The temperature of the graphics card is always very high, how to raise the bottom point.

1. **: Replace the graphics card fan and heat sink, and spend another dollar to buy a thermally conductive silicone, the gray kind! The problem should be solved!

2. Economy: Remove the heat sink, buy a silicone, don't apply too thick, just be even, and reinstall it.

If you overclock, reduce the PCI (AGP) frequency.

The problem should be solved, I hope it helps you.

The standby temperature is almost normal, it is recommended that the fan speed is set to automatic, to no longer add a PCI fan, or to improve the case cooling environment, I used to use a small chassis to cultivate 7300GT often to 89 degrees, and then changed to a large chassis at most 52 degrees, 24 hours of gaming is also like this, very good, I hope LZ will improve quickly, the temperature of boiled eggs above 80 degrees for a long time, the life of the component is greatly shortened.

The temperature of the graphics card is normal, the general temperature is 40-60 degrees, and the full load is 75

If you want to cool down, you can use SpeendFun to change the fan speed, or set the graphics card voltage in the BIOS to lower it a bit.

Add a fan, you can, more than 200 good.

Add a case fan to pump out the hot air, turn the fan speed higher, and paste a heatsink to the video memory If it really doesn't work, change to a large heatsink.

Buy a socket with a voltage regulator!!

60 is considered high, but what temperature is low?

Reasons why the graphics card is too hot.

1. There is too much dust inside the computer, and the heat dissipation is not good.

2. Poor contact between the graphics card chip and the heat sink.

3. The thermal grease on the graphics card chip is missing or dry, and the thermal conductivity is lost.

4. The speed of the cooling fan of the graphics card is not enough, and the power is insufficient.

Resolution. 1. Observe whether the graphics card cooling fan is running normally, add some lubricating oil to the graphics card cooling fan (sewing engine oil is OK), if the fan is not damaged, you need to buy a new cooling fan, if you are not a professional, please remove the graphics card, and take it directly to the IT store to ask someone to replace the fan.

2. If the contact between the graphics card chip and the heat sink is poor, you need to apply thermally conductive silicone between the fan and the graphics card core.

3. Pay attention to cleaning the dust in the chassis, and the dust on the graphics card should be cleaned even more. You can take a high-powered hair dryer and blow vigorously on the inside of the case for a while, or disassemble each accessory to clean up the dust separately.

4. Install a convection cooling fan on the chassis to reduce the temperature inside the host, so that the heat emitted by the graphics card can be quickly taken away5. Use software to reduce the frequency of the graphics card, of course, this is at the expense of the performance of the graphics card.

6. Radiator, radiator. Dedicated to notebooks.

In addition, the temperature of the desktop high-end graphics card is considered normal within 90°, and the temperature of the laptop graphics card is considered normal within 80°. However, the mainstream entry-level graphics card has to control the cost, so the general full-load temperature is within 70 degrees.

Installing a fan in the upper part of the chassis to blow the wind outward, and installing a fan in the lower part of the chassis to blow the wind inward, the effect is better than opening the case, because the convection layout of the two fans up and down is the best heat dissipation effect.

The main reason is that the quality and performance of the cooling fan of the CPU and graphics card lead to the sound and temperature being too high.

Because the perfect fit between the graphics card fan and the graphics card chip cannot be guaranteed, silicone is required. You can buy some silicone for the radiator, or the silicone grease of the CPU fan (gray is better than white), apply it between the fan and the core, and don't wipe it off at will.

There are also graphics card fans that sell, according to your graphics card and the fan on it, if it can't be solved after the smearing regulations, you need to buy a graphics card fan to replace it, one is only a few dozen dollars, and the high temperature may cause irreparable damage to the graphics card, it is recommended to change the fan.

In addition, pay attention to the heat dissipation of the case, buy a case fan, a good CPU fan can reduce the temperature of the case as a whole.

If you are a notebook, you should raise the notebook higher, or add a heat sink.

The chassis is fully opened, and the side of the fan is blowing towards the chassis, and the direct drop effect is obvious... The constant temperature of the graphics card is reduced from 75° to 68°, and the ZOTAC 9800GTX+. Other hardware temperatures are currently a:

CPU 28° (Will the temperature be too low to work properly - 34° for motherboard, 36° for hard disk.

