How to use and maintain a fishing rod to have a long service life?

The length of the rod's service life has a lot to do with the usual use and maintenance. When using a pull-out fishing rod, the thick end of the rod should be tilted upwards to let the rod tip slide out automatically, and then the thick end should be pulled down after grasping the rod tip, and pull out one section at a time in order, and the joint should be tightened to prevent the rod node from slipping in the opposite direction. When fishing, the hook may be caught by the obstacles at the bottom of the water and cannot be pulled, at this time the angler should calm down, do not pull hard, change the direction and angle of the rod, relax the fishing line, and then try to lift the rod gently.

When catching a big fish, do not lift the rod violently, and use the strength of your wrist to lift the rod upwards to avoid the rod from breaking due to excessive force in an instant.

1) Lifting the rod feels like a big fish, don't rush to reel in the rod, first open all the rods and start fishing. Pull the fish to the water's edge and scoop it up with a net; If the fish is less than half a catty, you can fly the fish directly to the shore. If it is more than half a catty, do not fly directly to the shore, because it is easy to break the rod if it is not handled well at this time.

If the fish weighing more than half a catty is placed upright, it is likely to damage the tip of the rod or the second section of the fishing rod. (2) Every time you go fishing with a trillion, clean the fishing rod when you get home. (Because there is often some dust and fine sand at the water's edge, etc.)

Wipe off the water with a soft cloth and carefully put it away after drying. Even if you don't want to wash it, you can leave it in a ventilated place to dry the water. It is not advisable to block the pole for a long time so that the water cannot be distributed.

If you fish in the creek, it is actually quite difficult because of the quality of all aspects.

If you don't pay attention to cleaning up, over time, the rod wall will inevitably be scratched, leaving scratches of different shades, which will seriously lead to the paint layer falling off, the carbon cloth is broken, and the positive mask is often used; After fishing, the rod is dried and ruined, and the reed is wet, the weather is hot in summer, if the water is not dried, it is easy to cause the paint layer to bubble and fall off, and it will also affect the service life of the rod for a long time. Whether it's mud or moisture, it's recommended to rinse the rod with clean water after fishing, then dry the surface moisture, dry it in a ventilated place, and then put it away.

If you do not pay attention to cleaning, in the long run, the inner wall of the rod will be scratched, leaving scratches of different shades, which is more serious and causes the paint film to fall off, and the carbon cloth is broken, which endangers the normal use; After fishing, wipe the water with the rod, in the summer high temperature weather, if the water is not wiped, it is very easy to cause the paint film bubbles, fall off, and the service life of the fishing rod will be endangered for a long time. Whether it's soil or moisture, the best way is to clean the rod in cold water after fishing, then wipe the surface moisture, let it dry in natural ventilation, and then put it away.

Hanging bottom broken rod often happens, the key is to teach you how to hang the bottom how to do, there are special tools to rely on special tools, and there are no special tools to do this, hook the aquatic weeds, you can hold the fishing rod with both hands and pull it back, and the rod line is in a straight line; Hang up other hard obstacles, be able to lift the rod and then learn to put it down, repeat it a few times, if you can't solve it the same as above or drag it to other directions; If you are worried about damaging the drift, you can wrap the line around the rod and pull it harder. Hanging the bottom will not produce a broken rod, why are so many people broken? Remember a little, don't be in a hurry to hang the bottom, and avoid shaking the rod hard.

Beginner fishing enthusiasts in the fish after more panic do not know what to do, the general fish after pulling back, both ignore the bearing capacity of the fishing group, but also ignore the fishing rod weight, if you meet a slightly larger fish, make the force stronger, it is very easy to break the line and break the rod. If the fish is not very big, you can maintain a posture, if it is not necessary, you don't have to walk the fish casually, if the fish is very large, you can follow the fish up and down, but you need to be careful not to let the bird turn around or not move.

Before joining the winter, many people seal the rod, and the damage to the rod through a summer and an autumn is very large, basically like that, so why not make one for your rod on the day of the rod"Maintenance"In fact, it is also very simple, after cleaning the fishing rod, scrub it neatly with a soft cotton cloth, and after the water volatilizes sufficiently, then change a piece of cotton cloth and pour some rod oil to gently scrub it evenly, and then put it in the corner for storage.

Here's how to maintain your fishing rod:

When you are out fishing, the water quality and environment are complex, and the weather is changeable. When we use the hand rod for fishing, we need to draw the rod and cast the rod frequently, and after a long time, it is inevitable that there will be scratches on the paint, and there will be blisters in serious cases. These problems are caused by the improper use of our fishing rods, which greatly reduces the service life of the fishing rod.

