Find programming and maintenance data for Panasonic mV2f. 20

Pull the sensor off the short circuit to see if it will be reported, and check how the position of the laser is adjusted, try to shake the relevant bit elimination source to see if the sensor will flash, and whether your split car is K type or Q type, if it is Q type, consider the problem of machine jitter. 1.Check the fiber optic circuit.

2.Replace the light mold. 3.

Replace the SC card.

I can send you relevant information.

Panasonic MV2F How to do Yin Yang Bench: 2006-05-03 12:33

You can make 1 piece and 2 pieces. When expanding the board, you click on the first block separately and then click to copy the distance of input x, and then you have the third block, and then click on the second block separately and then click to copy the distance of input x, and then you have the fourth block! This makes it much easier for you to jump over the x-board.

At-Large Member of Penjm.

Newspaper: 2006-05-03 14:15

Write the yin-yang board program in Fuji Flex.

If we need to write a yin-yin board program in Fujiflex (taking the quadruple panel as an example, if our PCB board 1 and 3 are the top BOT surface), the steps are as follows:

1) First of all, we choose a production line and guide the CAD data of the top surface to Fujiflex, if this production line has three machines CPA, CPB, QP; In general, there are fewer TOP surface components, and there are more chip components, so we can assign all the components on the TQP plane to CPA. (Note: If there are larger components we can achieve by changing the way of nozzle, vision(lighting), feedertype, in order to avoid the trouble of re-modifying the pd, we can export all the pds to somewhere in advance) generate the program, save it as aaa, and then export the pgo file.

2) We use the same method as above to import the CAD data of the BOT surface to Fujiflex, (if we select the same production line as above, assign the components of the BOT surface to CPB and QP), generate the program, save it as BBB, and then export the PGO file.

3) Create a new job, select the corresponding production line, guide the pgo file exported above to this job, and guide the pd exported in advance, balance the production line, optimize, and generate the program.

As long as we understand the true meaning of the Yin-Yang board programming method, we can flexibly apply it in the Fuji production line.

What is a yin-yang board; It is what we usually see in a panel with both top and bot sides on the same side. This is shown in Figure 1. We will only give a brief introduction to the programming under normal circumstances, and we will focus on the writing of the yin-yang board program below.

(1-10%)x5%+10%= (1-10%)*5%+10%= shabi The original price is regarded as a unit early trace1 1-10% after the first price reduction After the second late opening of the cash back (1-10%)*1-5%) The percentage of the price reduction code is: (1-10%)*1-5%) 1*100%= (1-..