Regarding the use of XP s built in check hard drive tool, it often gets stuck in one place

If there is a bad path, it should be like this, you can use a low grid, but it is recommended that you do not do it if it is not necessary, and there are other ways to avoid such practices.

If there is a bad sector, I suggest changing the hard disk, because, even if it is repaired, once there is a problem, the data cannot be found, there is no problem with money, it is better to change it, and the picture is at ease.

And don't shut down abnormally, especially if the power is suddenly cut off, which will hurt the hard disk very much. Do not move the computer or collide with the computer while it is running, causing large vibrations.

In addition, it should be said that the software of the optimization master is still used sparingly, which is easy to cause system instability and even failure, and is incompatible with other software, so it is okay to use it occasionally. There's also magic bunnies and the like. It should also be of great use.

Highly recommended: Windows Optimizer.

Because it's a stealing connection, it's valid for 24 hours, and you speed up.

What's the problem, I guess it's that your hard drive has too much junk and too many fragments, you can defragment the entire disk overnight!

Isn't it that you want to declutter disk in DOS。。 Can you? Pure DOS is not possible! There are a lot of software, but I tested it, and none of them were ideal, so go and check out the forum I connected to for you!

System files are missing.

Bad sectors on the hard disk, causing system file reading failures.

MS (Microsoft) XP comes with something that doesn't.

There's software that can fix bad roads, but within a few days, it's still coming up.

I support you to repair or buy a new one (80g 250 280 can be bought. 160 plus 30 50 yuan can be bought).

Physical bad sectors have nothing to do with software

Click - My Computer to open, such as the drive letter icon dot properties, click the tool to start checking, and click the full tick to start on the line.

Right-click on the hard disk you need to check, select Properties - Tools - First Option - Troubleshooting, and click to start troubleshooting.

There is a problem with the hard drive, format the hard drive, see if it works.

Change the system, I have the latest XP system here, you can try.

Clone System CD comes with ·· mhdd·· After running an interface, find a row with the hard disk model Enter the first serial number (number) to the bottom where you want to enter·· Another interface·Press F4 to get out of a small box·· Press F4 twice more to start scanning the hard drive·· If you want to fix the last 3 items in the small box, you can press f4 again·· (You can only fix the general ring too much or too serious, there is no way·· ）

diskgen is the Chinese version,You can use the mouse to operate,Detect whether the hard disk has bad sectors,You can also scan the surface of the hard disk,Clear the logical bad sectors of the hard disk。

Clean up and mark bad sectors with hard management software. After the reboot, the system no longer has to repeatedly seek, which speeds up the boot time. If it still doesn't start properly, you can reinstall the system.

I haven't used XP for a long time.,Remember that you can press ESC to cancel after booting up.,Enter the system.。

How about starting out without the last time you configure the correct way to boot the computer?

Press F8 to enter safe mode, or go into the BIOS to restore the default settings.

Your computer is a little stupid, so you can only go to the computer shop to have a look and reinstall the system.

If you don't reload this problem, you can't do it, and you can't cure it without heavy medicine.

Are you using Ghost XP press mounting? If yes, it may be that the primary partition is not activated when you install the XP system, use the partition tool to convert your primary partition, generally the default primary partition of the GHOSTXP system has been activated.