Audi go 5 car just started to drive well

Q5 just started, the engine is cold car idling, the speed is high, you can drive, Jianyi idle speed down and then open easy to control, especially for people who have just learned to drive!

Hello! Generally, the vehicle first self-checks, and the purpose of the self-test is to read the parameters of each sensor and set it accordingly! Then, start the vehicle, generally idle in situ for about 30-60 seconds, the purpose is to make the oil reach the required parts, followed by heating the oil, to reach the working temperature of the oil, in the best working performance!

Because the oil has a viscosity around 10, it has a real lubricating effect, and the longer the process is reached before the viscosity of 10, the greater the wear. Appropriately increasing the speed value of idle speed at cold start can increase the oil pressure to make the oil reach each machine part more quickly; At the same time, the coolant temperature is quickly increased to assist the oil to reach the viscosity of around 10 under the warm-up condition at the earliest. In particular, starting the in-situ hot car in winter can reduce the wear of the engine oil at low temperatures and high viscosity.

Finally, it is to drive at low speed for two or three minutes to maintain a low-speed driving state, the purpose is to make the temperature of the gearbox, steering machine, brake pump and other components rise synchronously, which can help the engine heat up more quickly

Hello: It is best to warm up in winter, so that the performance of the lubricating oil increases, which is good for the maintenance of the vehicle.

It is not advisable to do this, wait a little for the hot car before leaving. Hope mine can help you.

The third floor may not be successful, and the powerful car will squirt out things that are not tightly stuffed. And the landlord must not want to stuff it too tightly, so as not to be able to get it out himself.

1.Drain the tank of oil.

2.Borrow someone else's Audi key and he won't be able to open it.

The method is very simple, that is, open the cover of the engine compartment, loosen the spark plug of the engine and the ignition coil on the spark plug, so that the engine does not catch fire.

It's very simple, the side trim of the A-pillar of the dashboard is open, it's very easy to pick, there is a small gap, the key can be done, there is a gasoline pump fuse inside, it's OK to pull it out! If you don't know which insurance it is, there is an instruction manual on the inside of the trim.

Add a switch to the battery line.

Use something soft, loose, plug the exhaust pipe, borrow it from a friend, plug it, go away, and then take it out.

Or install an oil-electric dark switch to prevent theft and borrowing.

Just install it in 4s.

Headlight cleaning is the same as glass washing, but the headlight cleaning device must be turned on for the headlight to work!

Turn on the headlights, press the button to clean the front windshield, and press it for a while.

Turn on the headlights and lift the button to clean the front windshield for more than two seconds.

The washing device can only be used if the headlights are turned on.

Turn on the headlights, then snap the wiper lever backwards.

Look at the manual.

Turn on the headlights and turn on the high beam!! I wash the front windshield! This way it can be washed.

Alas.........Look at your wiper poles.

Before starting the engine, the automatic transmission joystick should be placed in either the P (Normal Forward gear) position or the N (neutral) position to start the engine. When the joystick is in a different position, the engine cannot be started.

The overspeed switch can be turned on while driving. If you have a mode switch, you can put the mode switch in the economy mode or standard mode position, which can save some gas. When accelerating, the throttle should be slowly increased, especially the automatic transmission car with a small displacement, it is not urgent, if there is no special need, do not rush the accelerator, and the engine speed should be controlled within the economic speed range as much as possible.

When the car suddenly turns off in the middle of driving, the control handle is still in the driving gear position, and the engine cannot be started by turning the ignition switch at this time, it is best to stop the car first, and then hang the control handle into P gear or N gear before starting the engine; Another way is to put the joystick into the n position while the car is coasting, then start the engine, and then put the joystick into driving gear to continue driving.

When you need to overtake at high speed in a short distance, you can press the accelerator hard before overtaking, and press on it, at this time, the car will shake a little, which is the automatic transmission automatically drops a gear, which can make the car get enough torque to quickly increase the speed. After completing overtaking, you should release the throttle immediately so that the automatic transmission will automatically move up one gear and resume normal driving. This kind of high-speed, low-gear driving method is more damaging to the car, so it should not be used frequently.

Special road surfaces should be handled carefully.

When driving on small ramps, you can put the joystick in D gear and use the accelerator or brake to control the speed of the car up and down the hill. And driving on larger ramps, when the car slows down after going uphill, and feels that the power is not enough, you can put the joystick in 2nd gear, and then continue to drive with the accelerator; If you slow down after a slope and feel that you don't have enough power, you can put the joystick in 1st gear and continue driving.

When the car is going down a long slope, it is best to put the gear selector in 1st or L gear, and it is forbidden to put the gear selector in N gear. Because the car is going downhill, the speed will increase due to the weight of the car, if the gear lever is in D gear, it is necessary to use the brake frequently, which is easy to cause the wheel brake to overheat or make the brake fail, which is extremely dangerous when the car is downhill.

