Is it necessary to do dynamic balancing after changing tires?

Updated on Car 2024-08-12
6 answers
  1. Anonymous users2024-02-16

    It is necessary to do dynamic balancing, and after replacing the tires, it does not match the original configuration.

    The wheels of a car are made up of tires and hubs. However, due to manufacturing reasons, it is impossible for the mass distribution of the parts of this whole to be very uniform. When the wheels of the car rotate at high speed, a dynamic imbalance will be formed, resulting in the phenomenon that the wheels of the vehicle shake and the steering wheel vibrates while driving.

    In order to avoid this phenomenon or to eliminate the phenomenon that has already occurred, it is necessary to make the wheel correct the balance of each edge part by increasing the counterweight in the dynamic situation. This process of correction is often referred to as dynamic equilibrium.

    There are two types of tire balancing: dynamic balancing and static balancing. Dynamic imbalance causes the wheels to sway, causing the tires to wear in waves. Static imbalance can cause bumps and runouts, often causing flat spots in the tires. Therefore, regular balance testing can not only prolong the life of tires, but also improve the stability of the car when driving, and avoid traffic accidents caused by tire swinging, jumping, and loss of control at high speeds.

  2. Anonymous users2024-02-15

    After the tire repair of the car, should I do dynamic balancing? Let's find out.

  3. Anonymous users2024-02-14

    This kind of problem has to ask the after-sales service of tires, my Giti tire after-sales service is quite good, as long as there is a problem for you to solve it immediately.

  4. Anonymous users2024-02-13

    If the direction does not deviate and the driving does not shake, there is no need to be a netizen of Yiche.

  5. Anonymous users2024-02-12

    Hello! The new tire must be dynamically balanced. Theoretically, you have to balance the tire when you remove it from the rim and put it back on, because you can't restore the position of the removed tire and the rim.

    In addition, it is recommended to do a wheel alignment check when replacing new tires.

  6. Anonymous users2024-02-11

    After changing the tires, you need to do dynamic balancing. If the car has an offset situation in the car, and the car steering wheel is not tilted, then there is no need to carry out four-wheel alignment, but must do dynamic balance. Due to the poor pants rental for production, the quality of the replaced tires is not completely uniform, when the car is driving fast, the wheels will be rotated rapidly and cause imbalance, which will interfere with safe driving and pose safety risks.

    Not only must dynamic balance be done after changing tires, but also dynamic balancing must be done after tire repair, valve replacement of different materials, wheel hub change or modification of tire pressure monitoring device control module. It can be said that as long as the tires are moved, the tires are separated from the rims, and then assembled again, all of them must be dynamically balanced.

    After changing the tire and running without dynamic balance for a year, although it is possible to flutter or deviate from the pure shed when driving in low gear, there is a considerable safety risk when driving fast; And the lack of dynamic balancing will also lead to abnormal damage to the tire, resulting in a reduction in the service life of the tire; It also increases the fuel consumption of the vehicle. Especially in the front tire, the vibration caused by the lack of dynamic balancing will be transmitted to the steering wheel of the car according to the steering system, which will not only affect the safety of safe driving, but also cause the steering system to loosen.

    Therefore, after changing the tires, it is necessary to do dynamic balancing to ensure safe driving, and if you do not do dynamic balancing immediately, you will increase the maintenance cost in the middle and later stages. According to the method of regular maintenance of tire pressure and timely four-wheel interchange, it can prevent abnormal tire damage and reduce the frequency of dynamic balancing; When driving, try to avoid potholes, if there is no way to bypass, the speed should be reduced according to the basis to prevent damage to the tire, which can also reduce the frequency of the tire to do the balance of the void.

    Millions of car purchase subsidies.

Related questions
13 answers2024-08-12

As soon as the hub and tires are assembled again, you have to do balancing. Therefore, it is necessary to do dynamic balance when repairing the tire. >>>More

13 answers2024-08-12

Not necessarily, it depends on whether there is professional equipment and professional technicians in the place where the tires are changed. It is easier to change tires, but dynamic balance and four-wheel alignment have a certain degree of technicality, and also require equipment, not all places where tires are changed can do dynamic balance and four-wheel alignment, but generally 4S shops or repair shops with a little scale can be. [Need to do dynamic balancing] When it is found that the steering wheel shakes or the wheels have some rhythmic abnormal sound when the vehicle is driving at high speed, it may be that the wheels should be dynamically balanced, especially when the tires are replaced, the wheel hub or the tire is repaired, the wheel is hit too much, and the balance weight is lost due to bumps. >>>More

9 answers2024-08-12

Hello, there is no need to replace the wheel hub, and there is no way to do it in the general repair shop, if it is to replace the tire, then it is needed, and it can be done on the tire dynamic balancing machine, the wheel hub is generally done during production, thank you.

32 answers2024-08-12

Generally speaking, it is best to do it for the front wheel, and the rear wheel basically does not matter. According to the regulations, it is necessary to do dynamic balancing after repairing the tire, but because the gap between the front and rear tires is not too large, there are many people who do not do it, and it also saves time and money. If you run at high speed for 100 yards, the car is shaking, it is necessary to do four-wheel dynamic balancing!

12 answers2024-08-12

Formaldehyde detection is actually a very mysterious thing, when I was decorating the company, the unit of formaldehyde testing is very familiar with our company, and there will be no problem. If there is, it can't be said to be due to decoration, such as sofas, wardrobes, beds, and even the structural glue on the edge of the window of the new house and the marble glue used for dry-hanging marble on the exterior wall may lead to excessive formaldehyde. Because newly bought furniture is more likely to exceed formaldehyde. >>>More