The Dell Inspiron 14 3437 stops on the logo and the progress bar does not reflect

Hello, it is recommended that you must install the original Windows operating system, do not use the Ghost version of the operating system, because this kind of operating system is mostly a streamlined system, the stability and compatibility are very poor, and generally do not have AHCI related drivers can not recognize the hard disk in AHCI mode. At the same time, be careful not to use driver management software to find the public driver, but should use the operating system CD that comes with the factory or go to the official website of Dell to install the corresponding hardware drivers, so that the stability of your operating system is very high.

At the same time, because the current computer configuration is relatively large memory, so chip manufacturers are also based on the development of drivers under the 64-bit operating system, it is recommended that you install the 64-bit operating system, because the installation of the 32-bit operating system can not find the relevant hardware drivers.

In addition, you are reminded to use domestic optimization software as little as possible to carry out the so-called "optimization" or "garbage cleaning", because it is easy to disable the startup operation of the driver or hypervisor or directly delete the driver by mistake and cause problems in the operation of the machine. In addition, the "boot optimization" claimed by this type of software will actually cause many drivers that should be loaded at boot to be disabled, resulting in problems with the related hardware.

Dell notes stop on the logo at boot and cannot start the operating system, you can try to solve it in the following ways:

1.First, check to see if the computer has started booting up the operating system when you turn it on. If the operating system freezes, blue-screens, or automatically restarts when the operating system is booted, the partition table and master boot record of the hard disk are normal, and the fault causes such as the corruption of the hard disk partition table, the corruption of the master boot record of the hard disk, and the loss of the hard disk partition end flag are ruled out.

The following method is then used to make a diagnosis.

2.First, start the computer in safe mode to see if it can boot, if it can't boot, it may be infected with a virus, system files are missing, the operating system is damaged, the hard disk has bad sectors, the hardware device has a conflict or the hardware has a problem; If you are able to start Safe Mode, it may be caused by the hardware driver being incompatible with the system, the operating system is faulty, or it is infected with a virus.

3.Then run the antivirus software, if there is a virus, it may be caused by a virus, restart the computer after the virus, if it is not normal, you need to reinstall the operating system.

Original: Caused by system damage and unable to boot.

Solution: 1. Press F8 when you boot up, and select "Last Correct Configuration" to try to repair.

2. Press F8 when booting up, and select "Safe Mode" to try to repair.

3. If method 1 and 2 cannot solve the problem, repair the system through system restore or reinstall the system.

Hello, if as you said, the logo of dell can be displayed when booted, it means that there is basically no problem with the motherboard hardware.

So, it's a computer system problem.

If you can't enter the system settings by pressing F2 F12, it is likely that there is a reading error in the computer's memory.

Repair suggestions: It is recommended that you go to a nearby Dell repair point for professional testing, and it is not recommended to disassemble and repair it privately.

Hello, this case is more serious operating system corruption.

Generally, this situation is difficult to repair and the operation is more complicated. Therefore, it is recommended that you can only solve the problem by reinstalling the operating system or redoing the factory operating system.

Hardware problems must go to the after-sales service, there is hardware in it is bad, boot self-test can not pass.

It doesn't work, it doesn't work to turn it on, that's it.

It is likely to be a hard disk problem, if the machine is out of warranty, first remove the hard disk of the machine and try it, if you can, then directly replace the hard disk.

This is a self-test crash of the boot motherboard, which may have the following reasons and solutions:

1) The hard disk is not recognized by the motherboard.

The hard disk connection is loose, plug in the hard disk connection tightly.

Hard disk 0 track damaged, replaced or repaired.

2) The memory self-test has not passed.

Clean the gold finger of the memory and reinsert it tightly.

3) If the keyboard fails, send it for repair.

4) There is an abnormality in the external socket of the notebook, remove all peripherals and try again.

The simplest and most direct way to be violent is to reinstall the system, the keys do not respond, and some Dell computers need to be equipped with buttons to fn to work.

If you don't know how to consult again.

1. Use disk cleanup to clear the system junk files.

2. Start --- running--- enter msconfig and uncheck all the unnecessary enablement items (such as msn qq, thunderbolt, emulet, virtual optical drive, etc.).

3. Detect and kill viruses and malware. Turn off real-time monitoring and keep your virus database updated and disinfect regularly.

4. Check whether the heat dissipation vent is clean.

5. Whether the ambient temperature is too high.

6. You can consider buying a *** heat dissipation bracket to help the laptop dissipate heat.

7. Close some useless running programs to reduce the burden on the fan.

8. Back up your data and reinstall the operating system.

9. If it still doesn't work, it's best to go to the after-sales department to clean up the dust.

Dell Workshop Tracking** for you

Unplug the power and restart, empty the garbage and other things that take up space, this is a must, remember to clear, and restart again after clearing will be particularly smooth, this is my accumulated experience.

