It is said that the production of sunshine burns a little engine oil, how to solve the problem of bu

Hello, burning engine oil needs to be overhauled.

1. Gasoline should be soaked in gasoline to dissipate heat, in addition, the oil volume is too low, which may also affect the oxygen sensor of the exhaust system, these parts are not cheap, so do not exceed the bottom line before refueling.

2. Engine oil Generally speaking, the consumption of engine oil is not serious and is enough to survive the cycle between maintenance, but in summer due to the hot weather, the oil consumption will be a little higher than usual. If it is found that there are impurities or gasoline smell in the engine oil during the daily inspection, and the exhaust smoke is light blue, it means that there is a problem with the engine, and the parts may be abnormally worn, so you should enter the factory for maintenance as soon as possible.

3. Transmission oil.

When you change your engine oil, you can check your transmission oil by the way, and since the inspection process is more cumbersome, you can ask the dealer's service department to handle it. In order to measure accurately, the car must be discharged into neutral p, run at idle speed, and parked on a flat place, and the oil must run to an operating temperature of 80 93.

Too much or too little oil can damage the gearbox, and too much oil may cause excessive resistance to the operation of the parts, or cause the transmission oil to bubble and deteriorate, resulting in abnormal wear and tear of the parts. So when you check your transmission fluid, it's important to measure accurately.

Fourth, the power direction oil.

When the engine cools down, wipe the top of the oil filler cap and the oil reservoir clean, then unscrew out the direction oil cap, and wipe the dipstick clean with a fiber-free clean paper towel, and then install the lock, and then open and pull out the oil level to check the dipstick.

To fill or change the oil, it is necessary to use the correct power steering oil, if it is not used properly, it will cause damage to the steering machine.

5. Brake fluid.

Just open the hood and look at the level of the brake oil can, as long as it is not lower than the lower limit.

When the level of brake fluid is not checked, brake fluid should not be added, so as not to add too much, and the brake oil will be sprayed to the high-temperature engine, resulting in corrosion and even combustion. If there are bubbles in the brake oil, or the oil becomes dirty, it means that the brake fluid has deteriorated, please replace it as soon as possible, so as not to reduce the boiling point of the brake fluid and produce bubbles, resulting in poor braking effect, which is very prone to danger.

The solution of burning engine oil in the car: 1. The oil is burned in the cold car but normal after the hot car, the occurrence of this phenomenon is caused by the aging of the valve oil seal, the solution: remove the engine cylinder head and replace the valve oil seal; 2. After the car reaches the normal temperature, the exhaust pipe still emits blue smoke, which indicates that the piston ring has a poor seal.

Hello, which Nissan car are you? If there is a burning of engine oil, you can choose to change it to a different brand of engine oil. If it is still burned more severely, then it can only be repaired, if it is not too serious, then you can choose.

It is to have some engine oil in the car in case you need it.

There are several ways to solve the problem of engine oil burning. 1: If the viscosity of the engine oil is too low and the engine oil is burned, you can replace it with the engine oil with the appropriate viscosity.

2: If the supercharger oil seal is damaged and the engine oil is burned, the supercharger oil seal or supercharger can be replaced. Three:

If the valve guide or oil seal is damaged and the engine oil is burned, it is enough to replace the valve guide or oil seal. Four: the piston ring is counterparted, adhesion, and the piston ring can be cleaned and reassembled by the piston ring caused by the wrong assembly.

Five: piston ring, piston cylinder liner is seriously worn or damaged, and the piston ring piston cylinder liner can be replaced due to oil burning.

How to solve Nissan's car oil burning. This matter needs to be handed over to a professional repair shop or after-sales service. If you want to test for a person, every step is more difficult.

And. Hehe. It needs to be disassembled and assembled.

Generally speaking, sometimes the quality of the oil added is not good, the throttle is clogged or. The quality of the spark plug is not good, the carbon deposition is serious, or the oil label does not match, and then it is likely that it is due to long-term non-maintenance, resulting in the phenomenon of pulling the cylinder.

Nissan cars generally do not burn engine oil under ordinary circumstances. Hey, but the quality is very good. If that's the case, go straight to him.

Find something, S shop well find the receipt, Shang An can go, let him solve it, and even go to the departure. Just change to another one.

