Why does the computer freeze so often and why does the computer freeze so often

Is it a virus??

Or is the hardware aging?

Recently, if you install hardware and connect other devices, you may have poor hardware compatibility. If the software crashes when running a specific software, it may be that the software compatibility is not good, you can change the software version, reinstall the software, or run the software in compatibility mode. It may be a system abnormal, and you can restore or reinstall the system.

It may also be overheating and causing a crash, so you can clean the ash and replace the silicone grease to improve heat dissipation.

Analysis of computer crash phenomena.

If your computer is newly built, do you see the light on the chassis panel or hear the fan inside the case when you turn on the power switch on your console?

1: I didn't see the panel indicator light on the case, I didn't hear the fan, and the computer didn't respond at all.

If you notice that the light on the case panel of your computer does not light up and you do not hear the fan turning, indicating that your computer is not plugged in, check the power supply.

2: I saw the indicator light on the case panel and also heard the fan turning.

I saw the indicator light on the case panel and heard the fan turning, which indicates that the computer is plugged in. So is the power indicator on the monitor?

a) The indicator light of the monitor is not on.

If the monitor's light doesn't light up, check that the monitor's power cord is plugged in and turn on the monitor's power switch. [It should be noted that there are some monitors whose power indicator is not lit when the main unit is not emitting a signal.] ]

b) The indicator light of the monitor is on, is there any text displayed on the screen?

There is no display on the monitor screen, please check whether the signal cable of the monitor has been connected to the main unit, please connect the signal cable firmly to the interface of the graphics card. And confirm that your case horns are intact and ready to sound.

The horn was heard:

If it is the horn that emits a "tick......Tick ......"Two consecutive beeps are relatively short, and the alarm sound is repeated.

It means that your graphics card is not plugged in properly, or it is not in good contact. At this time, please turn off the power, open the chassis, reinsert the graphics card, and tighten the screw. There are some compatible machine chassis design is unreasonable, if the agp graphics card is tightened screws, it will cause one end of the graphics card to be warped, resulting in poor contact, then you have to do it yourself and find a way to fix the graphics card.

If it still crashes, and continues to make the sound mentioned above, it may be that there is a problem with your graphics card, it is recommended that you take it to another machine to try it, if it still doesn't work, then you need to change the graphics card.

If the horn sounds "......Tick ......Tick ......"Each sound is long and repetitive.

This sound is made because the system did not detect the memory module, it is possible that there is a problem with the memory module, it is better to reinsert the memory module and try it on a different memory slot. If that doesn't work, replace the memory module.

No horn sound was heard.

In this case, we have to check the cables and the individual accessories one by one. First, turn off the power of the main unit, then unplug all the cards (including the graphics card) plugged into the motherboard, and then unplug the hard disk data cable, floppy drive data cable, and reset cable on the chassis panel (the power switch cable and speaker cable are kept). Only the CPU and memory are left on the motherboard.

Because sometimes the reset switch is stuck and the motherboard is always in a reset state, the computer will not boot. In addition, if the data cable of the hard disk is reversed, it will also cause the host to be unresponsive.

Then turn on the power again, and pay attention to whether the speaker is making sound.

CPU use 100, set up virtual memory, virtual memory is the computer in the process of running the program, when there is not enough memory, the computer will open up disk space from the hard disk as memory use and not to crash in real time, this part of the hard disk space is called virtual memory. (Yes, I 31434504 talk about computer application technology together.)

Here's how to set it up in a very detailed and simple way:

Right-click on "My Computer" on the desktop Stats Advanced Click on "Settings" in the "Performance" area Click on the "Advanced" tab Click "Change" in the "Virtual Memory" area.

Select the system drive letter (usually C drive) in the drive list, then select the "No paging files" item, and then click the "Settings" button.

Then select a partition with a large free capacity in the drive list (e.g. D drive, E drive, or F drive) Select the "Custom Size" option and fill in the "Initial Size" and "Maximum" columns.

It is recommended to set the initial size to multiple of your computer's memory module capacity, and the maximum value to be 3 times the memory module capacity (384 and 768 if your memory module capacity is 256M, 768 and 1536 if your memory module capacity is 512M, and 1536 and 3072 if your memory module capacity is 1G). Tip: Virtual memory only calls the capacity of your hard drive temporarily, so rest assured, it won't take up the capacity of your hard drive forever.

Click "Settings", then "OK", and finally restart the computer, and the virtual memory settings will take effect.

There are a few points that often crash:

1. The CPU fan is broken, resulting in the CPU

Superheating. Crash.

2. The graphics card fan is broken.

Causes the graphics card to overheat and crash.

3. The memory is loose, the contact is bad, or the memory is broken.

4. The power supply is insufficient.

It is recommended to try a different power supply.

System issues. Redo the system.

The CPU temperature is too high.

The power supply voltage is unstable.

Too many programs are open.

Memory is heavily occupied.

Low CPU or memory configuration.

There are logical or physical bad sectors in the hard drive.

There are viruses. Let's kill it.

Too many junk files.

Too many fragmented files.

System issues. There are compatibility issues with hardware and software.

The BIOS settings are incorrect.

Dust and dampness also have an effect.

Computer crash failure analysis.

Everyone who has used a computer has probably encountered the phenomenon of crashing, the freezing of the computer is indeed a very annoying thing, and sometimes it will bring you a lot of losses, but this problem is also true. Here are some examples to analyze the specific problem:

Graphics card reasons. q

A computer happens recurringly.

Check if it's a virus.,Antivirus.。。

Check if your host and memory are broken.

Check if your CPU fan is broken and the CPU cooling is too high.

Check if your power supply is not normal, the voltage is not normal...