What to do if water enters the Volkswagen Tiguan transmission

Water ingress into the gearbox is a troublesome problem, the gearbox needs to be cleaned, and if the water ingress is long, it needs to be inspected and repaired.

After many riders' hands-on practice, simply changing the automatic transmission oil will not solve the problem, because the oil change cannot remove the stubborn dirt and impurities that have formed in the automatic transmission, nor can it repair the wear and tear of the components that have formed.

Marty's products are products that can solve the problem of gearboxes without dismantling and repairing.

With the addition of Marty ATF: 10 minutes to quickly clean the automatic transmission of stubborn impurities and dirt deposited without damaging any of the automatic transmission's seals;

Matti TA: Consolidate the cleaning effect of Matti ATF, completely dredge the blockage of the valve body, and solve the frustration, impact and slippage; Penetrate into the metal surface layer to form a new organometallic film layer, stabilize and repair the wear state of the transmission components, and the noise is greatly reduced or disappeared; The unique ingredient can effectively control the temperature, inhibit the re-formation of dirty impurities, and greatly delay the "aging" of the transmission oil, and extend the oil change interval by 3-5 times.

By changing the gearbox oil, it is possible to clean up the water in the gearbox.

It's time for an overhaul, drain the transmission oil and clean it.

It depends on the degree of water ingress If it can help you, please set it to, thank you!

Emptying the transmission oil for repairs.

Hello, Repair treatment is recommended.

Volkswagen Tiguan transmission leakage is easy to repair. When the Tiguan gearbox leaks, the first thing to determine is the specific oil leak and the severity of the oil leak. There are two scenarios:

1. Oil leakage from the oil pan of the gearbox, it may be a problem with the oil pan gasket or which oil pan screw is loose or poorly sealed, and the oil pan needs to be removed and re-glued. 2. The oil seal of the gearbox is leaking, and the oil seal needs to be replaced, which may involve lifting the gearbox. <

Volkswagen Tiguan transmission leakage is easy to repair. When the Tiguan gearbox leaks, you must first determine the specific oil leakage and the severity of the oil leakage. There are two limbs of the canonization of the beam species

1. Oil leakage from the oil pan of the gearbox, it may be a problem with the oil pan gasket or which oil pan screw is loose or poorly sealed, and the oil pan needs to be removed and re-glued.

2. The oil seal of the gearbox is leaking, and the oil seal needs to be replaced, which may involve transporting to the gearbox.

Volkswagen Tiguan transmission oil leakage is not difficult to repair, Tiguan transmission oil leakage, first of all, to judge the specific part of the oil leakage, as well as the severity of the oil leakage. First of all, the gearbox shell leaks, there are two kinds of difficult situations:

1. Oil leakage from the oil pan of the gearbox may be a problem with the oil pan gasket or which oil pan loose shell screw is loose or poorly sealed, and the oil pan needs to be removed and re-glued.

2. The oil seal of the gearbox is leaking, and the oil seal needs to be replaced, which may involve lifting the gearbox.

In the above two cases, if the hole is only slightly oily, that is, there are oil stains but not dripping, it is okay not to repair, because the amount of oil leakage is very small, as long as regular maintenance, there is no problem, but if it is within the warranty period, it is best to apply for a claim. The oil leak was serious and had to be repaired.

It is also possible that the half-shaft oil seal is leaking, and the half-shaft oil seal can be replaced. There is also a possibility that the gearbox oil radiator is leaking, the radiator or related pipelines are damaged, and you should go to a 4S shop or repair shop for a comprehensive overhaul.

SAIC Volkswagen Tiguan becomes cautious of oil leakage in the gearbox. Start by checking the place of the oil leak. If the oil seal or O-ring on the end cap is damaged, replace it.

If there is oil leakage at the box connection, it can be cleaned with gasoline. After the gasoline is air-dried, you can wet the oil leakage with sandpaper, mix it with AB glue, and paste it on the oil leak until the glue dries.

The all-new SAIC Volkswagen Tiguan is atmospheric and full of spirit. The cool polygonal shape of the front xenon headlights is eye-catching, and the crystal diamond LED daytime running lights exude a high-spirited look when lit. The all-new Tiguan adopts Volkswagen's most advanced 4motion intelligent full-time all-wheel drive system, which not only greatly improves the handling and passability of the all-new Tiguan car, but also only improves its comprehensive fuel consumption per 100 kilometers compared with the previous model under the same state.

At the same time, the addition of paddle shifters on all steering wheels allows the driver to easily switch between driving gears without having to lift the steering wheel. In terms of interior, the workmanship is solid, the material selection is high-end, the practicality is strong, the stable black and warm beige are mixed and matched, as the main color of the interior, the leather-wrapped steering wheel not only has an excellent feel, but also has a relatively complete function. Rear** armrests, sun visor with vanity mirror, glove box refrigeration and glasses case all appear "standard".

