-
Generally, the original central control of domestic vehicles and the installation of a complete set of central locks are negative touches. Here's how to judge:
Negative trigger judgment: when one end of the pen is connected to negative electricity, and the other end is tested to test the signal of the switch lock, the door central lock will open and close the lock respectively, which is a negative trigger. Positive Trigger Judgment:
When one end of the pen is connected to positive electricity, and the signal of the switch lock is tested at the other end, the central lock of the door is opened and closed respectively, which is a positive trigger.
Positive and negative trigger: simple vehicles are equipped with the main control motor or the original owner's control end is a motor control vehicle, and the output signal of the immobilizer can be changed to positive and negative output through the relay group (if the original car is a single motor, the motor control line needs to be cut off and connected with a relay before it can be used). Tell me what kind of car you are, and I can tell you how to wiring the central control and anti-theft device!
-
After the warranty period is exceeded, the car repair shop or 4S shop can be installed.
-
I bought it in the repair shop and let them install it, and the universal one is the iron general, and it is generally used.
-
You can buy an immobilizer and install it.
-
Do you have the original car with a central lock to unlock the lock If you don't have it, the door is reserved for two holes with the central lock, which can just be on the central lock of the anti-theft device, and if you bring it, it depends on what kind of lock picker is common, there are two kinds of common ones with a motor and without a motor, it is best to use an immobilizer to control it directly, don't hang the lock machine again, both are easy to break, and if you don't have a motor, you have to find a place to open two holes below the original car lock machine, fix the lock machine of the anti-theft device, and then fold the steel wire with the anti-theft device into a suitable shape and hang it up.
-
Yes, if you want to drill a hole in the door to fix the motor, compare the position before drilling, don't turn it around and see that the position is wrong. I used bicycle spokes to connect the motor take-off lever to the door safety pin, and the section with the elbow was cut off and it worked very well.
-
The main control motor is five-wire. The main control motor is only a few dozen yuan, and it doesn't matter if you change it together, and you don't need to move the remaining three motors.
-
You can change it directly, you don't need to worry about the structure of the remote control, the original central control can still be used.
-
The central control is controlled by the computer, and the whole set of anti-theft can be replaced!
-
Hello, the general anti-theft belt central control with the same host, a vibration sensor, a prompt light, a horn, a relay, two remote controls, and three sets of combination cables. Hope it helps.
-
Hello, the general anti-theft device has a host, vibration sensor, LED indicator, antenna, connection harness these. There are also additions that you don't understand to help you answer, and the car master will walk with you all the way. I wish you all the best.
-
Hello! There are controllers, sensors, actuators, lines, horns.
-
The central control is mainly used to lock the doors. If the other doors are good, only one door is not good, it may be that there is a problem with the motor (also the lock block) or the circuit is broken and short-circuited, but now the central control of the vehicle is also controlled by the computer, so the internal electronic components of the central control computer may also be damaged.
-
1. Big red positive line, big black negative line, big white and white with black are the lines that control the central control, rhubarb and yellow with black orange and orange with black are the central control trigger line, pink is the anti-theft speaker line, blue door side switch trigger line, small orange is the brake light line, and small white is acc.
2. The small yellow is to control the relay, that is, the engine cannot be activated after the control of the fortification, the two brown are the left and right turn signals, and there are a few small red and black strips such as the tail box, the hood and the like are triggered, and the other vibrators and LED lights are plugged in.
-
If there is a computer chip, the car has to be wired out.
-
I guess it's a negative offense.