How to enhance the WIFI signal if it is too weak

Here's how you can boost your WiFi signal:

1. Update your WiFi device.

2. Set the best channel:

1) Log in to the router's management page;

2) Click "Basic Settings", change the "Default Channel", and select another better channel.

3. Adjust the position:

1) a central location in the home;

2) Keep away from interfering equipment;

3) Reasonable placement of antennas.

Fourth, prevent the outside from rubbing the net.

Fifth, the installation of auxiliary settings.

1. Check the mobile phone case.

If your phone uses a metal, magnetic case or bracket that has an impact on the Wi-Fi signal, it is recommended that you remove it and try it.

2. Check the environmental causes.

The strength of the wifi signal is related to the use environment (such as walls, distances, etc.), if the signal is weak and the Internet is slow, it is recommended to adjust the distance between the mobile phone and the wifi router before trying.

3. Reset the network settings.

Go to Settings - System Management - Backup & Reset - Reset Network Settings - Select the corresponding SIM card - Reset Settings, and then use View.

Note: Resetting network settings resets Wi-Fi, mobile data, and Bluetooth connection records.

4. Service center testing.

If the above methods do not solve your problem, please back up your mobile phone data in advance, and bring your mobile phone and purchase voucher to vivo customer service center for testing.

In addition: Method 1: Antenna gain.

Normally, it's okay for a wireless router to pass through one load-bearing wall, and it's okay to pass through two load-bearing walls with better performance.

Generally speaking, from single antenna to double antenna to triple antenna, the signal strength is arranged from weak to strong, and of course, the price is from low to high. In addition, there are single frequency and double frequency of routing, single frequency refers to a single frequency, and dual frequency refers to two frequencies and 5GHz, which has stronger anti-interference ability and relatively better signal.

Method 3: Add power modems.

A relatively general solution is to use the power modem, which is a device that transmits network signals through wires, and is generally sold in pairs. The earlier power cat does not have the dial-up function, and there is no built-in wireless module, and can not be used independently, the router needs to be used together, one of them is plugged into the socket near the router, and a network cable is connected to the power cat from the router LAN port, and the other can be plugged in the room with a bad signal, and from this power modem, you can contact a wireless AP or wireless router as an AP, and the signal must be full.