Can a car that has been soaked in water start immediately?

No, it is easy to extinguish, it cannot be emitted, and it is not conducive to the service life of the car.

Haven't you seen the Super Man Bei Anti?

Yes, it is not recommended to open it.

The safety hazard of the soaking car is very large, which means that there will be sequelae. Circuits are prone to short circuits and even**. Although it can be repaired to a certain extent, even if it is repaired, there are still great safety risks.

Most auto repair shops, including authorized repair points, are reluctant to repair the soaking truck, and the sequelae are mainly pollution sequelae and circuit sequelae.

The hazards of the soaking car depend on the degree of impact on the car and the later maintenance, if it is not very serious and the later maintenance is better, there is no problem with driving for three or five years, but the longer the immersion time, the higher the probability of vehicle failure, including engine and circuit system failure.

The hazards of soaking trucks.

The parts are rusty and stuck, because the blisters have reached the moving mechanism of these parts, which causes rust and stuck, especially the infrequently moving parts such as the fuel tank cap, which are very difficult to deal with once rusted and can only be opened by violent destruction.

Then there are metal parts such as the slide rails under the seats and the steering column under the dashboard, which rust quickly when they come into contact with water. Rust powder that comes off and gets into the electronic parts under the instrument panel may cause a short circuit, and entering the direction post may cause abnormal noise or jamming.

The soaking car can not be started directly, the vehicle wading is most afraid of affecting the engine and circuit system, if the water enters the engine intake will directly affect the engine, the circuit system is the most taboo is also wading. If the vehicle stalls while wading through water, remember not to re-ignite, as forced ignition can cause the engine to draw in more water, which can cause serious damage to the engine.

The most feared thing about the vehicle soaking is to affect the engine and circuit system, if the water enters the engine intake, it will directly affect the engine, and the most taboo in the circuit system is also wading, if the vehicle wading is turned off, remember not to re-ignite, forced ignition will cause the engine to suck in more water, thereby seriously damaging the engine.

Does it have any effect on the car after it has been soaked in water?

The safety hazards of the soaking car are very large, that is to say, there will be sequelae, the circuit is easy to short circuit or even **, although it can be repaired to a certain extent, but even if it is repaired, there are still great safety hazards, most auto repair plants, including authorized maintenance points, are reluctant to repair the soaking car, the sequelae are mainly pollution sequelae and circuit sequelae.

It is not easy to say how many years the blistered car can be driven, depending on the degree of impact on the car and the later maintenance, if it is not very serious and the later maintenance is better, there is no problem with driving for three or five years, and the longer the soaking time, the higher the probability of vehicle failure, including engine and circuit system failure.

Seeing that the beginning of autumn has just passed, the rain god is eager to favor the people of the south, this rain is unprepared, so that we are in the feeling of Venice on the water, and at the same time cause a large number of private cars to be soaked in the rain and damaged, so let's take a deep look at the water car is a god horse situation.

Everyone when choosing a used car.

Accidents, fires, and soaking in water are car purchases"Three taboos"

And the soaking car is at the top of the list.

Being looked at as a ticking time bomb.

We often see the car inspection report on a certain platform.

How to understand the distinction between soaking in water and wading?

Wading trucks, which are more common to us.

The water just flooded the wheels and stopped.

However, there was no water in the car.

It doesn't have much impact on the vehicle either.

Water intrudes into the vehicle, floods the chassis of the vehicle and reaches the inside of the vehicle.

The submersion height is below the dashboard.

Such is generally on the floor, seat tracks.

Rust or damage caused by vehicle headlights.

After a professional restoration, you can continue to drive on the road.

The water inside the blister car reaches the dashboard.

That is, the water level is half of the body.

water has been on the engine, gearbox.

Electronic components cause serious impacts.

Even if it is repaired later, it will be driven on the road.

There are also quite a few safety risks.

It is recommended that you do not buy such models.

Flooded cars, flooded cars, and you can't see the kind on the entire roof.

It's worse than the above.

In fact, there is no need to repair it.

But it's a pity that some luxury cars are scrapped like this.

As a result, individual car dealers saw business opportunities.

Engaged in such an unethical business.

Staying away from such flooded cars is a sign of respect for life.

The soaking car is not something that ordinary car owners will encounter.

Many car factory parking lots are also flooded.

These cars will certainly not go to the market.

The company will selectively offer low prices** to internal employees.

At the same time, the vehicle registration certificate will be left with the company.

In order to prevent the soaking car from changing hands and entering the market.

This will also allow the car manufacturer to reduce certain losses.

If abroad.

