What are the beautiful ways to tie bows?

The tie method of the collar bow, first cross the two belts, one on the top and one on the bottom, the upper belt bypasses the lower belt, and then hang down from the middle of the two belts and tighten it, tie a slipknot, fold the lower belt into the side of the bow S-shape, place it on the right side along the direction of the belt, and then use the upper strap to wrap it from the top of the bow to the bottom, the upper belt bypasses the bow on the right, folds it into the bow on the other side, slowly arranges the formed bow, tightens it and fiddles with it slightly, The beautiful and flat bow comes out, isn't it very suitable for your beautiful clothes!

The method of tying the spherical bow, wrap the ribbon with a length of 10 cm out of a circle with a diameter of 10 cm, repeat 5-6 times, hold the ** part, press the middle with your fingers, as shown in the figure, use scissors to repair the angle, overlap the cut part to the middle and align it, tie the ** part with a 10 cm long ribbon prepared at the inside and outside, pull the ribbon out from the inside out, turn all the upper ribbons out alternately left and right, and pull out the lower ribbons in the same way. Then tidy up the opening of a spherical bow to finish, and use the finished bow to decorate the gift box.

You need to put the belt in a suitable position first, align the left and right sides of the belt, and then you need to tie a knot first, the purpose is to fix the belt, and then fold both ends of the belt inward, so that the corners of the belt sag, and tie the folded belt into a knot, and spicy it, at this time, the circle formed after folding the left and right will come to the opposite side. Arrange the vertical knots that are formed, so that a beautiful bow is formed.

Tie the waist bow with the short side under the long side; Wrap around it for a short time, and the strap is tightened; The long ones come up from the short ones; This step is the most critical: the long one is discounted, and the good one is worn out of the short formed loop; Tidy it up, stretch the straps on both sides to the same length, and you're done.

Tie a knot first. With your right hand, hold down the knot and pull up the ribbon on the left side. Tie another knot, but the second knot is not solid, overlap the two ribbons, wrap a loop around the left hand, then pass the two ribbons through the middle of the two knots, open the two ribbons that are threaded, wrap around a loop slightly smaller than the left hand, tighten with the loop on the left side, and arrange the shape.

Let's fold one side of the belt first, just like the ** inside. The length should be the same length on both sides. Then put the other side on the strap you just folded.

Wrap the bag from the back, bring the strap from the back to the front, and go through the middle after getting to the front. If you pull the strap hard and it won't loosen, it means that you have the right tie. Just adjust the bow.

Align the left and right sides of the belt and tie a knot. Then form an S-shape on each side of the belt. But the two sides should be in opposite directions. Tuck the finished S-shape into the folded belt and tighten it firmly. Tidy up the shape a little and it's formed.

Bend the ribbon and hold one side with each hand. If you like to hang unevenly, you will stick to one long and short, and if you like flat, you will be average, depending on your personal like. The two ends of the hold are intersected with each other. As shown in Fig. Tie a knot, don't think too much, it's the usual kind of knotting. Pull it tight, and it's done.

1. 1) First of all, pick up the shoelaces on both sides with both hands, then let the thumb and index finger of both hands open, and the remaining fingers pinch the laces on both sides, and then pull two crosses, so that it is done. This is the easiest way to do it. Shirt carrying.

2) First, use the thumb and index finger of the left and right hands to prop up the laces in the same direction at the same time, and then pinch the laces supported by the other hand with the thumb and index finger at the same time, and pull hard in the opposite direction to adjust the tightness you want.

3) First of all, let the index finger and thumb of both hands stretch out or clear, and make a circle around the two fingers clockwise with the left hand and clockwise with the right hand. Then let the left and right hands face each other, and the index finger hooks the strap of the other hand, and pull it with both hands. Finally, overlap the two bands of each hand, cross the straps, and tie the lower straps through the "hole" by tying a common knot to complete the shape.

Second, the materials are ready: red ribbons and so on.

1. Stack the two ends of the strap like this, with the left side on the bottom and the right side on the top.

2. Fold the lower part of the right side and press up two-thirds, and press your thumb at the intersection.

3. With your left hand, pass the lower left strap through the inside.

4. Bypass the center intersection and fold it below the fold in step 2 just now.

5. Pinch the center point and the folded part of the right end with your left hand, use your index finger or middle finger to fold the left end into the hole and poke it out, catch it with your right hand and pull it out.

6. Adjust the length and tighten it. Such a simple bow comes out.

Tools Raw Materials:Ribbons, scissors.

1. Wrap the ribbon with a length of 10 cm into a circle with a diameter of 10 cm and repeat 5-6 times.

2. Hold the ** part tightly.

<>4. Overlap the cut parts to align them in the middle.

5. Tie the ** part with a 10 cm long ribbon prepared separately.

6. From the inside to the outside, pull the ribbon out from the inside, and turn out all the upper ribbons alternately left and right.

7. Pull out the lower ribbon in the same way, and then arrange a spherical bow at the beginning.

The first type: how to tie the bow at the waist.

The short side is placed underneath the long side;

Wrap around it for a short time, and the strap is tightened;

The long ones come up from the short ones;

This step is the most critical: the long one is discounted, and the good one is worn out of the short formed loop;

Tidy it up, stretch the straps on both sides to the same length, and you're done.

The second type: the tie of the collar bow.

Start by crossing the two straps, one on top and one on the bottom;

The upper strap wraps around the lower strap and hangs down between the two straps to tighten it and tie a slipknot.

Fold the lower strap into an S shape on one side of the bow and place it on the right side in the direction of the strap;

Then use the upper strap to wrap it from the top to the bottom of the bow;

The upper strap wraps around the bow on the right side and folds into a bow on the other side;

Slowly arrange the formed bow;

Tighten it and fiddle with it a little, and the beautiful and flat bow will come out, isn't it a good match for your beautiful clothes!

The tie of the bow is as follows:Material preparation: red bands and so on.

1. Stack the two ends of the strap like this, with the left side on the bottom and the right side on the top.

2. Fold the lower part of the right side and press up two-thirds, and press your thumb at the intersection.

3. With your left hand, pass the lower left strap through the inside.

4. Circle the center intersection of Zhongxiang and fold it below the second fold of the second step just now.

5. Pinch the center point and the folded part of the right end with your left hand, use your index finger or middle finger to fold the left end into the hole and poke it out, catch it with your right hand and pull it out.

6. Adjust the length and tighten it. Such a simple bow comes out.