How to clean the HP computer keyboard?

What kind of problem is it? Is the keyboard dusted? Or is it flooded?

If it's into the dust! It's simple! Take a hair dryer and blow at a 45-degree angle to the keyboard, and you're good to go!!

Remember not to take a hot blow! Easy to damage the keyboard! If it's water ingress!

Sorry, you'll have to take it to the merchant for repairs! If you were told how to do it, you wouldn't be able to do it yourself! If the keyboard is broken, you have to pay for it yourself, which is not cost-effective!!

It is recommended not to soak it with a small brush to clean it and then spray it with a foam cleaner and wipe it with a rag If you want to clean it thoroughly, you can buckle each key (I have deducted) but there is a certain degree of danger Because if you buckle too hard or the angle is not right, it is easy to damage the small plastic clip below and also remove the rubber pad, so if you really want to buckle, you should be as careful as possible Generally, you can remove the oil and dust on the surface with foam cleaning agent.

The main thing is to clean up the computer repair company, otherwise it is easy to go wrong Go forward and help you solve problems, I hope ours will make you happy.

Use a screwdriver to unscrew the screws on the back of the keyboard. It should be noted here that some keyboards are not opened by unscrewing the screws on the back, and there are two or three screws under the keys on the front of the keyboard, and some of the keys need to be pried off the keyboard to see the rest of the screws.

After removing all the keys on the keyboard, we will find that in fact, the circuit part of the keyboard is still very clean, and there is no need to clean, mainly because the keys and the front panel of the keyboard are dirty, and we only need to clean these two parts. Soak the buttons and front panel in water with detergent for a while, and then gently wash them with a soft cloth or brush, and the dirt that has accumulated for a long time will be easily cleaned.

Finally, let the cleaned keyboard dry for a few hours or use a hair dryer to install the keyboard as it is. It should be reminded that some keys have reeds, and the reeds should be installed when installing, otherwise the keys will be damaged if used for a long time.

1. We can first take the computer keyboard off the computer, the keys are facing down, gently pat the back of the keyboard, and gently shake the keyboard after patting, and dirty things such as cigarette ash, biscuit residues, and hair will fall out.

2. Turn the keyboard keys up, gently tap them, and use a hair dryer to blow on the gap of the keyboard, which can blow off some of the gaps attached to the keyboard. Stubborn stains.

3. After blowing, scrub the surface of the keyboard with a wet rag, it is best to use computer cleaner here, the computer cleaner adopts the foam cleaning method, which not only has the effect of sterilization, but also prevents the moisture squeezed out by the wet rag when cleaning the keyboard from penetrating into the inside of the keyboard and causing the internal rust and failure of the keyboard.

4. After cleaning, you can use alcohol and disinfectant to disinfect, but in the process of disinfection, it may cause it to corrode the keyboard after chemical reaction with air, resulting in the letters on the keyboard being unclear or corroded.

When cleaning the keyboard, turn off the computer and remove the power cord and battery (if the computer is a removable battery).

You can use a commercially available keyboard cleaning brush or blow up a balloon to remove dust between the keys.