There are many ways to design the drain channel of the sink, how to design it to ensure that there i

The sewer pipes under the sink are basically straight-through, and U-shaped pipes are rarely used, because there is not much need for the straight-through type at home to be more adaptableIf there is a corresponding blockage, it is easy to drain, and if it is U-shaped, it may be very troublesome to drain. <>

The connection between the sink and the sewer should be made of this straight-through type, as much as possible to make its diameter larger, because the diameter is larger it is not easy to block, the sewer below the ground is basically made U-shaped, because the U-shaped it has a better effect of preventing nausea, because after all, the sewer is a variety of domestic sewage, washing water, washing water,It is a lot of bacteria and dust, long-term water in the sewer will naturally have a corresponding odor, if it is not made into a U-shape, it will be easy to smell, the bathroom will have a strange smell. <>

Preventing water leakage is actually very simple, as long as the quality of the pipe is good enough, the connection does not have corresponding problems, use waterproof tape and waterproof glue, and then apply enough pressure on the screw at the connection port to ensure that it will not leak, the best way is to wrap something similar to plastic wrap on it, and then use waterproof tape, and then fix it with bolts, basically there will be no water leakage, because the sewer leakage will cause the floor of the home to be easy to enter the water, Floors that are prone to moisture will have a big problem, and it will be very troublesome to deal with themBecause the whole ground has to be thrown up, and then the sewer pipe is reprocessed. <>

The laying of sewer pipes should take into account the variability of decoration and the convenience of maintenance, decoration can not simply consider the aesthetics, but also consider how to repair if the sewer pipe has sexual problems, if the ground is completely sealed, you go to repair, you have to remove all the decoration on the ground, and then run underground to repair the pipeTherefore, it is necessary to have a certain maintenance opening flowing under the foundation, which can be a place where these pipes can be repaired directly, similar to the existence of a basement.

Personally, I think that the minimum width of the sink is 550mm, and the 600mm bathroom on one side has reduced the sink to about 300mm in order to save space, and the key is that the center of the sink to the wall on both sides should leave a 550mm headroom size so that there will be no leakage.

For such a sewer channel, it is best to choose a relatively strong waterway pipe, which can be wrapped with a protective film on the outside, so that there will be no water leakage.

There are many ways to set up the drain passage of the washbasin to keep it watertight! I generally find a professional home decoration design company to help us design, choose high-quality decoration materials, investigate the factors that will leak from the washstand, and improve it.

If you want the sink to not leak, you can only seal the pipe interface next to the sink with super glue, so as to avoid the leakage gap of the sink and prevent the water from leaking.