What should I do if the hands of a Longines watch fall off during wear?

1. It is more common for the watch needle to fall. If the watch is hit violently, the watch hands may fall off. If the watch hand is lost, it is recommended to stop the watch immediately to avoid the watch moving and letting the hands scratch the dial 2, The watch hands fall off:

When the watch is subjected to severe vibrations, the hands may fall off, especially the second hand. If the second hand (including the small seconds or other hands) has fallen off and may get stuck between the hours, minutes and the dial, the second hand will be plucked and scratched against the dial if the watch continues to move, causing scratches to the dial. Of course, if you have to dial the hands at this time, the situation is even worse, you know, the value of the dial is very high, and some accessories are not easy to find.

1. The gap between the hour hand and the dial becomes smaller: the distance between the hour hand and the dial is the closest, if there is no safe gap, it will rub against the dial surface, causing arc-shaped scratches on the dial, including the luminous on the hour hand, and the luminous powder will also be rubbed off. In addition, the hour hand is too low, rubbing against the logo on the dial, and the minute hand is too low or the minute axis is crooked, causing the front of the minute hand to rub against the hour symbol on the dial.

This will not only cause scratches, but also cause problems for the watch to run.

3. Rust of blue steel watch hands: Although the blue steel watch hands are high-grade and beautiful, it is very easy to rust after being damp, and when the rust "grows" downward, it will rub against the dial and cause arc-like scratches on the dial. This rust mark is still very difficult to wipe off when repairing, the composition of rust should be called "ferric oxide", in ancient times, the ancients used it to make pigments for painting in caves and rock walls, which can be preserved for thousands of years.

The luminous finger also has a non-negligible damage to the dial: especially the old watches, because the luminous materials at that time were probably made of promethium, which is a radioactive element and is not very good for human health; And now the watch luminous material is tritium, tritium is very safe. Watches that have not been used for a long time, such as collectibles, need special attention, if the hour and minute hands are always fixed in the same position, then the luminescence on the hands can harm the dial.

If you use promethium as a luminous material, it is possible to change the color of the dial, mainly the silver ray dial, and the position of the color change is exactly the corresponding position of the hand.

4. If you find that the watch hands are displaced or fall off, you must stop the watch immediately, if there is no stop second device, then you must also pull out the watch handle, let the watch gradually stop, at this time do not go to dial the needle and wind! You can place the watch glass downwards and send it to the after-sales repair center for repair.

In case the watch is subjected to severe vibration, it is also necessary to carefully observe the hands, especially whether the distance between the hour hand and the dial has changed, and if you find that the blue steel hands are rusty, you should also do it in time.

When the watch is worn and used daily, it is easy for the watch hands to fall off when it is impacted. Since the hands are installed in layers, and the top tube is connected to the second hand, the second hand is usually lost.

Watch hands fall off need attention:

1. Avoid moving the watch, so that the hands scratch the dial or the hands are damaged.

2. For some hollow watches, try to avoid the small needle falling behind the dial.

3. After the crown of the watch is pulled out, it should be repaired in time to prevent the watch from entering the dust and damaging the movement.

The watch hands are deformed:

First of all, the hundred watch crown should be pulled out in time to stop the movement to prevent the hands from scratching the watch, dial or damaging the dial.

Secondly, after pulling out the crown, please repair it in time to avoid the dust of the watch from entering.

Third, if the degree is a hollow watch, try to avoid the small hands falling into the back of the dial.

Fourth, when installing both hands, pay attention to choosing a formal mechanism to prevent scratching the improper operation of the dial plate, resulting in a decrease in the waterproof performance of the watch.

In general, maintenance is relatively easy if there is no damage to the inside of the watch. If the wheel tube is deformed, broken, or the parts are worn, the repair will be slightly more difficult. Please note that watches with hands need to undergo a full water resistance test, and the water resistance ring will need to be replaced when it ages. Right.

Hello oh dear, happy to serve you oh <>

If you lose the handle of your Longines watch, there are a few steps you can take:1Contact the brand's after-sales department as soon as possible.

Longines watches are a high-end luxury brand, its after-sales service is relatively comprehensive, you can contact their after-sales department to consult the process after the loss of the handle. 2.Repair your watch.

If the head and strap are integrated, you can choose to go to an authorized Longines repair center for your watch to get better service and standard accessories. 3.Buy a new grip or an entire strap.

Handlebars and straps are usually not a panacea, and different styles and sizes of straps need to be matched accordingly. You can buy original replacement parts at Longines official ** or in specialty stores. It should be noted that when purchasing accessories, you should choose the same specifications and dimensions as the original accessories.

4.Learn to maintain your watch. In order to avoid problems such as losing the head and cracking the strap, it is necessary to pay attention to the maintenance and maintenance of the watch, and clean it regularly to avoid bumps.

In general, Longines watches have high accessories**, so it is recommended to do a good job of care and maintenance of the watch in advance to avoid unnecessary losses caused by carelessness. If the watch is broken, it is recommended to contact the after-sales service in time to get the best service and experience.