-
Anonymous users2024-02-06Mine is also a problem with you.
-
Anonymous users2024-02-051. Memory card.
Fault. Dash cam.
If the memory card is faulty, it is also easy to cause the return of the dash cam to automatically switch on, you can format the memory card or replace it with a new memory card.
2. The power supply is loose. Many dash cams are installed in the car power supply, if the connected power supply is loose, it will also make the dash cam because the battery can not last for a long time, there will be an automatic shutdown.
3. Automatic power on and off function. If the dash cam turns on the function of automatic power on/off, it will turn on and off the machine due to the reason that the car is turned off, and the function of automatic power on or automatic shutdown can be turned off. The dash cam is turned on for a few seconds and turned off, usually because the battery of the dash cam is out of power, you can replace the new battery to try it, if you rule out the reason for the lack of battery power can not be used, it may be a memory card failure, or it may be a loose power problem, or a software failure, it is best to go to a professional repair shop for maintenance or replacement.
If the dash cam is connected to a car power source, such as a cigarette lighter.
If the recorder is powered on and cannot be turned on, it may be that the voltage is too low and the power can not be turned on, or it may be that the power interface is loose, or the line is damaged and broken.
In addition, the power supply circuit on the dash cam motherboard is open and cannot be supplied normally, resulting in no power start. Check the motherboard for component soldering. If there is a virtual solder joint, repair welding is fine; If you can't find the virtual welding, you can only use a multimeter.
Measure each component in the order in which it is supplied to the normal supply voltage, and then replace the damaged component.
-
Anonymous users2024-02-04The dash cam turns off after a few seconds of booting, this is caused by the battery of the dash cam being dead, and the specific repair and defense methods are as follows:
1. First of all, place the driving record correction pure recorder on the desktop
2. Then open the lid, and you can see the pants hunger battery in it:
3. Then you can take out the battery:
4. Next, put the new battery in:
5. Finally, the dash cam can be used normally
-
Anonymous users2024-02-03Check if the internal battery is low.
-
Anonymous users2024-02-02What's the deal with the dash cam that automatically shuts down after it is turned on? What's the deal with the dash cam that automatically shuts down after it is turned on? The dash cam shuts down after a few seconds, usually because the dash cam battery is dead.
You can try getting a new battery. If you rule out that the battery is unusable after running out of power, it could be a memory card failure, a loose power supply, or a software failure. It is best to go to a professional repair shop for repair or replacement.
If the dash cam is connected to the car power supply, such as a cigarette lighter, battery, fuse box, etc., if the recorder is powered on, it may not be powered on because of low voltage, or it may be caused by a loose power interface or a circuit break. In addition, the power circuit on the dash cam motherboard has an open circuit, which cannot be powered normally, resulting in failure to start. Check the components on the motherboard for virtual soldering.
If there is a virtual solder joint, repair welding is sufficient; If you can't find the virtual welding, you can only use a multimeter to measure whether each component has a normal power supply voltage in the power supply order, and then replace the damaged parts. @2019
-
Anonymous users2024-02-01The recorder will be turned off after a few seconds of booting, this is because the battery of the dash cam is dead, and the specific repair methods are as follows:
1. First place the dash cam on the desktop:
2. Then open the lid and you can see the battery in it:
3. Then you can take out the Yinqing battery
4. Next, put the new battery in:
5. Finally, the dash cam can be used normally
-
Anonymous users2024-01-31The dash cam shuts down after it is turned on, which may be a failure of the memory card, no power in the power search side pool, or a loose power supply; It can also be caused by software failure or system stuckness.
1. The dash cam memory card is faulty, due to the use of a long time, the memory card is prone to problems after repeated non-stop rubbing of the stove, if this happens, it is generally necessary to format the memory card on the computer, if it is a newly configured memory card, it may be a card incompatibility problem.
2. The problem of loose power supply, especially the use of a cigarette lighter with a tow n, will often be loose, after the power is loose, the recorder will automatically use the battery that comes with the recorder, and the battery that comes with the general recorder does not take long at all, so there will be a situation where it is obviously turned on, and when the hidden leakage calendar is looked at again, there will be a shutdown.
3. The problem of the cigarette lighter fuse, if it is directly from the cigarette lighter, and the interface is also loose, it may be the problem of the cigarette lighter fuse, in this case, it is necessary to consider replacing the power method, which can be added from the top light lead wire.
Photo by Ling Xiufang) @2019
-
Anonymous users2024-01-30There are many reasons for this situation, it may be that the power supply connector is loose, the power supply connector is not well connected to the code stool, the battery is late to finish, and the system crashes and cannot be turned on. After this happens, you should check the power supply interface to confirm that there is no problem, and then try to upgrade the system. If it still can't be solved, it is recommended to find the manufacturer's after-sales service department for warranty.
Dash cam is a very common thing in the car, and many car owners will buy a dash cam to install on their car after buying a car. Some cars are equipped with the original dash cam when they leave the factory.
The dash cam can be recorded during the drive, and if there is a dispute, the video in the dash cam can be used as evidence to provide to the traffic police, so that it can help you protect your legitimate rights and interests at a critical moment.
Dash cams rely on the 12V power interface and cigarette lighter interface on the car to supply power, and these two interfaces are prone to loose problems.
If the 12V power connector and cigarette lighter connector are loose, the power supply plug of the dash cam will be loose, which will lead to poor contact.
If the 12V power interface and cigarette lighter interface are loose, you can go to a 4S shop or repair shop to adjust it.
Some dash cams have built-in lithium batteries, and the recorders with built-in batteries can continue to work for a period of time after the power is turned off.
The dash cam is not recorded, but if the tachograph with parking monitoring is installed, even when the vehicle is turned off, the dash cam shuts down after knowing that it moves, once the body is collided or detects that there is an object moving in front of it, it will immediately wake up the parking monitoring function and record the surrounding picture. In this case, even if you are not driving, the dash cam may have a ** record. A dash cam is an instrument that records the image and sound of the vehicle while driving.
Let me tell you, first unpack the package, right, then disassemble the parts you want, first remove the rubber sealing strip of the passenger door, when disassembling the A-pillar trim panel, if the vehicle has a round fixed cover, use a screwdriver to unscrew the internal screws, and then pull and disassemble the A-pillar trim panel on the passenger side with both hands, then use a screwdriver to disassemble the B-pillar trim panel, leaving a little gap between the roof and the B-pillar trim panel, and then connect the front and rear cables to the front lens, Place the alignment between the windshield and the ceiling by hand, install the rear camera above the rear glass**, tuck the wires all the way into the C-pillar trim panel, and use insulating tape to sort out the remaining rear wires.
The role of the dash cam.
1. Safeguard the legitimate rights and interests of the driver, often walk on the road, how can you not scratch, for many people who cross the highway and bicycles, motorcycles on the road, in case of scratching with them, it is likely to be extorted, if you have a dash cam, the driver can provide effective evidence for himself. Many traffic accidents are caused by violations, and after installing this product, the scene before and after the accident can be clearly reproduced 20 seconds before and after the accident, and the behavior of creating fake scenes to defraud insurance can be completely eliminated. >>>More
Generally, the loop recording time is 3 minutes, 5 minutes, 10 minutes, it is best to set 5 minutes, which is convenient for later search, and in addition, in case of special circumstances, the lockable clip will not be covered by the loop recording, and the best evidence can be completely retained, so be sure to set the time clip. Hope, thank you.
It's fine via Bluetooth.