These cars are generally rebuilt directly from the furnace.

Foreign countries have basically zero tolerance for soaking trucks.

Flying a ticking bomb on the road.

The consequences of sensor failure at any time are immeasurable.

Therefore, the requirements for this kind of car in foreign countries are relatively strict.

For the time being, such a policy in our country has not yet been perfected.

will allow enterprises and individuals to take advantage of loopholes.

I believe that it will be slowly improved in the near future.

Therefore, just open it, there is no problem, it can be started and opened, for the sake of personal life and property safety, it is recommended not to use it again if the safety hazard is large.

Can you still drive a car that has been blistered? It can be opened, but there are potential safety hazards.

The soaking car refers to the car that has been soaked in water, generally refers to the engine, the gearbox has been blistered, the water immersion depth exceeds the wheels and body seats, and the bottom parts of the body are in contact with the water for a long time. The longer the soaking time, the higher the probability of failure, which is like a watch falling into water, even if it is disassembled and dried, the watch will still malfunction and cannot be completely repaired.

In fact, after the "soaking car" is repaired, it is like a "time bomb", problems may occur at any time, such as the engine suddenly stalls at high speed, the airbag can not be popped out at a critical moment or even popped out for no reason, etc., although such a car is cheap, but there are serious safety hazards in daily driving, so consumers had better not be greedy for cheap and buy "soaking car".

Many people say that they can't drive, and there is a reason for this, but not all blister cars can't be driven. Let's take a look at the effects of blistered cars: the so-called blistered car generally refers to the fact that water has entered the cabin, flooded the chassis, interior floor, etc., and even submerged the engine.

Then there are a large number of sponges, fireproof cotton, heat-insulating cotton, and other cotton fabrics for the interior and floor of the car, which are very easy to absorb water. In the process of repair, these cotton materials are not replaced, but after drying, sometimes the internal moisture can not be completely eliminated, and there will be a heavy musty smell in the car when it is hot every summer. This musty smell can sometimes be harmful to the body.

Water will enter the wiring harness and the shell of some on-board computers, and after the vehicle is repaired, everything will return to normal, but some water vapor in the circuit will accelerate the oxidation and damage of these wires or circuit boards. Rust caused by moisture, some metal parts in the car are not treated with anti-corrosion, and after the vehicle is repaired, some residual moisture will accelerate the corrosion and oxidation of these metals. The above are some of the effects of the blister car, so if it is a slight blister car, you know the process of treatment very well, and the treatment is proper, you can still continue to use, but if the blister is more serious, and you do not understand the maintenance process, or find that there are many suspected disassembly and assembly locations, it is not recommended to continue to use.

Under normal circumstances, the car soaking in water is not serious, and it can be used, but the performance will be reduced in all aspects. If the car is seriously soaked in water, it may be scrapped.

Heavy rain causes motor vehicles to be soaked in water, the height of water, the degree of damage to the car during the immersion time, and it is easy to be damaged: such as circuits, electrical appliances, precision instruments, heat and sound insulation materials, oil, etc. The high maintenance value is:

Engine, gearbox, computer system, audio appliances, wiring, airbags, steering system, etc. Therefore, the car with an overrun may have reached the level of total loss.

Because the cost of restoration is higher than the actual value. Usually, the blister level in the car does not exceed the water level in the car, and the loss of seats is not too large. Water inlet into the engine is entered by the intake and exhaust pipes.

The battery and fuse box are flush with the top of the engine. When the water level exceeds the gauge, it can be said to be a total loss (more than 80% loss). The amount of compensation that the insurance company can pay depends on the actual loss.

The condition is that you have vehicle damage insurance. Not intentionally and forcibly wading through water.

There are five main hazards of car soaking:

1. Corrosive hazards of chassis. The wading is not deep, and it just enters the cab through the chassis, which will cause corrosive hazards to the fixing bolts used to connect external attachments at the bottom of the vehicle car, resulting in weakened tensile fastening ability and serious falling off.

Second, the body is a serious density hazard. The sealing strip and the mud barrier rubber ring are invaded by sediment, oxidation and hardening, aggravating wear, and the static state is good, and it is inevitable that there will be abnormal noise or wind noise when driving.

3. Peculiar smell and mildew hazards. However, if the car is flooded, the water entering the car will be transformed into an acidic mixed liquid, which will be absorbed by the fabric in the car, and it is inevitable that it will produce peculiar smells after mildew in case of heat, and if it is not cleaned up, it will also cause invasion of its close metal parts to cause rust and weaken the mild hardness of the metal.

