What to do if the car is turned off while driving? How do you turn off the car?

If you slam on the brakes while driving a car, it is easy to put out the fire of the car, and for novices, if you don't know how to drive a car, then it is difficult for you to set it on fire. It's not like everyone thinks to twist the key directly, step on the accelerator, and he leaves, that's actually not right, that can't actually go. <>

Because you are still hanging the gear when you turn off the engine during the drive, if you hang the second gear, the car is not up with the original, it is easy to cause the flame to turn off again, first of all, you should turn off the key, and then take off the gear, of course, if you are an automatic transmission, you don't need it, here is the general manual.

When you're done taking off the gear, you can unscrew the key, then turn on the fire and step on the clutch gear, gas pedal and leave. Of course, this start is a start in first gear, and then after the start of the step, you can accelerate to hang the second gear, and then you can accelerate to hang the third gear, the fourth gear, this is personal, everyone likes to hang which. But the start is generally in first gear.

Turning off the engine during car driving is a relatively normal thing for novices, at this time, you should first calm yourself down and don't panic, because once you panic, you can't carry out normal operations, which is similar to our psychology when we take the driving test, and we are more nervous, so we must be calm. <>

In the process of driving some situations, often novices will suddenly step on the brakes, resulting in many cases the car will stall, this is still a novice with a very poor awareness, almost generally to step on the clutch, and then brake, the car is not easy to turn off. If the engine is turned off, it is important to remember to pull the handbrake up first, as this is a measure to prevent the occurrence of automatic reverse and collision.

When the handbrake is pulled, the next thing to do is to remove the gear, then close the key to the end, and then turn on the fire again, and then drive in normal operation, and it's OK.

These are for manual transmission cars, for automatic transmission cars have a certain difference, that is, there is no need to remove the gear, you can continue to drive after re-ignition.

1. Press the clutch pedal and brake pedal at the same time until the vehicle stops.

2. Hang the gear to neutral.

3. Press the key to start and turn off the vehicle.

4. Pull up the parking brake.

5. Release all pedals and complete the shutdown of the vehicle at this time.

Precautions for operation:

1. Do not directly press the brake pedal, otherwise the vehicle will be forced to shut down the engine due to the traction of the gear, which will damage the engine.

2. Be sure to pull up the hand brake to avoid slipping.

The car stalls normally: step on the clutch and brake and wait for the car to stop, extinguish the fire, hang up to first gear, and release the brake. It is taboo to hang in neutral after parking.

According to the theory, you should apply the brakes first, wait for the speed to slow down, gradually downshift, and press the clutch until it stops when it is about to stop. After stopping, put neutral, lift the clutch, and only apply the brakes.

In actual operation, it is more used, first step on the brakes, wait for the speed of the vehicle to slow down (this should be based on experience to choose when to hang the neutral gear, generally hang on the gear and step on the brakes, when the speed is lowered, the car will be clucking, before this can be changed to neutral), step on the clutch to hang neutral gear, and continue to step on the brakes until it stops.

It is not allowed to step on the brakes and turn off the ignition, which has a lot of wear and tear on the car and is not conducive to vehicle maintenance.

Reasons for the sudden stalling of the car while driving:

1. Circuit fault;

2. Flameout caused by short circuit of low-voltage line: intermittent flameout; 3. Device failure: it can start at first, turn off after a while, and then start again, and then turn off again;

4. Oil circuit failure; The gasoline pump was damaged, the oil line was ruptured, the carburetor inlet was clogged, and the fuel tank ran out of oil.

5. There is a problem with the ignition system and the explosion-proof system for engine overheating.

When it is found that after the ignition is turned off, according to the road conditions at the time, if there is no emergency, you can slowly step on the brakes to prevent the tail light, after the speed is reduced, slowly play the direction, drive to the roadside lane, pay attention, the brake should be stepped on all the time, the power from small to large, do not step on it and then loosen, and then go to the pedal, which will lead to the only remaining vacuum is also consumed, and then step on it can not be stepped on, park the car on the side of the road, turn on the four flashing lights, place the tripod, and hit the ** rescue trailer.

