How to Repair the Damaged Part of the Physical Track of a Hard Drive Is it possible to repair it wit

If it's physical damage, it can only be repaired with software (the so-called repair, just skip the bad part and don't use it), there are actually a lot of this kind of software, depending on which one is used to use, I use it called gendisk, you may need to use DOS knowledge, if you can, you can search it from the Internet**Try it.

Real physical damage is not repaired. The hard disk is a disk, and the strength of the signal depends on the strength of the Li Bo magnetic recording. When the magnetic recording intensity decays to a certain extent, it will be detected as a bad sector, but some software can strengthen the local signal strength by repeated erasing and writing to achieve the purpose of repair.

MHDD, for example, is such a principle.

But minor physical damage can be repaired temporarily, and only temporarily. It's still going to be bad after a long time. Therefore, it is impossible to repair the real physical damage. It can only be delayed.

Bad sectors can be repaired by CHKDSK Disk Repair Tool.

The specific steps are as follows:

1. Click the start menu in the lower left corner of the computer and find Run.

2. Click Run, you can see the running interface.

3. Enter cmd in the run box to open the administrator interface.

4. When opening the administrator interface, first confirm the drive letter displayed on the computer, and you can see the display disk in the computer: g

5. Then go to the management interface and enter **:chkdskg: f.

6. Press Enter to confirm, and the bad sector will be fixed.

Can the physical damage be repaired.

General mechanical hard disk damage can be divided into physical damage and internal data damage, such as physical damage can be repaired by manufacturers or professional personnel, if some circuit damage is repaired by professionals, it can generally be used, but if the damage is too serious, it may not be repaired.

HDDs may also be subject to data loss due to accidental deletion of partitions, viruses or formatting, etc., in this case, users can use third-party data recovery software to recover HDDs, provided that no new data is written to HDD.

HDDs may also fail due to system errors that cause the hard disk allocation table or disk partition to fail, in this case, if there is no important data in the hard disk, you can try to restore it by formatting or repair it through the system's built-in repair function.

Fix:

1. Check whether the mechanical hard disk has bad sectors.

First of all, use the HDTune software to check whether there are bad sectors in the hard disk, drop down to select the hard disk you want to check, select the error scanning function, check the quick scan, click to start scanning the old hard disk, if the hard disk has bad sectors, it will be displayed in red.

2. Enter the operation interface of the hard disk management tool.

Open the DiskGenius hard disk management tool, right-click on the faulty hard drive, pop up the hard disk function menu, and select the hard disk bad sectors and repair function.

3. Enter the hard disk bad sector scanning and repair interface.

According to the capacity of the hard disk, the general 500G hard disk takes 2 to 3 hours to complete the scanning, and the bad sectors will be displayed in red after the scanning is completed, and then click to try to repair, and start to repair the bad sectors of the hard disk, according to the number of bad sectors, the repair time is different.

A physically damaged hard drive cannot be repaired.

Physical damage to a hard drive is a permanent one that cannot be repaired, and if no action is taken, the physical bad sectors will continue, resulting in data corruption.

If the physical object is damaged but cannot be repaired but can be shielded, the location of the bad track can be detected and the location of the bad track is avoided by the partition method to reduce the extension of the bad track, so as to reduce the loss.

Hard disk is one of the main storage media of a computer, consisting of one or more aluminum or glass discs. The disc is covered with a ferromagnetic material. Hard disks have solid-state hard slag disks, mechanical hard disks, and hybrid hard disks, solid-state hard disks use flash memory particles to store, mechanical hard disks use magnetic disks to store, and hybrid hard disks use magnetic hard disks and flash memory.