Does driving a new car to 160 at a time have an effect on the engine

1. For new cars that have been run-in, 160 kilometers is not the maximum limit, and this is allowed. For a short time there is damage to the face.

The speed of kilometers is super high, and if it runs for a long time, it will be harmful to the engine.

3. When the speedometer exceeds the red line, it belongs to the speed limit area, which should be carefully grasped, otherwise it is likely to cause engine damage or cause accidents due to operation errors due to high speed.

There should be an impact. New cars generally have a break-in period. The maximum speed should be limited during this period.

At the end of the run-in period, the oil should be changed. Then you can accelerate, let's say 160 yards. Otherwise, it will affect the engine life.

This is because, all the parts are new and have burrs on them, which need to be run-in to get the burrs off and make the parts fit better in the future.

A new car running 160 miles will generally not have much impact on the car, but it is recommended that you avoid rapid acceleration before the first warranty of a new car. After the first insurance, it is recommended that you pull the highway. New car break-in period.

Generally in the range of 1000 km to 3000 km, the speed of the new car run-in period should not be too fast, generally controlled between 50-90km h, some models can be slightly higher, the maximum speed during the run-in period can be controlled within 100km h, the speed does not exceed 2200 rpm.

New car run-in method:

1. Preheat up at the start: After the engine starts, as long as it can maintain a stable speed, you can start walking, before the water temperature rises, properly control the speed, and wait for the water temperature to be normal. During the run-in period, avoid slamming on the accelerator and avoiding slamming on the brakes;

2. Don't drive at high speed: There are speed regulations for new cars at the initial stage, and domestic cars.

Generally within 40-70 km/h; Imported cars are generally stipulated in the first 1000 kilometers, when the throttle is fully open, the speed does not exceed 80 of the maximum speed, and it is required to pay attention to the engine tachometer and speedometer in use, so that the engine speed and speed are working at medium speed;

3. Add gasoline with good quality: the engine oil used in the new car cannot be lower than the label specified by the manufacturer. Under the condition that the economic capacity allows, it is necessary to add gasoline of better quality as much as possible. Do not add anti-abrasion oleacein, so as not to have enough mileage and insufficient running-in.

How to go to the smell and formaldehyde of the new car.

The smell and formaldehyde in the normal new car are mainly the items that can be seen in the car: such as floor mats, floor mats, seats, cloth or chemical fiber materials on the inner wall of the car and chemical fiber materials in the trunk, etc., so we can go to the car wash shop to wash the car with steam disinfection. Do not do it often, it is easy to cause electrical aging.

After cleaning, an appropriate amount of activated carbon can be inserted.

Treatment, and maintain proper ventilation in the car, generally 10-15 days is about the same.

The impact will not be very large, now that the automobile manufacturing industry is developed, the car engine has been cold-run after assembly, even if it is not run-in, it will not have an impact.

For a new car, the break-in period should be done at the beginning. During the run-in period, it is generally driven to 80 miles. If you get 160 yards, then that can wear out your parts mechanically.

New cars generally won't have much of an impact, but it is recommended that you avoid rapid acceleration, and I hope mine will help you.

If you just buy a new car, it's best not to drive it at such a high speed all at once, it still has an impact on the car, but if it's once or twice, it won't have much impact, and it will have a great impact in the long run.

It didn't have much of an impact.

Safe, healthy and happy every day! Hahaha!

Summary. Dear, hello, the new car is driven to 160 at a time, and this has little impact on the engine. First, it is not recommended to run at high speed during the run-in period of the new car, that is, before the first maintenance, which is not beneficial to the vehicle engine.

But the occasional one doesn't have much of an impact. Second, it is recommended to run at high speed after the first maintenance, because the oil added by the vehicle is a run-in oil. Third, when the vehicle is driving normally, we must develop good driving habits, do not rush, accelerate and brake sharply, and maintain a cloud speed.

Hello, I wish you a happy life, if you have any questions, you can consult at any time, I will reply to you as soon as possible.

Dear, hello, the new car is driven to 160 at a time, and this has little impact on the engine. First, the new car is not built or runs at high speed during the run-in period, that is, before the first maintenance of the orange group, which is not beneficial to the vehicle engine. But the occasional one doesn't have much of an impact.

Second, it is recommended to run at high speed after the first maintenance, because the oil added by the vehicle is a run-in oil. Third, when the vehicle is driving normally, we must develop good driving habits, do not rush, accelerate and brake sharply, and maintain a cloud speed. Have a good day, I wish you a happy life, if you have any questions, you can consult at any time, I will reply to you as soon as possible.

Dear, hello, the new car is driven to 160 at a time, and this has little impact on the engine. First, the new car is not built or runs at high speed during the run-in period, that is, before the first maintenance of the orange group, which is not beneficial to the vehicle engine. But the occasional one doesn't have much of an impact.

Second, it is recommended to run at high speed after the first maintenance, because the oil added by the vehicle is a run-in oil. Third, when the vehicle is driving normally, we must develop good driving habits, do not rush, accelerate and brake sharply, and maintain a cloud speed. Have a good day, I wish you a happy life, if you have any questions, you can consult at any time, I will reply to you as soon as possible.

Summary. When the vehicle travels above the maximum set speed, it will be subjected to additional side loads, which, together with the additional energy consumption of the engine itself, will reduce the life of the engine. At the same time, driving at such high speeds will also increase the temperature and friction inside the engine, which in turn will accelerate the aging of the engine.

In addition, overspeeding can overload components such as turbines, expansion turbines, or turbochargers, causing more damage to the engine. In short, driving to 160 at a time will not have a great impact on the engine.

I just brought it out from the 4S store, and the new car ran 160 at high speed, does it have any impact?

It didn't make a difference, this car has undergone a violent driving test in the pre-factory test.

So it won't make a difference.

Good. When the vehicle exceeds the maximum set speed, it will be subjected to additional side loads, plus the additional energy consumption of the engine itself, so that the life of the engine will be reduced. At the same time, driving at such high speeds will also increase the temperature and friction inside the engine, which in turn will accelerate the aging of the engine.

In addition, overspeeding can overload components such as turbines, expansion turbines, or turbochargers, causing more damage to the engine. In short, driving to 160 at a time will not have a great impact on the engine.

I mean, I just bought the Nissan Sylphy. Just out of the S shop. Then I drove to 160, is there a problem?

Nothing is a problem.

But try not to do so!

Okay, because I heard from a friend that the run-in period of the new car has not passed, and I can't drive it too fast, so I asked.

The break-in period has been completed at the time of testing, and the rest is the run-in between you and the car!