Millions of car purchase subsidies.

A few days ago, many netizens asked about "what to do if the Volkswagen Tiguan gearbox is damaged" and now I will explain it to you. Analysis of the causes of damage to the Volkswagen Tiguan gearbox, it is recommended that the owner go to the 4S store for detailed consultation. Replacing a new gearbox is costly.

3. Analysis of the wear and tear form of the main components of the transmission and its influence on the working performance of the assembly 1Transmission shell wear form: deformation - out of gear, impact noise increases, gear wear aggravation; Cracks – oil leaks; Bearing bore wear – increased impact noise and increased gear wear.

Causes of wear: working load and self-gravity (cantilever fixation) fretting wear of the front end face and shell deformation, bearing bearing hole wear; The front face of the shell is with.

1. The verticality error of the two-axis axis increases. 2.Shafts, bearings and gears, gear sleeves shafts

The fitting journal and the spline are partially worn. Bearing travel imitation bears load surface wear and fatigue peeling; The inner and outer parts of the bearing are dismantled and the fiber housing ring is worn on the matching surface; Bearing ablation. Gears, Racking:

Tooth flank wearing, ablation, tooth punching. Constant gear and tooth sleeve are generally not easy to be damaged; Sliding digging orange gears, tooth sleeves:

Millions of car purchase subsidies.

What should I do if the Volkswagen Tiguan brakes get into the water? Volkswagen Tiguan ( Price |What should I do if the brake is flooded? Volkswagen Tiguan brakes are flooded and go to the repair shop to clean them or dry them automatically.

The service brake silver is the brake, in the process of driving, the general use of the service brake (foot brake), convenient in the process of deceleration and parking; The parking brake is the braking used when the car is stationary, which is called the parking brake. Also known as handbrake. The main function is to prevent the car from slipping forward and backward.

The contents that need to be paid attention to when the car is used for parking brake are as follows: 1. When the parking brake is carried out, step down on the Jiuherun brake pedal, and pull out the parking brake lever upward. If you want to release the parking brake, step down on the Jiuherun brake pedal, pull the parking brake lever up slightly, press the button on the end of the handle with your thumb, and then lower the parking brake lever to the original position; 2. When parking on inclined ground, if you first shift to the P position, and then carry out the parking brake, the weight of the body will make it difficult for the driver to change out of the P position when preparing to start the car; 3. When preparing to start the car, the gear lever should be replaced from the P position before releasing the parking brake; 4. Do not tighten the parking brake when driving the car, otherwise the rear wheel brake effect will be reduced due to overheating, and the brake life will be shortened or the brake backup hall will be permanently damaged.

Summary. Hello, happy to answer your questions.

Hello, happy to answer your questions.

This car is a dual-clutch gearbox, and if the transmission fails, it may be that there is a problem with the Hunger clutch system. Or there is a problem with the electromechanical control slip unit on the limb key of the gearbox, which needs to be checked, and how to deal with the maintenance according to the results of this inspection.

The Volkswagen Tiguan is out of gear.

In this case, the main reason is that there is a problem in the electromechanical control unit above the gearbox, which leads to the need to use computer testing.

It is not good to change the valve body.

There are no fault codes.

Tell me where the gearbox computer is.

That's it. The computer of this gearbox is in this. The front windshield, this wiper sink is located underneath.

Motor. Position under the passenger instrument panel.

Severe water ingress: At least three items need to be replaced.

There are many parts that need to be replaced in the gearbox with serious water ingress, and there are six maintenance items listed below, of which the first three must be implemented: first, rubber components such as rubber rings and oil seals must be replaced; Second, the friction plate should be replaced, because the friction plate is composed of steel sheet and high-density wood grease material, which will affect the friction effect after swelling in water; Thirdly, it is also necessary to completely change the transmission oil; Fourth, the sprocket needs to be replaced when the water ingress is serious; Fifth, whether to replace the valve body of the gearbox depends on the situation, because if the gearbox is flooded, the lubrication effect will be weakened; Sixth, if components such as automatic multi-function switches wade in water, they must also be replaced.

Moderate water ingress: Friction plates, oil seals and other components must be replaced.

Moderate water ingress is much less than severe water ingress and requires replacement, but parts such as rubber rings, oil seals, friction plates, and transmission oil must be completely replaced. If components such as automatic transmissions, multi-function switches, etc., wade into water, they also need to be replaced.

Minor water ingress: It is best to change the transmission fluid.

Minor intrusion is similar to moderate intrusion, but is mainly preventive. It is best to replace parts such as rubber rings, oil seals, friction plates, etc., to prolong the service life, and it is recommended to change the transmission oil.

This has to be taken apart and cleaned, otherwise it will hurt the car very much, and it will have a great impact on the performance of the car.