The master comes in and solves it, and asks the master to solve it

The system is testing IDE equipment, and now there are many IDE interfaces on the motherboard, generally more than 4.

When the system starts, you need to check the IDE interface one by one to see if the device is connected, so, if you have devices installed on the interface, then there is no problem, but for most families and individual users, the general IDE interface will only be connected to 1 or 2 hard disks and optical drives, in this way, there will be a plurality of IDE interfaces free, and the system startup is not known whether the interface has a device, so the interface will be detected every time it starts, so, It is necessary to close these unnecessary interfaces, which will speed up the system startup.

Closing method, right-click on My Computer-Properties-Hardware-Device Manager (or in the Control Panel) - IDE ATA ATAPI Controller, open the properties of the primary and secondary IDE channels, and in "Advanced Settings" 00 check the device type of each interface, if you can choose None, then select None OK, so that close all interfaces without devices, restart, and you will find that the system boots up much faster.

You said that your hard disk light is on late, I think the problem is here, because the system scans the interface one by one, which delays the reading of the hard disk data, naturally, the windows screen is also slow.

Not to mention other system acceleration methods, you searched a lot, here is just the right medicine, not to do those ctrl+c transactions.

This situation may be that the hard drive has physical bad sectors.

3* 4 *(5 -3)=24

Children, memorize more multiplication oral decisions.

The third way is to calculate the total length of the side rectangular box, and then divide by the total number of edges (8+6+4) 4 12=18 4 12=72 12=6

First of all, take a look at what the prompted program is, it may be that there is a problem with this program, if it is uninstalled and reinstalled. If there is a prompt at boot, you can remove the boot start of this program. If you can't find out, you can recall what program software, plug-ins, patches or drivers you had before this kind of failure, and if you want to uninstall them first.

If you can't find it, it is recommended to check and kill the Trojan horse and repair the system.

1. Please use the system's built-in system restore to restore to the time when you do not have this failure (or use the restoration software to restore the system, if you can't enter the system, press F8 to enter the safe mode to restore the system).

2. If the fault is still there, use the system disk to repair, open the command prompt and enter sfc scannow Enter (there is a space between sfc and ), and insert the original system disk to repair the system, and the system will automatically compare and repair.

3. If the fault persists, set the optical drive in BIOS as the first boot device, insert it into the original system installation disk, press the R button, and select "Repair Installation".

4. If the fault persists, it is recommended to reinstall the operating system.

Please also do a little bit of private sub text1 keypress(keyascii as integer).'text1's keyboard event, that is to say, the keyboard will trigger the execution of the ** inside, keyascii is each resistant to the front.