There is often no network connection, why does the network show no internet connection

Double-click on the local connection for the exclamation mark and then use the right to build a local connection and then click on the property.

Then click the protocol and enter a few digits randomly in the IP address.

Such as 130 140 3 4

Enter 255 255 255 0 in the address mask

Click OK again.

Set up the IP and you're good to go.

Hello kiss wifi shows no mutual luggage and volt network connection means that there is no wifi connection, and the phone cannot connect to wifi. The reasons why the mobile phone is connected to the wifi but there is no network are: 1. The wifi itself is a problem, and the wifi may not be connected normally, resulting in the inability to access the Internet.

2. Router problems, the router may be overheated or damaged. 3. Broadband arrears may lead to inability to access the Internet. 4. The wifi name contains Chinese, resulting in some mobile phones unable to connect to the Internet.

5. There may be a problem with the mobile phone system, which may cause the connection to wifi but the Internet cannot be accessed. You can solve the problem in the following ways1, please check whether the DHCP function is disabled in the router hall chain, and only after this function is enabled can the IP address be obtained correctly. 2. Check whether other devices can connect to the wireless network and rule out whether it is a router problem.

1. Check your phone's settings.

Open the mobile phone Quick Center (scroll down at the top or scroll up at the bottom) to see if the data network is turned on.

2. Confirm the status of the mobile phone card.

Make sure that the balance of the mobile phone card is sufficient, if the payment is in arrears, please restart the mobile phone after the recharge is successful. Check with your carrier to see if the data limit has been met or if the data network function is enabled. If necessary, you can change the SIM card that can access the Internet normally to confirm.

3. Check the mobile phone signal.

If your phone uses a metal, magnetic case or bracket that has an impact on your phone's signal, it is recommended to remove it and try it. If you are in an underground parking lot, elevator hall and other environments, the coverage of the mobile phone signal is susceptible to these environmental impacts, the signal will be relatively weak, and the data network will also be affected, so it is recommended to go to an open area, such as an outdoor open environment for testing.

4. Check the network permissions.

Go to Mobile Phone i-Manager - Traffic Management Traffic Monitoring - Network Management or Set Application and Permissions - Permission Management to check whether the application network permission has been enabled.

5. View the virtual private network.

Go to Settings - Other Networks and Connections - Virtual Private Network, check and confirm whether the virtual private network is used, and if so, it is recommended to turn off and try again.

6. Check the network settings.

Go to Phone Settings - Mobile Network (SIM Card Information & Settings - Corresponding SIM Card) - Access Point (APN) or Set Mobile Network Dual SIM & Mobile Network - Access Point (APN), and tap"Reset to the default settings"restart your phone.

7. Re-search the network.

Go to Settings > Other Networks & Connections, turn on"Airplane mode"After turning it off, please enter Settings - Mobile Network for 5G mobile phones, turn it off and turn it on"5G enabled"Options.

8. Reset the network settings.

Go to Settings - System Management - Backup & Reset - Reset Network Settings - Select the corresponding SIM card - Reset Settings, and then use View.

Note: Resetting network settings resets Wi-Fi, mobile data, and Bluetooth connection records.

9. Reset all settings.

Go to Settings - System Administration - Backup & Reset - Reset All Settings Go to Settings - More Settings - Backup & Reset - Reset All Settings and follow the on-screen prompts.

Note: Restoring all settings will not delete any data or ** files, only all settings of the phone will be restored, and some third-party application accounts need to be re-logged in to confirm that it does not affect the use of the software before operating. For the security of mobile phone data, it is recommended to back up mobile phone data in advance before operation.

If you are using a Huawei phone.

If you can connect to Wi-Fi but can't access the Internet, you can use the following methods to troubleshoot:

1. If you are using a home network, it is recommended to connect to other WiFi or mobile phone personal hotspots for testing and troubleshooting

1.If connected to other wifi is normal.