Fourth, the stability of the engine and gearbox. Static wading conditions are relatively light, and external components and electronic components can be cleaned and replaced. Dynamic wading is more serious, the engine machine disassembly and assembly is inevitable, non-4S shop disassembly, maintenance, replacement is not enough to ensure the accuracy of engine assembly, it is inevitable that there will be two or three repairs in the future.

5. Electrical fire hazards. This is the most harmful, if the main electrical wiring and control unit of the vehicle are not replaced, the fire will break out sooner or later.

1.Go to the 4S shop to clean the vehicle after driving through stagnant water and rain, because the rain has a certain corrosiveness, although the car will spray some anti-corrosion materials on the body and chassis during the manufacturing process, but the long-term invasion and soaking will cause serious corrosion to the vehicle chassis, and it must be cleaned with fresh water.

2.Serious wading refers to the vehicle driving into the waterlogged road section, due to the engine water or exhaust pipe water after causing the ignition in the water, regardless of whether the vehicle has a second start, whether there is a whole vehicle power failure, it is serious wading.

3.During maintenance, vehicles that are heavily involved in water need to be thoroughly dismantled, especially the engine and interior electrical equipment, various computers and body modules. Simple maintenance may not ensure long-term use, and it is recommended to replace the electrical components that have been blistered.

After the repair, the static test of each function on the vehicle is carried out, and then the dynamic road test is carried out to ensure that the vehicle meets the requirements of the OEM after repair, and finally the vehicle is fully cleaned and delivered to the customer.

4.Other parts of the vehicle may also have problems after the vehicle is repaired by water ingress, so the owner needs to observe carefully in the process of daily use of the car to avoid the occurrence of the vehicle.

The invisible place of the frame will rust, some of the iron in the car will also rust, and the shadow is beautiful, the copper needle in the component plug will enter the water, and it will oxidize for a long time, which will affect the transmission of the signal, etc. If the soaking car is not handled well, it will fail at both ends for three days, and it will only be busy repairing the car every day.

After soaking in water, it must have been professionally repaired by a 4S shop, and the damaged parts will also be replaced and repaired, so you can open it with confidence.

If there is no failure, it can be opened, and it is recommended to do a maintenance before opening.

The engine was about to be replaced, and the engine was basically scrapped after the flood.

It depends on whether the problem of soaking water is serious, and if the whole car is soaked in water, it should not be able to be opened.

As long as there is no water inside, it will have no effect when it is opened.

You can open it if it's repaired.

It depends on what kind of soaking method, it is made in water, and if it is repaired later, there will be many problems with the line.

If the engine is turned off, do not start it again, otherwise the engine will be scrapped.

The starting car does not enter the water, and it is not a big problem to drive.

1. If there is water ingress and stalling during the wading process of the vehicle, turn off the ignition switch immediately, do not try to start the engine again, move the vehicle to a safe place, and try to make the vehicle high in front and low in the rear, so that the water entering the exhaust pipe can flow out and avoid damage to the three-way catalytic converter and muffler.

2. After judgment, if the water enters the engine, the spark plug should be removed, and the motor should be used to transport the motor after artificially cutting off the fuel supply system and ignition system, so that the water entering the engine can be discharged smoothly. At the same time, check the oil status of each system of the vehicle, and replace it in time if there is foaming and turbidity. After the test is completed, compressed air should be used to clean the electrical connection parts inside the engine compartment to prevent corrosion caused by moisture accumulation in the electrical connection parts.

The key removal areas are: fuse boxes, sensor plugs, and water accumulation in the body. After the cleanup, the vehicle road test is carried out to confirm that the engine is free of abnormal noise during driving.

If there is significant driving noise, check the engine bearings and rotating parts.

3. If the water enters the compartment in the wading, the maintenance process is mainly to clean up the water in the car, and there are several sealant plugs located in the lower part of the vehicle chassis, and the water in the compartment can be released when the rubber plugs are opened. However, due to the strong water absorption of the interior decoration material floor glue, the floor glue should be removed, placed in a spacious space to facilitate the evaporation of water, after installation, it is also necessary to pay attention to turn on the air conditioner, adjust the vehicle circulation switch to the internal circulation, so that the water vapor in the compartment is discharged out of the car through the air conditioning system, which is a very fast dehumidification method in summer.

4. Chassis parts are easy to cause deterioration of lubricating oil in the process of wading, especially when it comes to steering, transmission and other systems. For example, the maintenance manual requires the Land Cruiser to grease the chassis components after wading through water. At the same time, you should listen carefully to the chassis for abnormal sounds during the road test, or disassemble and inspect the chassis.