-
You can use a razor blade to scratch the fine slits on the nib, and if you want to clean the nib thoroughly, first distinguish between the two types of nibs. If your pen is a wrap-tip type – the kind where the nib is smaller, mostly wrapped in it, and the roots are almost rolled into a small metal tube – you can pull it out with a nail clipper gently holding the nib – note: not every nib can be pulled out like this, but most of the ones I've tried do.
If your fountain pen is an open-pointed type – that is, the one with a larger nib that is exposed, some of which can be pulled out with nail clippers, and some of which are fixed with screws – can be easily identified if you look closely.
Warm water is sucked into the fountain pen and rubbed at the hose of the fountain pen to remove the ink sediment attached to the hose.
If your pen is a tip type, you can also try this method, but this step requires a little trick: pinch the small plastic tube inside through the hose, then push the tip of the pen in the direction of the nib, and eject the tongue out to clean. This method is not suitable for all pens either, and if you are not sure or do not succeed the first time, it is best not to try again to avoid breaking the small plastic tube.
Remember to soak your new fountain pen in hot water before using it, as most nibs are coated with a layer of wax to protect the nibs at the factory.
After using the steel notes, you must cover the cap, otherwise the ink will settle on the nib after evaporation.
Try not to use carbon ink, because this ink has glue added to it, probably to allow the carbon particles to be better suspended, so it is also easier to clog the nib. If you want to change the ink, you should clean the pen first to avoid the reaction of different inks and precipitation.
-
Two reasons:1; The ink quality is not good.
2: The pen has not passed the national ISO quality certification.
-
Wash with warm water. Add a little vinegar.
Tried and tested. It doesn't work to find me.
-
Wash often with water.
-
The problem of ink quality.
Change some good ink ......
-
Use a brush, pencil, ballpoint pen.
-
Change a pen or take hot water to burn it.
-
If it is caused by the ink being left for too long and the concentration is too large, it is enough to replace it with a new ink. If the pen path is blocked, first squeeze out the ink in the pen bladder, shake it dry, remove the protective tube of the pen nib, pinch the pen nib with your hand, and turn it a few times, so that the paper hair or other dirt caught in the pen nib will be pushed out. Then, put the pen in warm water and continuously drain the water to clean it several times.
The water has changed color, so you can change it with clean water and wash it again. <
If it is caused by the ink being put for too long and the concentration is too large, replacing it with a new ink Bu Qingsheng will solve the problem.
If the pen path is blocked, first squeeze out the ink in the pen bladder, shake it dry, remove the protective tube of the pen nib, pinch the pen nib with your hand, and turn it a few times, so that the paper hair or other dirt caught in the pen nib will be pushed out. Next, put the pen in warm water and continuously absorb and drain the water to wash it several times. The water has changed color, so you can change it with clean water and wash it again.
Repeat it a few times, and the dirt in the pen can basically be cleaned out. Finally, the shape squeezes out the water in the pen bladder, spins it dry, pours ink and writes again, and the pen will be in the water normally.
-
When the pen is blocked, it will generally absorb water several times to clean the nib, and it can also discharge the ink residue in the ink tube, and finally absorb the ink to use!
-
If the case is blocked for a long time, you need to take the nib off. Prepare warm water and soak the nib and body directly in it for more than half an hour. Rinse the part of the pen with tap water.
Keep repeating the action of sucking the pen water and putting the pen water until the cleaning is completed. Short-term blockage, may be the tip of the pen gap blocked, with a thin wire, blade or piece of paper, poke can be dredged.
Short-term blockage, may be the tip of the pen gap blocked, with a thin wire, blade or piece of paper, poke can be dredged.
If it is clogged for a long time, you will need to remove the nib. Prepare warm water and soak the nib and body directly in it for more than half an hour. Rinse the part of the pen with tap water. Keep repeating the action of sucking the pen water and putting the pen water until the cleaning is completed.
How to care for your fountain pen:
1. Regular cleaning, normal use should be every three months (there are also every ten days and half a month, every month or so, etc.). Wash thoroughly once with warm water to keep the ink running smoothly.
2. In order to avoid the deterioration of the parts and ink of the fountain pen, the fountain pen should be placed in a cool place, not in a high temperature place.
3. Because the design of the tongue and nib is related to the composition of the ink, it is recommended to use the original ink, and avoid mixing the two inks (when changing the ink color, the original ink must be removed); Avoid using ink that is more than one year old.
4. When using, the cap should be put on the pen barrel, on the one hand, it can prevent the pen from rolling down, on the other hand, even if it falls, it will not be broken because of the light front and the weight of the pen; After use, you should cover the cap of the pen in time, even if it is only for a few minutes, so as to prevent the ink from drying and solidifying quickly in the pen, resulting in poor water flow - most of the pen blockage phenomenon is caused by this reason.