Before I use a fan, it is all 50 degrees up and down.

Big brother, your CPU fan is too dirty, clean it up, and the silicone is being installed.

Expert advice:

Clean the dust near the graphics card, apply silicone grease, and then uninstall the graphics card driver, and install the new version of the graphics card driver to solve the problem.

It is recommended that you remove the dust from the computer first, as too much dust will seriously affect the heat dissipation; Secondly, it is recommended that you reapply the thermal grease between the chip and the heat sink, if the silicone grease is dry, it will also affect the heat conduction; If it doesn't work, you can only change the fan.

Hope it helps.

The temperature of the graphics card is a bit high, and everything else is normal, looking at the temperature of your motherboard proves that the circulation system in your case is still good, if it is a desktop, take your graphics card to match a heat pipe graphics card heatsink, and it will cost about 50 yuan, which is guaranteed to give you a drop below 70 degrees. If it's a notebook, it's more troublesome, it's best to go to the maintenance department and ask them to clean up the fan for you and then reapply the thermal paste, which is not expensive.

Older graphics cards, some graphics cards work at a normal temperature of about 70 degrees, and cooling down your graphics card can't improve performance.

6600.。。The graphics cards of that era were at this temperature.

Does your graphics card have a fan? Cleaned up.

Rapid cooling requires an electric fan, open the case cover and blow it directly, the temperature is immediate, but not a long-term solution.

If you want to do it once and for all, it's best not to believe in the so-called cooling software, which is nothing more than frequency reduction, but frequency reduction means that playing games will be stuck, this is a hard injury, and it needs to be solved by hardware, at most install a temperature and fan speed monitoring software like game plus.

For laptops, the only way to do this is to add a cooling pad, or disassemble and replace the silicone grease, clean up the dust, and replace the fan with a higher speed.

Generally, when not playing games, it is normal for the CPU to be below 40 degrees, the graphics card to be below 40 degrees, the hard disk to be around 30 degrees, and the motherboard to be around 30 degrees, and the fan speed varies from individual to individual. If it is a large 3D game, the CPU and graphics card can reach 70 degrees or even higher, the hard disk is around 50 degrees, if the hard disk exceeds 70 degrees, there will be a risk of data loss and hard disk damage.

To play games, you can use the following methods when the temperature of your graphics card is too high:

Reduce the quality of the game and reduce the pressure on the CPU and graphics card.

External cooling fan to reduce the temperature by enhancing heat dissipation.

Upgrade your graphics card to improve your graphics card performance and reduce the pressure on your graphics card.

Seventy or eighty degrees is acceptable for a large-scale 3D game. You can remove the graphics card heatsink, clean up the dust, lubricate the fan bearings, and reapply the silicone grease to fasten the cooler. If it still can't be solved, just replace the radiator.

Exhaust radiator, ** is sold, I think Xu's father and son radiator is very good, it can be lowered by 10-20 degrees. Then add a heatsink under the graphics card position, and double heat dissipation is good. You can also take the computer apart to clean up the dust, but you have to pay attention to safety.

Generally, 30-50 degrees is normal for standby, even if the temperature of the graphics card rises to 90 degrees, it is only high, and the temperature of the graphics card can withstand at least 95 degrees or more, so you don't have to worry too much about cleaning up the dust, if it doesn't get better, you may need to replace the heat dissipation grease, and the position of the 100 sensor read by different software will also cause the temperature to be different, you can change the game plus to see the key information such as temperature and fan speed and occupancy.

Add a case fan, or remove one side of the case and blow the fan against the graphics card. The integrated graphics card does not have a cooling fan, and the heat sink is passive heat dissipation, and the temperature is relatively high.

Your current graphics card is an integrated graphics card, and it is better to use HD4830, 9600GT.

It is recommended that the landlord change the radiator, and the "overclocking three" radiator will do.

Changing the radiator works best. Water cooling is better.

Silicone grease can reduce the temperature by about 5%.

Directly apply a grain larger than a grain of rice, just scrape it flat with a straight plate.

Silicone grease is for CPUs

For graphics cards, you need to open the case, or blow it with a fan!

In the summer, if the graphics card is below 75 degrees, there will be no problem!

Silicone grease has little effect.

Replace the radiator and add the case fan.

Open the case and blow it with an electric fan, which is simple and convenient.