When we fish, we must pay attention to the rod handled with care, not in sandy and dirty water. The key is that the maintenance of the rod at home is also crucial. Here are two ways to maintain your fishing rod when fishing in two weathers!

If the temperature is high on the day of fishing, the rod is exposed to the sun for a day, the rod is slightly into the water when fishing, and the water vapor will be formed in the rod body, and the rod will be suffocated and lose its elasticity over time, and the probability of breaking the rod will be greatly improved.

Maintenance method Pi Jing:

First, pull out each section of the fishing rod, hold the jujube and tie the fishing line with a small towel to wipe the water in the rod.

Wipe the surface of the rod with a towel soaked in hot water and keep the rod dry!

Finally, apply the rod oil to the towel and wipe the rod evenly to increase the waterproofness of the rod. Then just put the rod in a cool and ventilated place (remember not to expose it to the sun)!

If you are fishing in rainy weather, the rod will inevitably be caught in the rain, and it will be more difficult to cast the rod because of the water. All we need to do is wipe the water off the surface of the rod when we finish fishing, and when we get home, we pull out each section of the rod to dry. If you find that there is still water and impurities left, wipe it again, and at the same time, you can also apply a layer of rod oil or rod wax to the fishing rod, and put it in a cool place.

1. Generally speaking, the best fishing rod will generally have a relevant introduction to the use of the subline, especially after the subsequent purchase of the fishing rod, it is necessary to carefully configure the subline according to the requirements in the manual. This ensures that the strength of the line matches the tension of the rod to a large extent, and even if the rod is suddenly caught by the hook, it will not break easily.

2. After the usual fishing activities, don't forget to prepare a delicate and soft towel, and then gently wipe the rod body to ensure that the rod is dry and free of moisture. At the same time, it can also cleverly avoid mud and sand pouring into the inner wall of the rod, which is easier and more convenient when retracting and jointing.

3. When using the fishing rod, you should also pay attention to the point, many people will quickly lift the fishing rod after finding that the fish is hooked, in fact, it is easy to cause the rod to break. In order to enhance the durability of the fishing rod, anglers can walk the fish first, and when the physical strength of the fish is almost consumed, they can gradually increase the intensity along the direction of the fish's escape, so as to disperse the force on the rod and quietly strengthen the durability of the rod.

4. When it comes to the maintenance of fishing rods, there are actually different ways in different seasons, such as in the cold winter, if the carbon fishing rod is not used for a long time, it should be carefully wiped clean and put in the original box, and stored in a room with a stable temperature. If you don't have the original box, you can put the rod in a special sleeve and put it upright in the house, not anywhere. At this time, anglers can take out the rod to wipe and wax, and then put it back in the box.

1. The fishing rod will be wet after using it in rainy days, although the rod has been wiped again, but after going home and withdrawing, the inside and outside of the pipe wall are still wet, if not treated, for a long time, not only the beautiful paint will fall off when it is serious, but also the bubbles on the fishing rod, commonly known as "stuffy bubbles", and there will also be gaps in the carbon cloth layer, thereby reducing the service life of the fishing rod and causing irreparable damage. Solution: Tools Required:

Fishing rod protective oil, special wax cloth, a piece of flannel, a section of velvet rope Be sure to wipe each section of the fishing rod with a dry cloth, and then arrange it in a ventilated place to dry overnight. After drying, tie a strip of cloth in the middle of a thread longer than the rod. Evenly coat the cloth strip with fishing rod protective oil Remember that the cloth strip is not too large, it must be able to pass through the inside of the pipe wall, and each section is repeatedly passed through several times, which not only cleans the stains in the pipe wall but also maintains the fishing rod.

Because the first two sections of the rod are too thin, this treatment can be omitted, and it can be placed in a ventilated place to dry. Then the fishing rod is repeatedly wiped out with a fishing rod protective wax cloth 2. The fishing rod is exposed to the sun for a day on a sunny day, and the natural moisture in the rod is consumed a lot. Maintenance method After fishing, go home, take out the fishing rod with the knots, and gently wipe the fishing rod back and forth with warm wipes (called hydration).

This will both hydrate the rod and remove stains from the rod and leave it to dry in a ventilated place for 20 minutes. Apply a special protective oil with a wax cloth on a fishing rod and apply it repeatedly with your fingers to apply the protective oil evenly. Wrap the rod and wipe it gently, and finally place the rod in a ventilated place to dry naturally, and assemble it the day before use.

In addition, the fishing rod should also be regularly maintained with protective oil, not only the fishing rod is good to hold up when in use, but also the service life will be greatly extended.

Today I will share with you a fishing tutorial, the use of fishing rods, effectively prevent violent death and breakage! I hope it can help fishing friends.