How to clean the filter of Gree air conditioner model KFR 50LW E 50568L FdNaC2A?

Tools Material: Gree KFR-50LW E (50568L) FDNAC2A air conditioner, screwdriver.

The lower part of the Gree KFR-50LW E (50568L) FDNAC2A air conditioner is the wind baffle, and the filter is inside the wind baffle.

Then open the covers on both sides of the wind deflector of the Gree KFR-50LW E (50568L) FDNAC2A air conditioner.

Use a screwdriver to unscrew the screws afterward.

Then pinch the buttons on both sides of the wind deflector of the Gree KFR-50LW E(50568L) FDNAC2A air conditioner, and pull the wind deflector outward.

After that, take down the wind deflector of the Gree KFR-50LW E (50568L) FDNAC2A air conditioner.

Then clean the filter in the wind deflector of the Gree KFR-50LW E (50568L) FDNAC2A air conditioner.

After that, take out the filter.

Then rinse the other side.

Finally, the filter is cleaned, and by the way, the air outlet gap of the wind deflector of the Gree KFR-50LW E (50568L) FDNAC2A air conditioner is also rinsed.

Use a brush vacuum cleaner to dust the filter, and then wash it with clean water. When it is too dirty and oily, it can be cleaned with detergent or neutral soapy water, rinsed with water and dried.

When cleaning the filter, first cut off the power supply, then open the panel and take out the filter.

It should be noted that it must not be washed with hot water above 40 degrees. Do not use laundry detergent, dish soap, gasoline, banana water, etc., to avoid deformation of the filter.

Carefully rinse the filter with clean water several times, with a soft brush, and finally dry it in a ventilated place until it dries thoroughly. Be sure not to bend the filter when cleaning, although it is elastic, but the plastic one can not withstand bending.

In addition, after rinsing with clean water, wipe dry with a soft cloth or blow dry in a cool place, and never expose to the sun or dry in an open flame such as a stove to avoid deformation of the filter. After installing the filter, plug in the power and wait for 3-5 minutes, set the remote control to the refrigeration mode, set the temperature to the lowest condition, and turn on the machine.

Method of removing the panel:

Before disassembling the air conditioner filter, carefully open the air conditioner shell, generally the air conditioner shell has two small card slots stuck, and gently pull the outer cover outward.

After opening the outer cover of the air conditioner, there are often two buckles inside, and it is necessary to gently pick open the outer cover to fully open. Then it is to take the filter, the filter is relatively easy to take, but it is stuck by a few card slots, first push the filter up, and then gently drag the filter down after the card slot.

The role of air conditioner filter cleaning:

The filter mainly plays the role of air purification and dust prevention in the air conditioner, preventing the internal parts of the air conditioner from being blocked by large dust, causing unnecessary failures of the air conditioner.

When the air conditioner is in use, if the filter screen is dirty and blocked, it will cause the temperature of the air outlet of the air conditioner to be very low, so that the air blowing is not far away, and the circulation in the room will be slowed down, which will affect the use of the air conditioner, and if there is too much dirty blockage, it will also block the drainage system or evaporator, etc., so that the air conditioner will leak and other faults.

At this time, the air conditioner needs to be cleaned to avoid such failures.

Turn off the power supply, press the part that usually rotates when the machine is turned on, rotate to the right hand direction until the air intake filter rotates to the front, two filters up and down, two buckles each, a screw, remove!

There is a small cover in the middle of both sides, open the screws, buckle it and open it in your own direction, take out the filter screen, clean it with water, add an appropriate amount of washing spirit, wipe off the water, and then put it back on.

1) There is a small detachable cover on the right fence, insert it into it with a flat screw (from the right side when it is facing it) and open it when you knock it.

2) There is a screw inside, unscrew it with a Phillips screwdriver.

3) Then use a flat-blade screwdriver to insert it from the middle and pry open the front panel.

If you want to bargain, go to Jingdong and Newegg to learn about it. It's basically the same. See how the giveaways are.

The specific cleaning method is as follows:

1. Power off: First of all, the power supply of the air conditioner is unplugged, although it is a simple job to take the filter, but the operation is to be operated in the case of power failure. Be sure to stay safe. Sometimes the hang-up is in a relatively high position, so you must pay attention to safety at this time.

2. Open the front cover.

Figure 1. <>

Figure II. 3. Take out the filter screen and clean it: take out the filter screen, the filter screen is generally two, gently pull it out along the arc of the air conditioner, and do not use too much force to break the filter screen. Then rinse with a shower, the water flow should not be too fast, so as not to break the filter.

Former Zen Figure 1.

Figure II. 4. Filter drying: After cleaning, put it in a cool place to dry and dry completely.

Figure 1. <>

Figure II. 5. Install the filter screen and plug in the power supply: After the filter screen is dry, install the filter screen along the arc of the air conditioner, then cover the front cover of the air conditioner and plug in the power supply.

6. When cleaning the filter screen, you will find that the air of the external unit is good, and the dust of the filter screen is more. There is a lot of sand around the external unit, and there is also a lot of sand on the filter, so try to clean it up in time after windy weather.

7. In the case of daily household use, it is also necessary to clean the filter once a month in the summer, and now the air conditioner has a self-cleaning function, which is only for the internal condensation plate of the air conditioner to form water droplets through automatic heating and refrigeration to achieve the role of self-cleaning, and the filter screen still has to be cleaned manually.

Summary. Hello dear! We're happy to answer your <>

1. First of all, we need to remove the panel: find the air inlet on the side of the air conditioner, press the movable door up to open the filter panel. 2. Then remove the filter screen from the panel; Find the zipper of the air conditioner filter and pull out the filter outward (the same is true for the filter on the other side).

3. Finally, clean and restore the filter: you can directly rinse with water or wash with a brush. Insert the filter in place and put it back into the panel.

Haier air conditioner KFR-50LW cleaning filter.

Hello dear! We're happy to answer your <>

1. First of all, we need to remove the panel: find the base circle of the air inlet on the side of the air conditioner, and press the movable door to open the filter panel. 2. Then remove the filter screen from the panel; Find the zipper of the air conditioner filter and pull out the filter outward (the same is true for the filter on the other side).

3. Finally, clean and restore the filter: you can directly rinse with water or wash with a brush. Insert the filter in situ according to the belt pattern and put it back into the panel.

Haier air conditioner KFR-50LW cleaning filter method two: 1, remove the Kailu board; Some have screws on both sides of the left and right shirts, and some only have one screw in the middle or right side. 2. Remove the filter; There is a screw in the middle of the upper part of the filter screen.

3. Clean the filter screen; Stare directly at the area where rinsed with water or brushed with a bristle brush. 4. Install the filter screen and panel to restore the original state.

It mainly includes the following steps:

Turn off the power of the air conditioner, unplug it, and open the window for ventilation.

Remove the dust filter and air purifying filter (some air conditioners do not have one) to expose the heat exchanger fins.

Shake the air conditioner cleaner well, and spray evenly at a distance of 5cm from the heat sink: air conditioners below 2P can be used for 1 minute, and air conditioners above 2P can be used for 2 minutes.

Wait for 15 minutes after the end of spraying, replace the dust filter and air purification filter, turn on the machine for 15 to 30 minutes, and the sewage will be automatically discharged from the drain pipe.

Spray the air cleaner on the air conditioner enclosure and dust filter.

After waiting 15 minutes, wipe clean with a rag.