What should I do if the back cover of the watch does not buckle in?

The reason why the back cover of the watch cannot be attached is because the back cover of the watch is a product with a more accurate shell processing. It's not easy to pry it open by hand and then press it back.

The specific solution can be to close the back cover of the watch with a rolling pin, see if there is a rolling pin at home, and then find an old book, or put a piece of paper about 1cm under the book to prevent the watch mirror from being scratched. Then press the back cover left and right with a rolling pin, repeatedly exert force, pay attention to the use of skilled strength, try a few more times, and you're good to go.

Extended Information: Precautions for Watch Maintenance:

1.Do not use the watch (including waterproof watches) in hot baths, saunas, or environments with large temperature changes.

2.Do not operate the pushers and adjust the crown in water.

3.Please clean the strap and case regularly; If it is a leather strap, avoid contact with moisture, moisture, makeup, and sun exposure.

4.Pay attention to the anti-magnetic nature of your watch and avoid prolonged contact with electrical appliances, mobile phones, and magnets.

5.Do not disassemble the watch under any circumstances.

This kind of back cover is pressed up by a special machine, and the average person has so much strength in wood.

If you are not afraid of breaking it, you can find a cap with a diameter slightly larger than the dial glass, fasten it to the dial glass, wrap it in a fixed position with tape, and then stuff the watch into a drawer, then stuff it into a wooden rod, and press the back cover into it with a lever principle.

It's best to go to the watch repair shop to get it, just press the back cover, it won't cost much.

Watch maintenance and repair can refer to the service center of 702] Joy City Office Building, Xidan District, Xicheng District, Beijing to provide Swiss watch strap customization, cleaning and maintenance, identification, refurbishment, fault repair, watch appearance and replacement of damaged parts, and strap replacement services. Our technicians have undergone strict professional skills training and provide two years of after-sales guarantee services. The service center is guided by the watch manufacturer on the spot**, **transparent, no hidden consumption, no additional charges.

How to replace the buckle: Many watch wearers buy a new buckle after the watch buckle is broken, and want to replace it by themselves, but for those who have no practical experience and do not understand the watch structure, there will be many problems when disassembling and reinstalling the buckle, causing unnecessary trouble. The material of the buckle is also different, if the purchased model is different, the material is not good, the closing strength is poor, easy to deform, etc., it is likely to cause the watch to be lost and dropped; The clasp closure and switch technique used is not good and inconvenient, and it will easily damage the strap.

What to do if the buckle is broken: The watch buckle may be broken and the small tongue falls off, so you don't need to replace the strap, you only need to replace the buckle. Replacing the buckle needs to be carried out by a professional and regular watch repair organization, which can not only ensure the quality of the buckle, but also change to the original model, and there are more kinds of buckles to choose from.

The solution to the problem that the back cover of the watch cannot be buckled after changing the battery is as follows:

The back cover is aligned, and the general press type is the notch alignment needle shaft. The glass side is side down, and it is best to pad two layers of towels. Roll out the dough dry and roll it out vigorously, and you can hear a click.

If there is a bump on the back, it is screwed. If it is smooth, it is pressed, and if it is smooth, there is no bump or convex, but with a thin circle, it is also used to turn.

The lid is snapped, that is, the lid is pressed into the case with pressure. If there is a notch on the edge of the inside of the cover, the notch should be aligned with the handlebar. Sit on a stool with the dial facing down, hold the strap with the four fingers of your left and right hands, your index finger under the watch axis, press your thumb on both sides of the cover, not in the middle, put your hand on your thigh, and press down with the strength of your arms to press the cover back into place.

Precautions for watch maintenance:

1. Do not use watches (including waterproof watches) in hot baths, saunas or environments with large temperature changes.

2. Do not operate the buttons and adjust the crown in water.

3. Please clean the strap and case regularly; In the case of a genuine leather strap, avoid contact with moisture, moisture, and makeup, and avoid exposure to sunlight.

4. Please pay attention to the anti-magnetic properties of the watch, and avoid long-term contact with electrical appliances, mobile phones and magnets.

5. Do not disassemble the watch under any circumstances.