There are many reasons why the notebook cannot be turned on, including the corresponding fault phenomenon, and we can judge different fault causes according to different fault phenomena, so as to find the corresponding solution.

1.Phenomenon: After pressing the power on/off button, you can see the logo interface, and then you can't enter the system, the screen prompts to fix the computer or English error message, press F2 in the logo interface to enter the BIOS setting interface.

Cause: The system was compromised.

Solution: If you are using a pre-installed genuine Win7 system, it is recommended to restore the backup data in the logo interface by pressing Alt+F10 with one click; If you are not using a pre-installed system, it is recommended to back up your data and reinstall the system.

2.Phenomenon: After pressing the power on/off button, you can see the logo interface, and then you can't enter the system, the screen prompts an English error message, and pressing F2 on the logo interface can't enter the BIOS setting interface.

Cause: Failure of other hardware such as hard disks.

Solution: It is recommended to send the local service station for testing hardware.

According to the above description, it should be no boot, if you are a Dell machine, you can follow the following operations to run down the psa and there is a 9090 detection to check whether it is a hardware problem, this kind of problem occurs, generally the memory is loose or the hard disk data cable is loose and the graphics card is loose. Detection steps:1

Cut off all power 2Press and hold the power button for 5-20 seconds to discharge the motherboard3Reseat the following hardware: Hard Disk, Graphics Card, Memory, Optical Drive4

Plug in the BIOS to see if the BIOS detects the corresponding hardware device5Power on F12 and select Hard Drivers

Hello, please provide your computer's service code for further verification of your model. The service code of the notebook model is located on a long strip label at the bottom of the fuselage, which consists of 7 digits of English + numbers; A small number of XPS models need to cut out the nameplate at the bottom; Desktop models are mostly located near the backrest of the case.

At the same time, please describe the problems and error prompts in detail, so that you can propose targeted solutions according to your model and problems.

This belongs to the boot motherboard self-test crash, there are the following reasons and solutions:

1.There is an abnormality in the external socket of the laptop, remove all peripherals and try again.

2.The keyboard is faulty and sent for repair.

3.The memory self-test has not passed. Clean the gold finger of the memory and reinsert it tightly.

4.The hard drive is not recognized by the motherboard. The hard disk connection is loose, the hard disk connection is tightly plugged in or the hard disk 0 track is damaged, replaced or repaired.

Notebook daily maintenance precautions:

1.Do not force the lid of the display screen or place any foreign objects between the keyboard and the display screen to avoid damage to the internal components caused by heavy pressure on the cover glass.

2.Do not touch the surface of the screen with fingernails and sharp objects (hard objects) to avoid scratches, in order to avoid being scratched, it is recommended to paste a screen film, which can play a good role in protection. This protective film is applied when you are not using your laptop and removed when you are using it.

3.The surface of the LCD screen will absorb dust due to static electricity, usually wipe the screen with a special soft brush, glasses cloth, ear wash ball, etc., do not use your fingers to pat it so as not to leave fingerprints, it is recommended to buy a special wiping cloth for the LCD screen to clean the screen, and wipe it gently.

4.Try to recharge the battery after it is exhausted, and the charging must be fully charged before reuse. Although today's laptops use lithium batteries, the memory effect is weakened, but bad habits will still make their life shorter.

5.Do not charge the battery on rainy days. Thunder is common on rainy days, and the instantaneous current shock caused by lightning strikes is extremely unfavorable to the battery.

6.Hard disk is a component that mainly works in the form of mechanical movement, and it is also the most vulnerable component, so special attention should be paid to its protection. Therefore, it is necessary to use it in a stable condition as much as possible, and avoid operating the computer in a place that is easy to shake.

7.For various ports of notebook computers, such as PCMCIA bayonet, VGA interface, etc., we should also pay attention to it, and try to seal the interface with a special buckle cover or empty card when not in use, so as to prevent dust from entering the host from these places.

Hello! What model of notebook are you Dell, this prompt is usually a problem with the file in the boot partition of the hard disk, or an MBR error, in this case, you can only remove the hard disk, and then hang it on other computers, reset MRB or re-partition the C drive.

It's usually a problem with the hard drive. Replace it without hesitation.

If the progress bar is slow, it's because the system is self-checking, just wait!

Mine too, how did you solve it in the end? What exactly is the problem?

There's a screenshot to see the specific situation.,Exactly stopped at that interface.,Different interface prompts,The fault situation is also different.。

The system files have been corrupted, and it is most convenient to reinstall the system.

Press F2 to enter the BIOS when you boot it on, and see if the hard disk can be detected, if it can, it means that it is a problem with the system, and you can reinstall the system to solve it.

3. All reinstall the system to solve:

Then select the hard disk installation system or the U disk installation system according to the situation.