How to clean and maintain the crystal head, how to clean the crystal crystal cleaning method

The crystal head will oxidize, whether it is a miscellaneous brand or a big brand AMP, the oxidation of AMP is slow, and there will be oxidation problems after a long time, which can be observed and treated at an interval of one or two years.

The solution is that some people here say that the oxidized part of the oxidation is removed with a flathead screwdriver or tweezers, which is very simple and the dozer along the groove is very well completed, and you will see that the crystal head contact lights up a lot after the event, and it is considered successful. Among them, you can only remove the contact oxide layer of the four slots of 1236 (orange and white, orange, green and white, green), and only these four slots are used in the general production of network cables, unless it is another line sequence that you connect yourself.

The above methods will not cause any damage to the crystal head, on the contrary, after the above methods, the network speed will return to the fast era, the conductor contact surface is large, the contact is close and effective to run more, run fast, this is really important, to confirm and reiterate.

There are also people who say that you can change a crystal head, of course, you can change the new contact shiny, but if you bought enough before, if you don't keep it closed for a long time, it will oxidize, then you must deal with it. Therefore, the crystal head of poor quality can not be bought too much, oxidation is very fast, try to buy sample products, and for complete isolation of air airtight preservation, well.

The crystal head does not need to be cleaned, and it may cause a short circuit in the metal wire and a network failure after being wet. If you maintain it, you should be careful not to pull it out, the crystal tip contacts may oxidize after a long time, and you can remove the oxidized part with a carving knife and comparison. If possible, the faulty crystal head can also be replaced, and the cost is very low.

If the crystal head is always plugged and unplugged, you can add a sheath The most important thing is that when pressing the crystal head, the jacket of the network cable should be pressed so that the line inside can be protected If the crystal head fails, pinch it off directly and make another one.

1. Water purification cleaning method.

When cleaning the crystals, you can first soak them in pure water for 10 to 20 minutes, and then start cleaning. When cleaning, you need to use mineral water on the market, which contains more mineral elements, which is conducive to the maintenance of crystals. After cleaning, it needs to be wiped dry in time to prevent the crystal from being oxidized and discolored, resulting in a decrease in aesthetics.

2. Snow hiding method.

If there is snow around you, it will be very simple to clean, you can directly bury the crystal in the frost and snow, and let it stand for 2 or 3 hours, you can eliminate the magnetic field around the crystal, which has a very good purification effect. If there is no snow, you can make some ice cubes, then break the ice cubes, bury the crystals in the ice cubes, and put them in the cold room.

3. Coarse salt burial method.

Take an appropriate amount of coarse salt and bury the crystal jewelry directly in the coarse salt, which can play a role in purifying the crystal magnetic field. However, because salt has strong hygroscopicity, it can absorb a large amount of water in a short time, which can easily lead to oxidation of the metal on the metal jewelry, so it is best to remove the metal inlay and clean it.

It depends on how expensive the crystal is, the general crystal ornament ball (within 500) can be wiped with a wet towel, if it is more difficult to clean the dirt, add some dish soap, but if it is more valuable, it is estimated that there is more dust, it is recommended to wipe it with water, and the detergent will have a corrosive effect.

Crystals generally don't need to be cleaned in any way, as long as they are kept clean, and they are washed in clean water in the near future.

Crystal cleaning is very complicated, you must use clean water to clean, if the cleaning is not good, it will hurt the crystal.

If you clean the crystal, of course, you should establish a professional with that profession that specializes in cleaning and cleaning water, and it is better to witness it, so don't clean it yourself.

Place the crystal in a glass container, cover it with coarse salt (remember: sea salt, not refined salt, the former is the crystallization of nature, while the latter is a chemical synthesis), after 24 hours, rinse the crystal and leave it in the sun for three or four hours to bring it back to life. The principle of this cleaning is:

Salt itself has the function of absorbing impurities and removing impurities.

It is best to use a neutral dish soap or laundry detergent to clean the crystals, it is very clean.

If it is a real crystal, it is recommended that you wipe it with a wet paper towel and do not rinse it with water, or use other alcohol or other chemicals.

Then you, go get a professional electrical appliance to clean it, because this kind of thing is very precious.

Crystal words. You just need to scrub it clean with a rag and you're good to go.