How to keep the mobile phone film from foaming, and how to deal with the bubbles in the mobile phone

It's actually very simple that the phone film doesn't blister. First of all, wipe the surface of the phone with a cloth to ensure that no impurities remain on the surface of the phone; Secondly, the outer film marked with the first step on the mobile phone film is uncovered with a small corner to expose the middle film; Again, paste the exposed mobile phone film to the corresponding corner, and slowly remove the outer film, so that the two sides and the edge of the mobile phone are kept horizontal, and after confirming that the mobile phone film is not crooked, you can remove the outer film, in this process, press the film with the corner of the film, and then stroke to the opposite corner and both sides; Finally, if it goes well, there are no bubbles at this time, if it doesn't go well, there will be some small bubbles at this time, just use your fingers to drive the bubbles outward.

Things to note: First, the mobile phone screen should be wiped clean; Second, if the film is found to be improper in the process of filming, it should be corrected in time, and the small corner of the paste can be uncovered and re-pasted, but do not touch the mobile phone screen and the film fitting surface with your hands or impurities, which will make the impurities adhere to the mobile phone film; Third, do not cut the bubbles with your fingernails, which will not drive out the bubbles and will also deform the film.

1. When sticking the film, first clean the mobile phone screen, you can use a wiping cloth and dust removal sticker to clean the stubborn dirt on the edge of the mobile phone and other parts, there is a protective film on both sides of the film, and the side with the date is facing up, there is no stickiness; The side without the date faces the screen and is sticky;

2. Use auxiliary tools to cut a small part of the vacuum film, paste it on the side without the date, and paste it by the edge, leaving a small section for easy removal;

3. Wipe the screen clean, tear off the side with the dust suction film, stick the protective film on the screen, press lightly, and squeeze out the bubbles;

4. Tear off the protective film with the date side, and the protective film will be pasted.

In order to protect the mobile phone screen, now everyone is a mobile phone film, in order to save money, a lot of their own paste, but the hand remnants of their own stickers are not often crooked or have bubbles, so how to deal with the mobile phone film after there are bubbles?

1. Blow with a hair dryer: It is to use the heat of the hair dryer to soften the tempered film, blow the bubbles with hot air for a period of time, and then press and hold the bubbles for a period of time, repeatedly, so that the tempered film is easier to fit the mobile phone screen.

2. Use a clip: Find a clip with a relatively large clamping force, before going to bed at night, clamp the bubbles at the edge of the mobile phone screen, clip it overnight, and get up the next morning, surprised to find that the bubbles have disappeared!

3. Use lubricating liquid or liquid glue: use a small amount of liquid on a toothpick and other objects, gently open the edge bubbles, and force the liquid to flow slowly into the bubbles, so that the liquid fills the gap between the screen and the tempered film. Don't forget to press the bubble during this time, this method is very good, and it won't hurt your phone much.

But the technical content is a bit demanding.

The above is an introduction to the method of "how to deal with bubbles in the mobile phone film", if you paste the bubbles in the mobile phone film yourself, you can deal with it according to the above methods.