What happens if the router restarts and can t connect to the Internet

It may be that the button on the back of the router was accidentally touched when the router was turned off, causing the wireless signal parameters to be cleared. Solution: 1. Click "Network" to find the router, enter the routing login panel, and log in to the router.

2. Find "Network Parameters" on the left side of the router settings, reset the "Network Parameters", and restart the router. 3. After the setting is completed, search for the wireless signal again, connect the wireless network, and check the network connection. 4. In this way, the network has been connected normally.

Don't use the router to dial in directly to see if you can access the Internet normally? Then connect the router correctly and enter the settings interface to see if there are numbers in the WAN port status in the running state, such as the IP address, subnet mask, and default gateway, if not, it means that you have not set it successfully.

A router is an electronic device that we use very often in our daily life, and it can help us achieve the connection of our home network. However, sometimes we encounter some problems when using the router, such as not being able to connect to the Internet after the router restarts. So, how to solve the problem of Shuhuqin?

First of all, we need to check if the power supply and network cable of the router are connected properly. If you find that the power supply or network cable is loose or damaged, you need to plug it in again or replace it. If the connection is fine, we can try the following methods next:

1.Restart the router: Sometimes there will be some problems with the router's system, resulting in the inability to connect to the network, at this time we can try to restart the router.

The way to reboot your router is to unplug it, wait a few minutes before plugging it back in, and wait for the router to restart.

2.Check your router's settings: Sometimes some of your router's settings may affect your network's connection. We can check if the settings of the router are correct through the router's management interface. If you find that the settings are incorrect, you need to adjust them accordingly.

3.Change the location of your router: Sometimes the signal of your router is affected by your surroundings and you can't connect to the network. At this time, we can try to change the location of the router to make the router signal more stable.

4.Check the network status of the network service provider: If the above methods do not solve the problem, then the network of the network service provider may be faulty.

In short, when the router is not connected to the Internet after restarting, we should first check whether the power supply and network cable of the router are connected normally, and then try to restart the router, check the router settings, change the location of the router, and check the network status of the network service provider. Through these methods, we can solve the problem that the router cannot connect to the network and ensure the smooth operation of the home network.

Sometimes, our router will be reset, but after we reset it, at least we find that the phone can't connect to the Internet.

Mobile: Huawei P30

System: EMUI

Software: QQ Browser.

<>5. Let's change [LAN IP] and [Preferred DNS] here, so that it does not conflict with the address of the optical modem, and it is generally changed to [or changed to [It is also okay, as shown in the figure.

<>7. Make sure that the Internet access method is [dynamic IP], so it's OK, just restart the router.

1. Open the webpage Or, press the reset button on the back of the router for more than five seconds to reset the login password, and it is best to set it up simple and not easy to forget. Then log in.

2. Then click the Setup Wizard on the left, click Next, choose to let the router automatically select the Internet access method, and then proceed to the next step.

3. It will take a few seconds to detect the network environment, then fill in your username and password, be sure to fill in the correct one, and click Next.

4. Enable the wireless function, click the encryption method to set a password, preferably set a combination of letters and numbers.

5. Finally, click the next step and click Save to complete.

6. If the computer and equipment still can't connect to the Internet after setting, just restart the computer.