Nissan burns engine oil, to solve this problem:

1.Go to a repair shop or 4S shop to pick up the engine for repair.

2.Try using a higher grade oil to slow down or stop the burning of oil.

3.Use a better fuel treasure to clean up the carbon deposits in the engine and oil circuit.

First of all, it doesn't matter whether it's Honda or Toyota or Volvo, you can usually burn the engine oil by checking the oil pipeline next to the engine and changing the oil.

If you used to use 5w30 engine oil, you can change it to a thicker oil to see, but you can only go to the 4S store if you can't solve it.

Nissan doesn't burn much. However, my antenna is famous for burning engine oil, but it was more than 10 years ago.

You don't have to solve anything, check it every 2-3 weeks, and add it again.

Therefore, the quality of maintenance directly affects the performance of the car and its service life. Magic pressure engine protector, solve the problem of burning engine oil and cold start, fully protect the engine, and care for the heart of the car! BOD Magic Press Reminder:

Causes of engine oil burning in vehicles.

The engine oil itself has a certain amount of consumption, and excessive consumption is the problem of burning engine oil. There are many factors that affect the burning of engine oil, such as: fuel quality, driving conditions, driving habits, maintenance habits, etc., the following reasons will aggravate the oil consumption and cause the burning of engine oil, so that the vehicle appears:

1. Carbon deposition occurs in the combustion chamber, which makes the gas ring of the piston ring stuck, and the sealing is poor.

2. Oil sludge is generated in the lubrication system, and the oil sludge blocks the oil return hole of the oil ring and weakens the oil scraping performance.

3. Wear occurs between the piston and the cylinder wall.

4. The valve seal is corroded and aging, and the sealing performance fails.

In addition, cars now have crankcase ventilation systems (exhaust valves), which can also exacerbate oil consumption if there is a problem.

Precautionary measures for burning engine oil:

1. Use high-quality engine oil

Engine oil is very easy to corrode and age in a long-term high temperature state, resulting in the oil film becoming thinner, and it is easier to escape to the combustion chamber to participate in combustion, so the use of high-quality engine oil can greatly delay this phenomenon.

2. Pay attention to the cleanliness of the fuel circuit

Fuel in the combustion process is indispensable to produce carbon deposits, and carbon deposits are the root cause of some car failures, such as the aging of valve seals, piston wall clearance, etc., all have a direct or indirect relationship with the formation of carbon deposits, considering the relationship between domestic oil products, it is necessary to use high-quality engine oil and (PNF) fuel additives to achieve, which is also the key to achieve no dismantling and repair to solve the problem of burning engine oil.

Summary. Hello, Dongfeng Nissan Sunshine, ran 80,000 kilometers, a little burned oil, it is recommended that you use the oil viscosity is a little sticky, so that it is easy to burn a little, you can recommend the use of model 10w40 model oil. The engine oil is relatively thick, and it is a little more resistant to burning.

Hello, I have seen your inquiry, please wait for a moment and answer it for you immediately.

Hello withered Yu, Dongfeng Nissan Sunshine, ran 80,000 kilometers, a little burned shed rock oil, and La recommends that you use the oil viscosity is slightly sticky, so that it is easy to burn a little, you can recommend the use of model 10w40 model oil. The engine oil is relatively thick, and it is a little more resistant to burning.

I used to use 5w3o, but now I use 10w40.

Hello, yes, now change the oil of the 10w bar 40 and use it. This kind of oil is a little more resistant than your 5w three-zero oil.

If your engine oil consumption is relatively large, there are mainly the following possibilities: condensation of pressure oil vapor in the crankcase ventilation system, such as crankcase ventilation pipe blockage, etc. The engine valve oil seal is aging and causes the engine oil to burn.

The piston ring is worn or the mouth is burning. Therefore, it is recommended that you go for maintenance as soon as possible to avoid hidden dangers in the future. If it is a cool car that emits blue smoke when it lands, first deal with the crankcase ventilation valve and valve oil seal and valve guide, and try it.

In the early stage, you can use some auxiliary products to maintain the car engine and reduce the phenomenon of burning engine oil, the vehicle has a long service life, once it is found that the exhaust emissions appear blue gas, which means that the burning of engine oil is already very serious, and you must go to the 4S shop to replace it.

