Regarding the problem that there is noise in the cover of the recording on the computer.

Change the headset Secondly, you can use professional software to do noise reduction.

Our computer voice has noise, we are also very unhappy to use, the following is about the computer voice noise what to do, welcome to read!

There are only a few reasons for the noise in computer headsets, and it is easy to find the real cause as long as the corresponding solutions are eliminated one by one. There are several reasons why computer headsets have noises:

1. The computer is not cleaned up in time, too much system garbage is piled up, and the computer responds slowly;

2. The headset is damaged;

3. The computer has static electricity, which is also the main reason;

4. The microphone is in a strengthened state;

5. There is a magnetic field source or sound wave source near the earphone;

6. Abnormal voice during voice call;

7. If the microphone is not turned on to strengthen, the volume of the headset will be very small, and there will be a lot of current noise when the microphone is turned on and strengthened;

8. The headphone jack is faulty.

If there is noise in the computer headset, then the first choice is to determine what caused the noise in the headset, and then take the corresponding solution to eliminate the noise of the headset, the general solution is as follows 8 points:

1. Clean up the system junk and anti-virus of the computer;

2. Compare the headset with other headphones or computers, it is easy to judge whether it is a computer problem or a headset problem, and replace the headset if necessary;

3. Touch the iron part of the computer chassis with your hands, if the current sound disappears, you can put a piece of copper wire, one end is connected to the screw behind the computer, and one end is grounded, you can eliminate the current sound, the effect is excellent;

4. If the microphone is in the enhanced state, turn off the microphone reinforcement, because some sound cards do not support it;

5. Remove electrical appliances with magnetic fields;

6. If the voice is abnormal only when you are connected to your friends, it will be normal in the chat hall;

7. If the microphone is not turned on to strengthen, the volume of the headphones is very small, and there will be a lot of current noise when the reinforcement is turned on, the solution to this situation is: control the panel - sound and audio equipment - voice - recording - volume, click on it to see - adjust the microphone slider to the maximum.

8. There are headset sockets in the front and back of the host, and if you look at it separately, the effect of the back is generally better than the front.

It is inevitable that there will be noise in the recording, and it generally requires post-processing and software

That's for sure. The place where the recording is recorded must be anti-echo. You need to be quiet.

You record at home. Or it's not a professional place outside. There must be a problem.

If you're hiring to make money. Go out and rent a recording studio. Record.

The conditions are still complete. Comfortable,.The effect is not bad. Specialized.

Is the sound set right? There is a small speaker in the lower right corner, double-click to open the volume manager, Options--Properties--- Recording--- put the microphone on the hook, click OK, and put the microphone on the hook in adjusting the volume** Try it.

When recording a song, you can use the following methods to reduce background noise:

If possible, you can borrow soundproofing and noise-canceling recording studios for recording.

Noise-cancelling microphones can be purchased to reduce ambient background noise.

In rooms with low background noise and good sound insulation, high-quality microphones improve signal strength, improve signal-to-noise ratio and reduce noise.

It would be nice to use post-processing software, but I don't know if you can do it.