I'll show you how to turn off the fire! When the car is moving, you are ready to stop and turn off, the first thing is to step on the clutch and then immediately hang it in neutral and step on the brakes, don't always have a clutch to step on, so that you are not tired! The clutch plays a role in separation, so when the gear is changed, there is no need to always step on it, when the car stops steadily, pull the handbrake and then turn off, and finally it is best to hang a gear, it is best to hang a gear when it is flat and uphill, if it is on a downhill road, it is best to hang a reverse gear, because this is to prevent the car from the handbrake can not be pulled, but the method I said is for manual transmission, and finally I will give you a trick!

If the car has a problem and can not turn off, you don't panic, in fact, this problem is very simple, first you drive slowly, when you drive to an absolutely complete place, and then you hang to neutral and slowly step on the brakes, when the car stops steadily, you step on the brakes and do not let go, and then step on the clutch to hang a gear, and finally the brake does not put all the time to step on, slowly release the clutch so that you can turn off, this method is very safe, if your car is an automatic transmission, when you park directly on the brakes, and then when the car stops, Put the gear to the p position on it.,Finally, pull the handbrake.,I said the method I hope you remember to make up.,When you have time, you can follow the method I said you can try.,I hope you can adopt the advice I gave! Open it well! At least be worthy of all the tricks I'm telling you here!!

Turn right steering, close the throttle, light brake fast critical semi-linkage fast step on the clutch and take off the gear, confirm the safety to the right, slowly step on the brake, close to the destination to stop, turn off the ignition, pull the handbrake, and hang up the second gear. If the slope is steep, place bricks or obstacles under the wheels (at the low wheels). After driving at high speeds, you need to idle for one or two minutes before turning off the engine.

In addition, the traffic law stipulates that parking is not allowed at the location of the intersection, the entrance of the fire brigade, tunnels, bridges, highways, and sections of the road with no parking signs.

Reasons for stalling: oil circuit blockage, spark plug ignition abnormality, throttle blockage, automatic transmission models will not easily stall, while manual transmission models may often stall due to low driving level. However, it is not excluded that the automatic transmission car will not stall, the main reason is the use of inferior fuel (many gas stations sell impure oil in order to obtain huge profits) resulting in the engine carbon deposition and stalling, in addition, for the new car (automatic transmission) The reason for the stalling is mainly caused by the lack of driving skills, and the other possibility is the problem of the car engine or oil circuit, but for the new car, the problem of the engine itself is less likely, most of the reason is the problem of the oil circuit. Finally, for old models, the reason for stalling is not only the lack of driving skills, but also the stalling caused by the use of substandard oil to collect carbon in the engine.

Flame-out various:

Individuals usually manually, pull the handbrake in neutral, and turn off the key when it returns

Automatically pull the handbrake in P gear, and turn off the key when it returns to the position

Turn off the key and turn off the ignition normally, and press it again if you want to start it with one button.

A single step on the stall will cause an impact on the gear gears, affecting the service life of the transmission and clutch.

After stepping on the clutch and braking to stop, do you turn off the ignition by picking it up to neutral and then twisting the key?

1. First of all, it is necessary to determine the reason for turning off the ignition. If the car with automatic transmission has a premature flame, it is generally caused by the use of low-quality fuel, in this case, the general operation is as follows: the left hand grasps the steering wheel to stabilize the direction, the right foot firmly presses the brake to reduce the speed as much as possible, and then quickly hits the AT gear to N gear (Note:

Re-ignition must be in N gear during the journey, not D r P and other gears, otherwise, the car either cannot ignite, or the car gearbox will be damaged), and then the key is set back one notch, and then re-ignition, and then the AT gear is restored to D gear normal driving.

