What is the size of the squatting water supply pipe installation, and what is the reserved size of t

The squatting drain is generally 650mm away from the wall. Squatting toilet installation steps: 1

According to the sewage outlet of the installed product, reserve the sewer pipe at the appropriate position from the wall, and determine the distance between the sewer pipe inlet and the ground level. 2.The depth of the pit reserved for the installation of the squatting toilet under the ground is greater than the height of the toilet.

3.Place the connecting rubber plug into the water inlet hole of the squatting toilet and clamp tightly. Apply a layer of glass glue to the outer edge of the contact with the water inlet hole of the squatting toilet.

or putty, insert the water inlet pipe into the glue plug inlet hole, so that it is well sealed with the rubber plug to prevent water leakage. 4.Apply a layer of glass glue or putty to the edge of the outlet of the squatting toilet, put it into the inlet of the sewer pipe and screw it together, and set the toilet level with coke residue or other filling.

5.Open the water inlet system and check each joint for water leakage, and if there is a water leak, check the condition of each joint. until the problem is resolved.

6.After checking that there is no water leakage at each joint, fill the area around the toilet with filler, and use ceramic and cement mortar.

The contact surface is filled with more than 1cm of asphalt or linoleum.

and other elastic materials. 7.Use cement mortar to fix the squatting toilet in the horizontal plane, and after it is stable and firm, then pave the bathroom floor tiles on the cement surface.

8.Test flushing, if there is no abnormality, you can use it.

Squatting to feed the water tank, self-closing, the water tank is generally given to the water height, and the floor is about 20 minutes. The downstroke is about 20 minutes to the left. Self-closing type, self-closing type, and foot type, hand self-closing water supply installation height is 80 minutes, and foot type is 15-20 minutes.

When using a squatting toilet in the bathroom, the distance between the center of the drain pipe and the rear wall should be at least 680mm.

The common size of the squatting toilet drain is between 1500 mm and 1800 mm, usually 680 mm is reserved, and 300 mm or 350 mm is reserved for the rear drain. The size of the squatting toilet drain depends on the situation. If it is with a water inlet, the distance from the wall is about 50 cm.

If you install a pvc bay, the distance is about 35 cm to 45 cm.

Precautions for squatting toilets

If the squatting toilet does not have a water storage inlet, a water storage inlet should be set up on the pipe, which can play a deodorizing function. If the squatting toilet has its own water storage inlet, the sewer pipe does not need to be equipped with a water storage inlet, otherwise the flushing function will be affected.

The water inlet flushing device of the squatting toilet mainly includes high water tank flushing, ball valve, delay flushing valve, electromagnetic induction flushing valve, manual flushing valve, etc., and the installation and use of the squatting toilet are to avoid violent impact.

The specifications are not uniform, the size is different, the toilet is generally 30-40cm from the wall, the squatting toilet is divided into two kinds, with the water bay to be about 50 from the wall without a bend (another PVC water bay) 35-45cm from the wall, the sink pipe from the wall 10-15cm, the broom pool 30-40cm. It is said that the size of the pipe, and the size and requirements of the space should be seen when installing.

1. The general size of the squatting toilet trap is: length: 585mm * width 470mm * height 296mm.

2. Purchase squatting toilets, the bathroom must be left with a good squatting pit squatting toilet installation size is generally fixed, there are several different sizes on the market, mainly 520x420x x420x x450x x420x x430x x430x190 These options.

3. The pit distance refers to the distance between the center of the sewer pipe of the toilet and the wall, generally 300mm, 350mm, 400mm, 450mm, etc. Choosing the right toilet starts with choosing the right pit spacing. Conventional reserved clean wall toilet:

The back is 300mm from the wall, and the side is not less than 500mm. (The distance between the center of the toilet is generally as follows: mm) The distance between the squatting on the wall is 650---700mm behind the squatting on the regular reserved wall, and the side is not less than 450mm.

4. The urinal drain pipe is 150 200mm away from the wall, the toilet drain pipe is most commonly 400mm and 300mm away from the wall, and the squatting drain pipe is generally 650mm away from the wall. There are five steps to pay attention to when choosing a squatting toilet: looking at the whole, touching the surface, weighing the weight, specific water absorption, and testing the flush.

Generally, a powerful squatting toilet will reflect its own situation from the whole and all aspects of the sample. So you can see how much they put their intentions. The high-grade glaze and body are more delicate and will not be uneven.