1) Please do not stay away from the router;

2) Please check whether the broadband account expires, restart the router and restart the phone before trying;

3) If the router has been set to the blacklist and whitelist, you need to check whether the MAC address of the mobile phone is added to the router, if the router does not set the blacklist and whitelist, please power off the router and restart the attempt.

2.If you connect to other wifi, you can't get online.

1) Please turn the WLAN switch back on and try to connect;

Follow the on-screen prompts to restore. (Note: This restores the Wi-Fi, mobile data, and Bluetooth connection records and deletes the Wi-Fi and Bluetooth connection records).

2. If you are using a public network:

1.Try using it in a place with a small amount and confirm that the hotspot is working properly.

2.Please check if you need to log in through a browser** to register before you can access the Internet.

3. If individual applications are not available online:

Enter Traffic Management and click to enter the Traffic Management page, click Application Networking, and check whether the WLAN permissions are checked for individual applications, and it is recommended to check all the WLAN permissions that need to be used for applications.

If the above methods do not resolve the issue, we recommend that you back up your data.

Boarding service. Huawei Customer Service Center.

Repair spare parts** inquiry.

It is detected that this wireless router is not connected to the internet. You can wait for a few seconds, and if you are not connected to the Internet, you will have to check if the wireless router really has no network.

Thank you for your question.

Network shows no internet connection reason:

1. Broadband arrears.

Broadband arrears need to be paid in time, and the network operator forcibly shut down, and only needs to pay a certain fee to resume normal Internet access. (as shown in the image below).

2. Mobile phone system problems.

There may be a problem with the mobile phone system, which may have a problem with the greenhouse system, resulting in a connection to the wifi but unable to access the Internet. You can try restarting your phone. (as shown in the image below).

3. Router failure.

If the router or other device is faulty, check the router and the optical modem. You can choose to have a network repairer come to your home to help you find out why you can't access the Internet. (as shown in the image below).

4. Network cable failure.

If the network cable is loose and the contact is poor, you can choose to strengthen the network cable, and if necessary, you can unplug the network cable and plug it in again to solve the problem. (as shown in the image below).

5. WiFi failure.

The wifi name contains Chinese, and Tonghong caused some mobile phones in the bureau to be unable to connect to the Internet; It is recommended to change it to English or a combination of English and numbers before connecting. (as shown in the image below).

Summary. 1. First of all, call the operator to ask if the cost is not enough. 2 .

Once the router crashes, you won't be able to access the internet. In this case, the router must be shut down and restarted, and then reconnected to the network. 3. When the crystal head is oxidized or damaged, pull out the crystal head to confirm whether the metal point is oxidized.

If there is oxidation or damage, replace the network cable with a new one as soon as possible. 4. The setting parameters of the router are incorrect. If the router is set up incorrectly, it will not be able to connect to the internet.

The router must be reset based on the username and password provided by the host where it is installed. Enter the correct username and password. 5. The terminal of the outdoor junction box falls off or is short-circuited due to rain.

If you encounter this problem, you should notify the person in charge of your area to deal with it. Or feedback to the service station.

Why is my internet connected? But there is no way to get on.

Why is my internet connected? But can't get online?

1. First of all, call the operator to ask if the cost is not enough. 2 .After the router crashes, there will be no messy way to access the Internet.

In this case, the router must be shut down and restarted, and then reconnected to the network. 3. When the crystal head is oxidized or damaged, pull out the crystal head to confirm whether the metal point is oxidized. If there is oxidation or damage, replace the network cable with a new one as soon as possible.

4. The setting parameters of the router are incorrect. If your router is set up incorrectly, you won't be able to connect to the internet. The router must be reset based on the username and password provided by the host where it is installed.

Enter the correct username and password. 5. The terminal of the outdoor junction box falls off or is short-circuited due to rain. If you encounter this problem, you should notify the person in charge of your area to deal with it.

Or feedback to the service station.