-
Anonymous users2024-02-05A signal strength of 0 is a connection error between the signal pot and the receiver! It is advisable to recheck the connection! When the signal strength is not 0, start debugging!
The following takes receiving Zhongxing 6b as an example: first select Add Program or Auto Search in the menu, and re-enter the parameters (downlink frequency, polarization, symbol rate, FEC channel name) with the remote control.
3706 Level (h) 4420 3 4 Fujian Southeast TV).
Once set up, start adjusting the pot, first point the pot to the south and slightly east, and then have one person watch the TV while you move, and let him report the signal quality! Move left and right until the signal quality is at its highest, then move up and down, as above! Until the signal quality reaches more than 35% and the status is locked, the signal quality bar should be colored at this time, and Southeast Satellite TV can be seen at the same time.
-
Anonymous users2024-02-04You're talking about small satellite receivers. There is no signal, I guess you are adjusting the wrong direction, probably the direction of the pot mouth is facing south, and the angle is about 35 degrees. Then turn it and find the signal. It's stupid method.
Usually, the dealers of these antennas have a dedicated person to install them. There are height and angle parameters on it, which are easy to adjust.
-
Anonymous users2024-02-03The cauldron is to the signal, first adjust your receiver to any of the stations, we generally tune to the Henan station, and then press the information key at this time there will be p00 or p0x At this time, you have to adjust the direction of the cauldron a little bit, the direction of due south, up and down, left and right, (you have to make sure that the 0 scale mark of your high-frequency head is level with the ground), if the direction and angle are right, the green light of the signal indication will be on The value of p00 will change, probably adjust to p48 or more Your cauldron can be seen.
-
Anonymous users2024-02-02In rural areas or townships, there are still a large number of people who use pot lid satellite antennas, so how to install small pot lid satellite antennas?
01 Assemble the main part of the lid according to the instructions, and install the receiver in front of the pot to align it with the marked position.
02 Then connect the antenna to the set-top box and follow the exit manual. Output a wire on the small pot and connect it to the set-top box so that the signal can be received.
03 Then connect the set-top box to the TV, there is a red, white and yellow interface in the back, and connect the two wires together according to the corresponding color.
04 After the connection is completed, adjust the TV to the corresponding view, and then adjust the position of the lid of the pot, aiming at the satellite in space, the domestic satellite Zhongxing 6b Zhongxing 5a and so on.
-
Anonymous users2024-02-01<>1. Assembly and placement of pots. Install the pot according to the instructions, and then put the pot in the position where you want to install it, be careful not to have any obstructions! The end of the white lid of the high-frequency head is facing the pot noodles, and the signal cannot be adjusted if it is reversed.
The high-frequency head is stuck on the bracket, facing forward and backward, and facing left and right has no effect. The satellite pot can be installed on the roof, ground, balcony or air conditioner, and there can be no high-rise buildings, big trees, glass, anti-theft windows, anti-theft nets or even branches in the southwest direction. Agitation.
2. Connect the antenna to the receiver. If the set-top box does not light up after plugging in the coaxial cable, it means that the coaxial cable is short-circuited, check the joints at both ends of the coaxial seepage line, and clean up the fine broken mesh inside, the mesh and the copper core cannot be contacted.
3. Link TV and receiver. It's very simple, the red line is connected to the red line, the yellow wire is connected to the yellow line, and the white wire is connected to the white line.
-
Anonymous users2024-01-31The satellite dish (small pot) has no signal, how to adjust it?
Hello, dear, I'm glad to answer for you: the satellite dish (small pot) has no signal, how to adjust? Hello, the satellite dish has no signal adjustment, and the specific method is as follows:
1.Press the F3 button of the remote control to adjust the star button. 2.
Squat behind the pot and slowly turn the chassis first to maximize the signal quality. 3.Adjust the elevation angle to maximize the signal quality.
4.If the signal quality does not go up; It is necessary to check whether the polarization direction of the high-frequency head is correct to ensure that the 0 scale is directly upward; Make sure that the elevation angle of the cauldron is maintained at an approximate angle of 15 degrees behind the vertical deviation; Make sure that the horizontal direction is approximately 43 degrees west-south. 5.
Due to the different geographical locations, there are differences in the car, and the small pot should be slowly closed and carefully adjusted.
See the polarization scale on the high-frequency head? There is a 0 scale in the middle, just parallel it to the ground, no matter up and down, left and right, the 0 line is parallel to the earth. Visual inspection ensures that the high-frequency head is roughly perpendicular to the bottom of the pot! >>>More
No, if there is a satellite around it, then the star should be large enough and have enough space. What's more, there is a "satellite satellite", imagine how big it must be. On the second floor, it says something like "Chang'e-1", which has its own power and maintains balance at a certain height. >>>More
It is enough to use a 90 satellite receiver, a 11300 high-frequency head, and a receiver from Zhengzhou Wycombe Company (this equipment is used for distance education of party members and cadres, and you can change the parameters to distance education for primary and secondary schools).
Mackerel rice with tomackerel sauce not only has a rich flavor of tomato sauce, but also has the flavor of mackerel! It's very delicious and enjoyable. You can go to the supermarket and buy ready-made canned mackerel to cook your own meals, or you can make your own at home. >>>More
What kind of TV box do you call it? Is it the one produced to match the display,If it is this one, you can connect the satellite pot,You have to correct it,Not directly connected to the satellite pot,But connected to the satellite receiver at the back end of the satellite pot,The **jack behind the receiver is connected to the **jack on the TV box with**wire,Then connect the signal of the TV box to the display,Some of the TV boxes have no audio,You have to connect the audio of the receiver to the power amplifier。