My computer s blue screen shows 0X000005 0X000000BFAA8DB5 0X0000008AFDDA5C, please point 20 with you

System BSOD issue caused by memory incompatibility! It is recommended that the landlord check what kind of memory model his machine is suitable for, and then buy the corresponding memory.

Take the memory module off, click it with an eraser, and put it back on! TRY ...

If that doesn't work, it's a problem with the hard drive!!

0x0000007b This is the memory address,First of all, it depends on whether your machine was good before,It was good before it appeared recently,That means that the computer hardware is no problem,That's a software problem,System problem,You can solve it by reinstalling the system,Go to Thunderbolt search xp,Then select the one with the most comments**,Then unzip,Then click the installer,You can install it all the way to the next step。

Stop Error Number: 0x0000007b

Description: inaccessi-ble-boot-device

Common cause: Failure to initialize the IO system (usually the boot device or file system).

Workaround: Boot sector viruses usually cause this stop error. Use the latest version of anti-virus software to check for viruses on your computer.

If a virus is found, you must perform the necessary unsearchable removal from the computer, refer to the anti-virus software documentation to learn how to perform these steps.

Remove all newly installed hardware (RAM, adapters, modems, etc.).

Check the Microsoft hardware compatibility list to make sure all hardware and drivers are compatible with Windows.

If you are using an appropriate SCSI adapter, you can obtain the latest Windows drivers from the hardware vendor, disable synchronization negotiation for the SCSI device, check if the SCSI chain is terminated, and check the SCSI ID of the device, if you are not sure how to perform these steps, you can refer to the documentation for the hardware device.

If you are using an IDE device, define the IDE port on the board as the only primary port. Check the master-slave unique settings of the IDE device. Remove all IDE devices except the hard drive. If you are not sure how to do this, you can refer to the hardware documentation.

If your computer has been formatted with the NTFS file system, you can restart your computer and run the chkdsk fr command on the system partition. If the system cannot be started due to an error, then use the command console, and run the chkdsk r command.

Run the chkdsk f command to determine if the file system is corrupted. If Windows can't run the chkdsk command, move the drive to a different computer running Windows and run the chkdsk command on that drive from that computer.