No matter what kind of car, the root of burning engine oil is that the domestic fuel quality and oil quality are too poor. The fuel is poor, everyone should still have a number in mind, but the oil is poor, a little bit I don't understand. In Europe, there must be 22% additives in engine oil, and the content of additives is as follows

Typical multigrade motor oils – 78% base oil, 10% viscosity improver, 3% detergent, 5% dispersant, 1% wear protection, 3% other components; The content of domestic oil additives does not exceed 15% at most, or even less. The poor quality of the engine oil not only does not clean away the dust inhaled into the air during the operation of the engine and the carbon deposits formed after combustion, but also the combination of gum and other impurities formed by self-oxidation will lead to the formation of more carbon deposits. These carbon deposits are deposited in the piston, which affects the outward elastic tension of the piston ring, causing the cylinder pressure to deteriorate. If it is deposited in the engine, it will cause poor lubrication, increased wear, increased fuel consumption, decreased power, and cause oil burning.

The engine oil is burned, and it must be solved as soon as possible. At present, there are two more popular ways to find land for overhaul, the quality of accessories, the level of technicians can be guaranteed, and the cost can be afforded, you can try, but after the overhaul, it will inevitably cause damage to the engine, which is common sense, the car is not broken, it is repaired!

The second is not to overhaul the solution, because the root cause of burning engine oil lies in the poor quality of oil and oil, resulting in excessive carbon deposits, which causes a series of problems such as piston ring stuck, cylinder wall wear, oil seal aging, etc., so as to burn engine oil, through high-quality cleaning and repair technology, such as the more popular German Marty, can solve these problems, do not overhaul can also solve the problem of burning engine oil, and solve the quality of gasoline and engine oil from the root, to ensure that there will be no more **.

If it's not too severe, try adding some repair anti-wear agents. It's really not done, so I can only overhaul and change four matches.

Honda concept S1 costs oil, mileage 130,000 points, oil changed, ran more than 3,000 kilometers, the oil stick can not keep up with the oil, the cold car in the morning does not emit blue smoke, the display lights on the dashboard are normal, what is the reason for this, thank you.

Do not change the oil with a higher viscosity after the car burns the oil, as it will cause problems with the crankshaft of the engine. Timing issues. Burning engine oil with higher viscosity oil is destroying the car.

Qashqai, when burning engine oil for inspection, must see whether the cylinder wall is worn, whether it is serious worn, and slight and moderate wear is fine. In addition, 100,000 kilometers to check whether the exhaust valve is aging, this accessory will also lead to a certain loss of oil. There is no need for an overhaul of the engine without significant wear and tear on the cylinder walls.

If there is no problem with these, it is piston ring jamming, 100% piston ring jamming, and the above inspections are to be 100% sure of the piston ring problem. The piston ring of this car is bound by high temperature, but it is necessary to rule out possible accessory problems. The problem with the piston rings is easy to solve.

Causes of piston ring seizure.

In fact, the treatment principle of piston ring stagnation should start from the oil circuit, the reason for the stagnation is the beginning of the oil circuit, the oil bearing temperature is 110 degrees, and the high temperature caused by the long-term unclean oil circuit makes the oil at a temperature of 120 degrees or higher for a long time, so that the oil will be exhausted in advance, the small hole of the oil ring is very small, and the oil inside will be dried and scabbed for a long time, and a cylinder stuck is 5000 kilometers of a liter of oil, at this time, the working conditions of other cylinders will also begin to be bad, and soon the 4 cylinders will be stuck. It becomes a liter of engine oil for 1000 kilometers or even hundreds of kilometers. Therefore, in order to solve the problem, we must start from the root oil circuit, which is the way to remove the root.

It is recommended to use the additives that can release the piston ring once at 5000 kilometers, which can prevent the piston ring from being stuck well, and can also clean the oil circuit, which will not lead to the long-term high temperature of the oil circuit affecting the working condition of the engine, and 20w kilometers will no longer cause the problem of burning engine oil because of the piston ring stuck and sluggish.

The solution to solve the problem of burning engine oil in Nissan car link.

The engine oil bai itself has a certain amount of consumption, and excessive consumption is the question of burning engine oil

Title. The oil in the burn-in machine is caused by the following factors as long as it is solved.