There is a problem with the old blue screen of the computer, what is the reason for the old blue scr

Stop Error Number: 0x0000000a

Workaround: If you can't log in, restart your computer. When the list of available operating systems appears, press the F8 key. On the Windows Advanced Options menu screen, select"The last correct configuration"and press Enter.

Check that all new hardware or software is installed correctly. If this is a clean installation, contact the manufacturer of your hardware or software to get any Windows updates or drivers you may need.

Run all the system diagnostic software provided by the computer manufacturer, especially memory checks.

Disable or remove newly installed hardware (RAM, adapters, hard drives, modems, etc.), drivers, or software.

Make sure that both the hardware device drivers and the system BIOS are up to date.

Make sure the manufacturer can help you have the latest version and help you get the hardware.

Disable BIOS memory options such as Cache or Shadow

In general, there will be no hardware bad, for example, if you install some hardware, if the driver is not corresponding, this situation will occur, and when you appear in this situation, analyze whether you have newly installed new software or new hardware!

There is also a more likely situation that the system you are using is not very good! There are a lot of BEGs out there, and I would like to give you a suggestion: you install a new good system (just go online!).

There shouldn't be a blue screen anymore!

To put it bluntly, the blue screen is a compatibility issue!

**I don't understand, it's very likely that I read it, or the driver is not played

1. System reason, solution: reinstall the system, this is basically omnipotent.

2. Reinstalling the system or appearing, it may be caused by hardware, incompatible with the memory module, bad sectors of the hard disk, motherboard failure, etc., may be caused.

How can the blue screen of the computer be rotten in the state of the bright office?

Start by confirming whether it's a software or hardware failure.

Try reinstalling the system first.

If the flush is still a blue screen.

Then there are more possibilities.

The fan temperature is too high, the power supply is insufficient, and the memory module will be blue screen if it is like a barrier.

In general, the best thing to do is to replace the memory of the same model or send it to a designated computer repair shop for service.