CPU p42 6c 2 4c Which is better What are the advantages and disadvantages?

Can you still get such an antique CPU?

It doesn't matter how many watts the CPU is, overheating and restarting can only mean that your case fan is not hot well, and you should consider changing to a larger case or a better cooling device.

For example, fans are water-cooled and the like.

Of course, the higher the frequency, the better, not only the main frequency, but also other parameters.

The tile heat is small. 2。The speed is definitely not the same, maybe you can't feel the comparison and the contrast, but the contrast is definitely obvious, especially when playing games.

3。Solving the problem of heating is not the way to reduce the CPU model, otherwise why would there be a high-end CPU. Saving electricity is saving watts That is, you can save 1 kilowatt-hour of electricity when you turn on the machine for more than 300 hours.

Finally, no BIOS does not support the CPU, you can search for the problem of pressing F1 on boot It may be that there is a problem with your BIOS settings.

You can restore the default settings in the BIOS or pick up the jumper to restore the default settings.

Don't just look at the frequency, there are many factors that affect the efficiency of the CPU, such as architecture, cache, manufacturing process, etc., your two cup frequency and power are similar, then it depends on several other parameters, in general, the larger cache is better than the small cache, and the higher bus frequency is better than the lower one. The new architecture is better than the old one

Okay, although there are a few watts of extra heat, but it's very small, it doesn't have any effect, but the work efficiency is of course higher.

The power consumption of the P4C series is generally around 70W. In the case of a difference of a few W before and after, it is of no use to improve fever. Your problem is not something that can be solved by replacing the CPU.

You need to replace the CPU fan. Replace the fan with a higher speed. Heatsink with larger fins.

1. The Pentium 4 processor with all main frequencies is more complex, with 2 generations, 100 external frequencies and 400 front-end buses first; The last out of the 133 external frequency, 533 front-end bus, is one of the earliest 90 nanometer process processors, overclocking ability is good but the heat is large, now most of the words refer to the latter, in addition, there are, 133 external frequency, 533 front-end bus, and the earliest hyper-threaded processor, 200 external frequency, 800 front-end bus, 845d motherboard, can only support 533 front-side bus and 133 external frequency, so it can only support the earliest old and, installed will be used for frequency reduction, I'm afraid that the new 90nm is not recognizable at all, so it is recommended, the performance of the old one is really not very good.

A belongs to the older generation of Ben 4CPU 845 can only be clicked.

1 All of course P4C is good!! Don't think about it.

In terms of performance, the performance of P4C is much stronger than that of P4A.

The core technology is different.

SSE3 I don't think it's much of a use. Even if you don't support it, can't you still watch movies and watch TV??

Good cost performance, very classic, SSE3 instructions are not used by few programs.

It's definitely C's, C supports hyperthreading.

Whoever says it must be good is not certain, it depends on your luck.

Ultra overclocking can completely defy the Seyang D, no problem.

The one you're talking about is the maximum speed of your network card. It's not your internet speed.

Well, it's more than enough, but I recommend that you buy a Celeron that is cheaper than a better value for money than it meets your requirements.

Just because it's good to use doesn't mean it's still one of the best to use, there are more good CPUs in addition to this, it's just a little more expensive, and it's no problem to have money. If you don't have enough funds, it is recommended that you use Celeron, this P4 is a bit of a feeling that it is not up or down.

P4A 478-pin 2400Hz 90nm FSB 533 L1=16K L2=1024K Prescott core.

P4B 478-pin 2400MHz 130nm 533 L1=8K L2=512K Northwood Core.

P4C HT Technology 478-pin 2400MHz 130nm FSB 800 L1=8K L2=512K Northwood core.

The lift is huge. P4C is inherently better than P4E at the same frequency, and it is also a high frequency.

The improvement is still quite large, and it is better than changing it.

win+r, type.

Find Windows Search, stop and disable it.

Deactivate Aero Glass

At least memory, otherwise it would be difficult for this machine to do anything.

Single-core CPU is better not to use Windows7, after all, P4 is still something from 04, and Win7 is released in 09.

The working temperature of the CPU temperature of P4 is 20 70 degrees, the temperature is determined according to the calculation of your CPU, you said that it is 65 degrees just after booting, and the CPU heatsink is not very hot, it is very likely that your heat sink is not in good contact with the CPU, it is recommended that you remove the CPU, replace the silicone grease, and install it from scratch. In addition, always shutting down is not caused by the CPU temperature being too high, and the CPU temperature is too high to cause a crash. It's not clear what you're talking about, whether it's closed and won't be turned on, or if it's automatically restarted.

If it's automatically turned off, it may be caused by CPU overheating protection, if it's a restart, then there are many problems, it may be caused by memory, or it may be the motherboard, it's not easy to say, you can only do your own elimination method to determine the problem.

It is normal for the temperature of the south bridge to be high, and it is recommended to spend a few yuan to buy a fan and install it.

Maybe there is a mistake in the temperature detection of the motherboard, the fan is not strong enough, and the 3 contact is not good.

Check whether the CPU is in good contact with the fan, and then look at the setting problem, it is estimated that it is a hardware problem.

I'll have a configuration with you, and the minimum special effects are completely okay.

Very reluctantly! Try it to the lowest effect!