What should I do if there is no sound on the computer stereo and the settings cannot be saved?

First, first confirm that the hardware is fine. If the speaker is fine, the sound card is fine, and if you've tested it on other machines and it's really good, then you can read on.

2. Make sure all the cables are exactly right. Then power on the speaker and turn on the volume switch.

3. Install the driver of the sound card correctly.

If you have an onboard sound card, it's a good idea to install the drivers provided on your motherboard's driver disk.

In fact, the computer does not make a sound, and many times it is because the sound card is not driven correctly. In general, after the sound card driver is installed, it is located in the taskbar in the lower right corner.

There will be a little horn in it.

icon. Fourth, if you are sure that the driver is installed correctly, then take a look at the volume settings in your computer.

The specific method is to double-click the speaker icon in the taskbar, and check whether the volume is turned off to the minimum in the "Volume Control" and "Waveform" dialog box in the pop-up "Volume Control" and "Waveform".

If these two options are not available in the dialog box, click on the "Options" menu - select "Properties" - select "Volume Control" and "Waveform" in the "Show Volume Controls" and then set them correctly.

Note: Step 4 can only be set up after the driver for the sound card has been installed correctly.

Reinstall the sound card driver and see if it works.

For the installation of the sound card driver: If you know your sound card model, you can search for the sound card driver corresponding to your sound card model on the Internet, **Install it. If you don't know, ** a Optimizer, then find your sound card model in Optimizer and search for it.

For the situation of sound card driver, I personally don't recommend you to use software such as Driver Life, Driver Genie, Universal Sound Card, etc.

Internet maniacs are enthusiastic about service, if it helps, please give points.

Summary. Hello Glad for your question, the specific operation method is as follows:

1、First of all, eliminate the hardware problem of the speaker itself (can be connected to other devices to confirm),It should be the problem of the equalization setting of the left and right channels,Take win7 as an example,The setting method is as follows。

3. Right-click on the speaker and click Properties.

4. Click the Level tab and click the balance button after ouput the output device.

5. Drag the left front and right front sliders to the same position, and click OK.

Why doesn't the computer's audio ring and how to set it?

Hello, I'm glad about your problem,The specific operation method is as follows:1、Shoulu Hao first excludes the hardware problem of the speaker itself (can be connected to other devices to confirm),It should be the left and right channel equalization setting problem,Take win7 as an example,The setting method is as follows。 2. Right-click the taskbar volume icon and tap Devices.

3. Right-click on the speaker and click Properties. 4. Click the level tab, click the balance button after ouput the output device. 5. Drag the left and right sliders to the same position, and click OK.

I'm buying a new stereo, why is there no sound.

According to the above tone attributes.