024-02-05

    If it is a monitor with an operating system, there is a possibility of a virus.

    In fact, each monitor has its own decoding software,I've encountered several times when I do maintenance The display keeps changing color,Take it to the after-sales service and reflash the software before it is solved!

  12. Anonymous users2024-02-04

    It's just that the driver of your graphics card may not be driven.

  13. Anonymous users2024-02-03

    Hello. Use PC Manager - Antivirus - Comprehensive Detection and Killing, you can solve the problem of computer poisoning.

    In addition, when using the computer in the future, pay attention to the synchronous opening of the computer manager, which has 16 layers of real-time protection function, which can protect the computer security from Trojan viruses from Internet security, application entrance, and the bottom layer of the system.

    If you have any other questions and problems, welcome to come to the computer manager platform again.

    Ask us questions and we'll do our best to answer your questions.

  14. Anonymous users2024-02-02

    There are loopholes, it's like people who don't have strong resistance and get sick.

Related questions
11 answers2024-08-05

Troubleshooting steps: 1. Driver problems, which are also an important cause of blurred screens, mostly occur after changing the driver version of the graphics card, or may be caused by driver file corruption. The solution is very simple, reinstall and install the official graphics card driver. >>>More

4 answers2024-08-05

The motherboard is a little more likely, or it may be a problem with the graphics card, you first unplug the graphics card and clean it up, as well as the memory, and try again.

5 answers2024-08-05

This must be able to see.,It's just the display that you're broken.,The data is still there.,The phone can see it.,Open it and take a look.。

9 answers2024-08-05

After the high-voltage board is damaged, the backlight of the LCD loses power and does not light up, causing the display to go black. >>>More

5 answers2024-08-05

If the pressure is too heavy due to the use time for too long, and something magnetic is nearby, turn off the monitor and then turn it on to see if it can be normal.