My friend gave me a lighter, and I couldn t add it when the gas dried up

Your method of filling the gas is not normal, please be sure to press the gas tank hard and press the gas hole of the lighter. Generally, freshly filled lighters are cold and need to wait for a while before they can be used.

Then you see whether the lighter is disposable or reused, if the latter you can buy a can of gas, similar to a spray bottle, there used to be a brand called red leaves, press the air filling hole and don't let go to know that the gas is full.

Are you sure yours is not a disposable lighter? Then adjust your inflation valve properly to see if it still works.

Go to that kind of place where lighters are monopolized, people must know.

First of all, there may be two problems with this, the first is to check whether there is a problem with the inflator hole of your lighter, and the second may be that there is a problem with your inflatable bottle, you can change a few more inflatable bottles, eliminate the method, and see if there is a problem.

Try a lighter If it doesn't work, it's a lighter.

If you can't add it, you'll blow up his chrysanthemum.

Get a new one, maybe a one-off.

Maybe it was kerosene.

Try twisting the inflatable hole in the back of the lighter a little.

Put the top of the inflatable and the tail of the lighter and squeeze it a little.

Disposable, there is no change in addition.

How about the refueling method and the quality of the gas.

It is possible that the air intake hole is plugged and pulled.

Not every lighter can be refilled. There must be an air port at the bottom. If you can't add gas, it may be that the lighter refueling port is blocked, if not, it means that the gas is in the wrong direction.

The fact is that the liquid is required to be added, and the volume of the liquid into gas increases many times, so it is durable; If you just add gas, it will be used up in a while. Therefore, the outlet of the refueled gas tank should be turned downwards so that the liquid can enter the lighter gas tank.

Add it from top to bottom, and it won't take long to buy a lighter for a dollar, and I directly bought a few hundred, using electricity. I have used it for 4 months, and I can smoke 4 packs of cigarettes after charging it for more than an hour.

The air valve is aimed at the lighter and the air hole can be pressed down.

There is an inflator nozzle at the bottom, just press it down with the nozzle of a lighter cylinder.

Be sure to drain the remaining gas in the lighter (use something to top the gas hole), and then screw the gas cylinder into the lighter downwards, and gently shake the gas cylinder upwards. Dupont is slow to add gas, and it takes about 2 to 3 minutes to add it all. Because the inflatable cylinder and the inner bottle of the lighter are exactly the same size, so be patient If you still can't add it, see if the iron buckle of the gas cylinder is stuck and doesn't move?

It's just that after adding it for a long time, the gas cylinder is still full) In this case, go and change the bottle of gas.

Dupont's lighter needs an inflator nozzle, that is, a lighter, a bottle of ordinary gas and a nozzle.

Hungry, of course, the Dupeng I mean is genuine or Hong Kong-made imitation, if it is not for these two, it is a problem with the lighter or the gas if it cannot be charged.

You can go to ** "Baiyun Boutique World" to learn how to inflate Dupont lighters, with pictures and detailed explanations.

Du Peng's mouth is relatively thin, so you have to use special gas, or it's fake, buy a conversion mouth.

Heat the gas with a lighter! Remember to keep track of the temperature.

I don't know if the counter is repaired, I suggest you buy it again, I bought it in Pinshang overseas famous stores before, it's very good, and I'm still using it, and I also bought it myself.

You try to amplify the qi.

The biggest possibility is that the quality of the oil is not good, it is recommended to buy **zippo oil. Now there are many imitation ZIPPO kerosene on the market, generally **ZIPPO kerosene is between 20-30, and less than ten yuan of zippo kerosene is imitation, but the domestic one is not necessarily bad, just depends on which manufacturer you choose to leave the factory. It is recommended to buy Stellar factory.

Isn't it covered? Listen to your situation, it seems like the oil has volatilized.