When driving on dirt roads, if the joystick is in D gear, release the accelerator pedal immediately when the drive wheels slip. Since the slippery drive wheels rev quickly, the automatic transmission raises one gear, further exacerbating the drive wheel slippage. At this point, the joystick can be placed in 2nd or 1st gear, or even L gear, to limit the automatic transmission's top gear.

When reversing, after the car is completely stopped, put the joystick in R gear, release the brake, do not need to refuel, and slowly reverse at idle speed; If you want to cross steps, protrusions or climb a hill in reverse, you should slowly increase the throttle, and after crossing a step, protrusion or climbing a hill, you should release the throttle in time, and immediately step on the brake to control the speed.

Happy driving!

Upstairs, where did this copy?

Fasten your seatbelt, press the brakes, press the start button, the engine ignition, the gear knob is shifted to D gear, the brakes are sent, and the car drives.

1.Take the key and open the car door.

2.Adjust your seat.

3.Click Start

4.Foot on the brakes.

5.Move the remote stick to D and S.

6.Then it's time to boot and go.

It is recommended that you check the oil pump and grease nipple

1. Take out the car key with a holster from the cover, and observe the position of the dark key if there is not.

2. There is a movable gusset at the corner of the key, and there is a pointing triangle on the gusset plate, which can be moved gently by hand.

3. One finger board moves the buckle plate, and the other hand can directly pull out the car key from the side.

4. After taking out the dark key, observe that there are two natural pits on the corners of the original shell, which are consistent with the size of the original car's dark key.

5. Use the dark key drawn out to aim at the pit. With both sides in a cross, the key is pressed against the key case and the key is turned.

6. After turning, the key shell will burst open naturally, and then both hands can be gently opened.

Not sure which one you are :

One has an integral metal logo on the top, hold the metal mechanical key, and then press the inner part and pull it out, and there is a coin cell battery inside.

Look here a kind of fully enclosed, the sign is on the key, with a knife or something, pry the key from the edge, revealing the battery. Look here.

Is it to replace the battery? There is a gap in the middle of the key, about 2 mm, gently squeeze it with a qizi, and then pull it open with your hand, you may have to come several times, do not hold it hard; After opening it, you can see a button battery, 3V, take it off and take it to the market to match, and you can install it.

I change it to a 4S shop.

Do it yourself, according to the manual, first buy the same specification of the button battery, there is a small gap on the key, and it can be replaced directly with a screwdriver.

It should be free to go to the 4S store to find someone to get it.

Use the smallest flathead screwdriver to slowly warp through the gap in the back, and the inside is snapped

The remote control was opened, and it turned on with a slight warp.

After starting, start up, step on the foot brake to change gears (from P gear to D gear), release the parking brake, release the foot brake and step on the accelerator to grasp the direction and drive.

The Audi A6 (Audi A6) is a luxury car produced by Audi and is available in both sedan and station wagon models. The Audi A6 incorporates Audi's most advanced high-tech exclusive technology in the world, further enriching the luxury equipment and giving it a super sporty character, from design to performance.

The Audi A6's Multitronic continuously variable manual transmission is the first time in the history of luxury sedans that a truly continuously variable transmission has been achieved.

The Audi A6 adopts a metal chain transmission method, which completely replaces the traditional gear set transmission method, so the power output is completely frustrating, smoother and smoother than ordinary automatic transmission, and has the speed and sensitivity of manual transmission, while also saving fuel and making it more comfortable to handle.

The newly added S gear improves acceleration and increases driving pleasure. One of the most fascinating aspects of the Multitronic manual transmission is that it overcomes all the shortcomings of automatic and manual transmissions, surpassing the performance of both in one fell swoop, and achieving a quantum leap in automotive transmission technology.

If it is an old A6, insert the key into the hole on the right-hand side under the steering wheel and turn it clockwise.

If it is a car that is standard on the A6L, it is the same as above.

If you have an A6L premium key, you only need to carry this key with you, and then press and hold the start button on the left side of the gear lever and stop the bottom one.

On the right side of the steering wheel, the instrument panel inserts the key and twists clockwise, and the deluxe model has a round silver start button on the left panel of the partner, and the start engine is written on the old model, which is a black square button.

Applies to: MMI: On the home screen, select: Settings connection settings. Bluetooth.

Applies to: Rear seat remote: On the home screen, select: Settings Connect Bluetooth.

Bluetooth works with: mmi: You can choose to set "Make other Bluetooth devices visible".

When you want to pair a new Bluetooth device, you must select Set Visible. If you select Invisible, only Bluetooth connections to paired devices can be established. If you choose to turn it off, then you can't pair your Bluetooth device.

The standard automatic type is without Bluetooth and needs to be installed by yourself. If it is a 10-model car, the original car was originally carried, but it was just locked, and it can be unlocked.

The standard automatic and the following seem to be without Bluetooth function, and they need to be installed, so you can consult the 4S store for details.

Hello landlord, you look at the manual, all the functions on it are written, he will tell you how to operate!