5. When writing, some manuscript paper should be padded under the paper to enhance the elasticity of the nib and reduce friction. Do not write on hard materials such as metal to prevent damage to the nib.
6. When the pen is not used for a long time (more than one month), it should be thoroughly cleaned and dried or wiped dry with warm water before collection, so as to avoid the ink drying and stagnation, and even causing corrosion damage.
-
Blocked for a short time, it may be that the gap between the nib of the pen is blocked, and it is okay to use a thin steel wire, a blade, or a piece of paper, just poke it.
It doesn't matter if it's blocked for a long time, the first thing to do is to remove the pen first.
I took off the nib of the fountain pen and wrapped it in toilet paper and pulled it out.
Then prepare warm water and soak the nib and body directly into it for more than half an hour.
-
It doesn't matter if the pen is blocked, you can take it apart by yourself, put it in clean water to clean it, and then wipe it dry and reinstall it, it will work as well as new.
-
If the pen is blocked, you can soak the tip of the pen in warm water, then use a fine-bristled toothbrush to clean the solids, and then pour ink into it to try to write normally. Fountain pens need to be cleaned regularly, about once a month or so, to keep the ink flowing. If you do not use the pen for a long time, you should clean it and store it.
Generally, when cleaning the fountain pen, you need to pull out the ink in the fountain pen, and then repeatedly absorb the water and drain it until the clean water is discharged, and then wipe it clean. If you want to keep the pen for a long time, you should take all parts of the pen apart and clean them separately. All parts are cleaned and wiped dry, and when they are completely dry, they can be sealed and sealed.
Of course, the structure of each fountain pen is different, not all fountain pens can be disassembled, for the pen that is difficult to disassemble, only one cleaning method can be used, that is, repeated pumping of water. It should be noted that the fountain pen should not be cleaned with boiling water or overheated water, otherwise it will cause damage to the fountain pen.
The ink inside the fountain pen contains a lot of carbon, and if it settles in it for a long time, it is easy to cause the pen habit to clog. The nib is also very fragile, and if you accidentally fall or poke it, it is easy to be unable to write, or write poorly.
-
If the pen is blocked, the following methods can be adopted;
1. Soaking in water for a day is the easiest way.
2. Find an ultrasonic cleaner, which is the one that washes glasses in the optical store.
3. From now on, there will be damage to the fountain pen, take the alcohol bubble, the solubility of alcohol to the ink is higher, but there will be potential damage to the skin.
4. Use a very fine blade or a hard piece of paper to open the gap of the pen tip, the gap is large, the water is natural and smooth, this operation is irreversible, and it will not come back if it is thick.
5. Disassemble and clean the capillary, that is, the parts inside the pen holding part, which is the core component of the pen, the high-grade pen is not easy to disassemble, the resistance pen is glued, and it will leak after dismantling and restoration.
-
Rinse with clean water and you're good to go.
First look at your house's sewer bar is metal or PVC (that is, plastic material), if it is metal, it is easy to say, directly use the electric dredging machine to open directly, if it is PVC, it will be troublesome, see if you find someone to dredge is not opened, it proves that it is very blocked inside, there should be a rag or a lot of hair inside, no matter what way, you have to find the gambling point first, you say that it is about meters can not be passed, it should be the inspection port of the main sewer pipeline downstairs of your house, you can go to the inspection port of the main sewer pipeline downstairs of your house to check, Dredging should also be dredged from **, as you said in this case, you can't directly channel the blockage from your home into the well, if the dredging is not open, there is only one way to cut it directly from the blockage, and it is good to recover, if you do not wrap the main sewer bar downstairs decoration, everything is easy to do, and you can judge the blockage point by knocking by hand. >>>More
Here are some of the well-known brands recognized in the valve industry, which are widely recognized and have a high reputation. While rankings may vary depending on time and market conditions, the following brands are generally considered to be among the top brands in the valve industry: >>>More
When you find that you and others have premonitory sha and mild sha, the first thing to do is to quickly evacuate the hot environment that causes heat stroke and choose a cool and ventilated place to rest; And drink plenty of salty cool drinks. You can also apply cool oil, wind oil essence, etc. to the forehead and temporal area, or take traditional Chinese medicine such as Rendan, ten drops of water, and Huoxiang Zhengqi water. If there is a decrease in blood pressure and collapse, you should lie down immediately and go to the hospital for intravenous saline infusion. >>>More
There are many reasons why you don't get fat, and in general, it can be attributed to two reasons: poor absorption and excessive consumption. >>>More
First of all, your contract is obviously unfair, and it is unfair to clearly stipulate the liability of Party B for breach of contract, and there is no corresponding liability for Party A's breach of contract. Legally it is a void contract or a contract whose validity is undetermined. >>>More