First of all, you hit it to see if there is electric light, and if there is, it proves that the ignition is no problem, and then you hit it again, often press to smell whether there is a smell, and if there is gas. You can also take a good lighter and hit it first, put the mouth at it, if it catches, it means that the ignition is useless, and it is disassembled to replace it, that is, to disassemble other lighters and replace them. If you don't rush in or don't get out well, take it apart and fix it yourself, it's likely that the trachea is off, just plug it back.

The reason is that the gas in your lighter is not compatible with the gas you bought, resulting in unstable air pressure and a phenomenon that cannot ignite.

You put all the gas in the lighter, be sure to put it clean, and then pour the lighter steam upside down into the lighter (it will be full in 3 seconds at most), heat it by hand, and it can be used normally.

Look** is not very clear, it feels better, first, if it is a lighter with resistance wire, there are three reasons why it cannot ignite, 1 is no electricity, 2 is not gas, 3 gas is problematic 1 is not electric, charge the lighter.

2 no gas, if the gas is good, it is estimated that the air pressure is not enough, and then fill some gas 3 If the gas is not good, change the bottle and flush it down.

2. If it is an impact spark ignition, the possibility of the first one running out of power can be ruled out.

It's too cold just to rush in, and it'll be fine after a while.

Possible Issues:

1. Low gas temperature;

Second, the purity of the gas is not enough;

3. The opening of the air outlet is too small; Generally, the size of the gas outlet can be adjusted at the bottom of the lighter, and the air outlet can be opened wide.

Solution: 1. Hold the lighter in your hand for a while;

2. Press and hold the ignition button, but do not press it completely, deflate the lighter, and refill it after it is discharged;

3. Generally, the size of the gas outlet can be adjusted at the bottom of the lighter, and the air outlet can be opened wide.

Adopt me, thank you.

In the case of a gas lighter, provided that the lighter is not damaged.

There are two reasons why it can't catch fire:

1. Just rush in, the temperature is too low, and your hands are hot for 2 minutes.

2. The air pressure of the lighter is unstable, and the two gases are not of the same brand, so the original gas of the lighter should be emptied, and then new gas should be injected.

It was the lighter inside the lighter that produced the spark, and the lighter was oily or had a memory of aging and failed. You can change the lighter, or clean the lighter's lighter, give it a try!

First of all, the gas that the lighter is filled with is liquefied gas that has been compressed under high pressure. It's like our gas. It's hard to get a lighter just into it. After inflating, wait a while and you can hit.

Secondly, you can check the valve of the lighter, and it is not easy to ignite if the air output is too large or too small. Third, whether the ignition device, flint, and electronics of the lighter are effective, and if these effects are poor, they will also affect the success of ignition.

1. See if the flint and steel are effective, 2. See if the vent is blocked, 3. Check whether you are filling the gas normally.

1. If you are sure that the gas is enough, you can turn the lighter upside down to let the gas penetrate.

Second, you can drop a little oil on the core and ignite it with another fire, and then he will burn for a while;

Third, it is best to check whether the core inside the cotton core is broken, or other reasons.

The engine oil you bought is fake, and I've bought it once, and it's hard to burn with a fire point.

First of all, you make sure that there is no gas or not.

Then see if the flint and steel are broken.

Then check whether the asbestos is intact.

It is possible that this gas did not penetrate inside, or the lighter leaked.

Qi is not pure. Or maybe it's too cold. You can use the fire source to light it for a while and continue to light the fire.

whether the lighter's battery is weak;

whether the wires of the lighter have deviated;

The temperature of the new gas is very low, and you need to wait for a while before you can light the lighter;

Whether the gas bought is guaranteed by quality.

The vent is plugged.

Press the ignition button to release some gas and try again I've had this situation when the gas is too full.

The flint and steel were loose, and when it was disassembled, there was a twist at the bottom, which tightened him.

Changed to flint, how much did this cost to buy, 20 yuan?

The gasoline is too cold, just shake it.