The mid-range ones are darker and will have pores. The high-grade firing temperature is more than 1200, and the material structure is all completed in the crystalline phase transformation, and the glass phase with an extremely dense structure is generated, which meets the requirements of all porcelain sanitary ware, and the hand has a heavy feeling. The most obvious difference between high-temperature ceramics and medium- and low-temperature ceramics is the water absorption rate, the water absorption rate of high-temperature ceramics is lower, it is easy to clean, it will not absorb odors, and there will be no cracks and local water leakage on the glaze.

If it is a simple latex paint, it is generally about 7 days, because the latex paint can be dried in about 7 days, and the volatile harmful substances in the latex paint after drying are basically all volatilized, and it depends on the humid weather at least two weeks, as long as you buy the most environmentally friendly latex paint.

The general size of the squatting toilet trap is: length: 585mm * width 470mm * height 296mm.

When using a squatting toilet in the bathroom, the distance between the center of the drain pipe and the rear wall should be more than 600mm, and the installation of the squatting toilet below 600mm may not be smooth, but the reserved size should not be too long, so as to avoid the distance being too far and causing the length of the flushing pipe to be insufficient and affecting the normal use.

At the same time, the distance between the drainage pipe and the side wall is also required, and it must not be less than 450mm, otherwise even if the installation process is smooth, it will be too cramped and inconvenient to use.

Precautions for installation of squatting toilets

1. All parts of the squatting toilet in contact with concrete should be filled with elastic materials such as asphalt or linoleum, otherwise the toilet will rupture due to cement expansion.

2. When finishing with heat-dissolved asphalt, the toilet should be prevented from being heated and caused by rupture.

3. The installation of the squatting toilet should be operated in strict accordance with the instructions, otherwise the toilet will be broken.

4. The water inlet flushing device of squatting toilet mainly includes ball valve, high water tank flushing, electromagnetic induction flushing valve, delay flushing valve, manual flushing valve, etc.

5. Avoid slamming the squatting toilet when installing and using it.

The installation size of the squatting toilet refers to the distance between the center of the toilet sewer pipe and the wall, generally 300mm, 350mm, 400mm, 450mm, etc. Choosing the right toilet starts with choosing the right pit spacing.

The conventional reserved net wall squat is 650 700mm away from the wall, (the flushing pipe is a little short and needs to be lengthened) and the side is not less than 450mm.

The toilet is generally 30-40cm away from the wall, and the squatting toilet is divided into two kinds, the one with the water storage bay should be about 50 from the wall without the storage bend (another PVC storage bay) 35-45cm from the wall, the washbasin sewer pipe is 10-15cm from the wall, and the broom pool is 30-40cm.

Other types of more common squatting toilet sizes are: the length is roughly five two zero, five.

Three. Between five and five hundred and eighty millimeters, the width is roughly four hundred and two.

Ten, four hundred. between three and four hundred and five millimeters.

Hello, I am helping you to inquire about the relevant information and will reply to you immediately.

<><1. What is the reserved size of the squatting toilet drain?

The reserved size of the squatting toilet drain pipe is generally more than 600mm, and the rear drainage is reserved for 300mm or 350mm. In addition, if the squatting toilet has a water inlet, the distance from the wall is about 50cm, and if you need to install a PVC water inlet, the distance is about 35cm-45cm.

Second, the installation standard of squatting toilets

1. When installing the squatting toilet, you need to reserve the water pipe from the wall, determine the sewage outlet, and measure the distance between the sewer pipe inlet and the ground level.

2. Special attention should be paid to the depth of the pit reserved for the installation of the squatting toilet, which must be greater than the height of the toilet.

3. Put the connecting rubber plug into the water inlet hole, and put a layer of glass glue or putty on the outer edge of the contact after clamping, so that the water inlet pipe and the rubber plug can be well sealed in the water inlet hole, which can prevent water leakage.

3. Advantages and disadvantages of squatting toilets

1. Advantages. **Affordable, easy to use, easy to clean, no direct contact when using**, so it is more hygienic. In addition, the squatting toilet does not take up much space, and if the bathroom is relatively small, you can choose a squatting toilet.

2. Disadvantages. The elderly and children are inconvenient to use, and their legs will be numb after squatting and shouting for a long time. In addition, the installation is more cumbersome, the installation location needs to be filled, and the construction steps are more complicated.