I USED GHOUST TO BACK UP THE PREVIOUS C DRIVE TO D DRIVE, HOW TO OPEN THE BACKUP FILES

If it's a hard disk version of ghost, just restore it directly.

If it's a flower with the system disk into ghsto1,2,3 is a restoration,It's all in English,I don't understand,You just choose the first one, then the submenu, select the second, and the next submenu selects the third, and then there's a browse to find the ghost file you backed up.。

There's also what was said upstairs.

Do you want system recovery?

Start --- program --- installer tool ---ghost--- one-click recovery.

If you want to find any files, you can find them in the ghost directory.

How do you back it up? The process is almost the same, and you can restore it like that. Then you use the deep mountain red leaves to guide the start, and you can see your data. Otherwise, if you restore it and hang it up on another computer, you can also see it.

Can you enter the DOS environment?

Run in a command prompt environment.

Load your backed up files and you're good to go.

Good luck !

Use the ghostxp software to check the contents inside.,That can be opened casually.,Is it safe to back up like that?。

Replication is replicable. If you want to copy to a USB flash drive to install the system, you need to make the USB flash drive as a boot disk, set the BIOS to boot on the USB flash drive, or use the PE system in the system disc to select the system image in the USB flash drive.

Ghost is a powerful disk backup tool that can back up specified partitions or entire hard drives.

Here's how to back up your entire hard drive with ghost:

After running the ghost program, select the menu "local"->disk"->to image" on the main interface, press enter and select the hard disk to be backed up, the path and file name used to save the backup file, and then you can back up the entire hard disk as a gho file. The menu selection is shown in the following image:

Note: If you want to use the backup hard drive feature, you need at least two hard disks to implement the feature because the resulting backup file must be saved to a different hard drive.

You're doing the right thing, but you're making the mistake of common sense, backing up an entire hard drive means cloning data from one hard drive to another, not backing up the current entire hard drive to a specific partition of the drive. The reason is very simple, because you are backing up the entire hard disk, for example, you have F drive, but F drive is being backed up, so it is impossible to store the backup image, which is the same as the fact that you can not operate the data Ghost backup of C drive to C drive.