2. Secondly, if the car with manual transmission has stalled, under the premise of quickly improving their driving skills, they must first judge whether the oil circuit is smooth, often due to this simple reason, the result is a waste of time. Completely dredge the oil circuit, including the fuel injection cavity slip adjustment, throttle and fuel tank, etc., it may be that the quality of the engine oil you add is not passed, and the oil channel is blocked due to too much grease. At the same time, the possible cause of stalling is too much dirt in the valves.

When the engine is running, there is a lot of dust accumulated at the valve core and throttle seat of the electric machine, and when too much dust accumulates, the engine will have too low idle speed and poor idle stability, and finally cause the dust to stop at idle. At this time, you only need to swing the idle motor. At the same time, the use of high-quality and decent fuel that meets the standards is also the key to solving the problem of car stalling and avoiding excessive carbon deposition in the cylinder.

<> "When we travel by car, we often encounter a variety of situations, traffic jams, vehicles run out of gas, stalled, broken down, etc., if it is just a simple traffic jam and no fuel, it is okay, if the vehicle is turned off, it is often called every day should not be called the ground is not working, if it happens to be on the highway, it is even more difficult to do.

In fact, many times when encountering a vehicle accident, there is no need to panic too much, it is necessary to understand the possible causes of the vehicle accident in advance and then take the right way to deal with it.

There are many parts in a car, and once one of them strikes, it can lead to an overall strike. When the car suddenly stalls halfway, it is most likely caused by incorrect data from the throttle position sensor. The throttle position sensor is a part of the car that is easy to wear, and its function is to detect the working condition and load of the engine.

In addition, many parts of the car are rubber products, and rubber products are easy to age and break, and they are easy to stall once there is a problem. For example, if the timing belt is broken and it may cause the car to stall for too long, it will cause the car to suddenly stall, so we must replace the timing belt every 80,000 kilometers to avoid the sudden breakage of the timing belt and cause the car to stall halfway.

We often find that when the climate is different, the probability of vehicle failure is also different. There are also such temperature measurement components in automobiles, such as car water temperature sensors. Its function is to detect the engine water temperature, and if the water temperature sensor temperature is abnormal, it may cause the vehicle to stall.

It is worth noting that the vehicle should be turned off and parked, sell the limbs and then call for rescue, and send the vehicle to the nearest repair shop, do not rush to repair it yourself, so as to avoid accidents.

The correct way to deal with the car turned off: 1. Immediately pull up the handbrake and then return to neutral. 2. Twist the key to the closed position, step on the clutch pedal with your left foot, and put your right foot on the brake pedal.

3. The key is twisted to the open position, the right foot is pressed on the brake, the handbrake is released, and then the clutch is released, and the vehicle can start.

Flameout means that the flame in the engine of the vehicle is extinguished, which may be the flameout of the electrical circuit, or it may be the flameout caused by the failure of the oil circuit. When the vehicle is driving, the engine suddenly stops, if you can use the inertia of the vehicle to start the vehicle, you can still drive normally, this kind of stalling is an accidental phenomenon. If it doesn't start, it's probably because one of the parts of the vehicle is malfunctioning.

How to restart the manual transmission after the vehicle is turned off, you must immediately pull the handbrake and then return to neutral. Twist the key to the closed position, press the clutch pedal with your left foot, and put your right foot on the brake pedal, don't press it yet. The key is twisted to the open position, the right foot is pressed on the brake, the handbrake is released, and then the clutch is released, and the vehicle is ready to start.

After the automatic transmission is turned off, restarting it does not need to be so troublesome. First shift the gear lever to neutral, that is, N gear, and then twist the ignition switch to the starting position, if the car starts successfully, the gear lever will immediately shift to D gear, so that you can start normally.

Automatic vehicles are not so prone to stalling, and if they do, it is likely to be caused by the owner using poor quality fuel. It is recommended that the owner go to a regular gas station to refuel, although it will be a little more expensive, but it can better protect their vehicles. Most of the reasons why vehicles with manual transmissions stall are because the driving skills are not that good.

For novice drivers, turning off the engine is already commonplace, and the most important thing is to improve their driving skills as soon as possible.

Photo by Pacific Automobile Network Q&A).