What should I do if vivo comes out of system repair mode?

vivo smartphonesSystem repair mode appearsYesPress the volume down button to select RestartPress the power button to confirm the restart of the phoneCan.

Specific steps (tovivo x20For example):

1. The mobile phone button is indicated as shown in the figure below.

2. In the system repair mode interface, press the volume button up and down to adjust to restart.

3. Press the power button again to confirm the restart, it will take a few seconds to boot the interface.

The easiest way is to take it to the vivo service center for testing.

The system repair mode appears on vivo phone, please deal with it as follows:

1. Check whether the power button and volume button are touched by mistake.

If the power button and volume button are stuck in the case, or if they are squeezed in the pocket for more than 12 seconds, they may be accidentally touched to enter the recovery mode, please be careful to avoid squeezing the button.

2. Force restart your phone.

Try force restarting your phone to see if it can be used again.

Force Restart Method:

Models released before September 2017 (models before x20): Press and hold"Power button"More than 12 seconds.

Models released after September 2017 and new models released later (X20 and later): Press and hold the "Power Button" and "Volume -" for more than 10 seconds to force restart the phone.

NEX 3 NEX 3S: Press and hold the top round button for more than 10 seconds.

3. Repair the system.

Enter"System Repair Mode", and then tap"Install the system software"Enter"Networking updates to the latest version", click"OK"(It is recommended to connect the charger) - Connect to the available wifi, when the upgrade package is detected, tap"** and install"Update your phone's system.

Ways to enter System Repair Mode:

Models released before September 2017 (models before x20): Press Shutdown status"Power button"with"Volume +"Enter recovery mode;

Models released after September 2017 and new models (X20 and later): Press Shutdown status"Power button"with"Volume +"Enter fastboot mode, then enter recovery mode through the menu selection, select: install system software, and then select:

Networking updates to the latest version

NEX 3 NEX 3S: Press and hold the top round button for about a second in the shutdown state, and then press and hold "Volume +" to enter fastboot mode, press "Volume-" to move to"Go to Recovery", press the "Power button" to confirm to enter the recovery mode.

4. Service center testing.

If the above methods do not solve the problem, please back up your mobile phone data in advance, and bring your mobile phone and purchase voucher to the vivo customer service center.

Detect. <>

1. The system repair mode appears on vivo mobile phone, you can try to solve it in the following ways.

2. First of all, it is recommended to connect the phone to the charger and wait for a while, and then press and hold the power button for 30 seconds to force restart.

3. You can press and hold the power button and the volume up button at the same time to enter recovery mode, use the volume button to select the "restart phone" or "now" option, the power button to confirm, and restart the phone.

Summary. Hello. We'll be happy to answer for you.

vivo system repair mode is recovery mode, in recovery mode, users can erase all data of the phone, you can flash in this mode, and make a data backup before using this mode.

System Repair Mode Description:

If the X6 series, XPLAY5 series and subsequent new models do not turn on (i.e., the screen is black, the desktop cannot be entered after booting, the vivo interface stays at boot, and the vivo interface stays at boot after upgrading), you can try to "revive" the phone without losing data through the "System Repair Mode".

If the above operations still can't turn on normally, please press and hold the "Volume Up Button" + "Power Button" at the same time, and let go to enter Recovery after the phone screen turns on or vibrates (if you can't enter, you need to go to after-sales processing), and select "System Repair Mode" for system recovery.

Due to the large flashing package (about, it is estimated that the 4M network will take about 1 hour (it is recommended to connect the mobile phone to the charger to ensure that the power is sufficient).

What is the system repair mode of vivo phone?

Hello, I am inquiring for you here, please wait a while, I will reply to you immediately.

Hello. We'll be happy to answer for you. vivo system repair mode is recovery mode, in recovery mode, users can erase all data of the phone, you can flash in this mode, and make a data backup before using this mode.

System Repair Mode Description: X6 series, xplay5 series and subsequent new models do not boot (i.e., black screen, boot can not enter the desktop, boot stays in vivo interface, boot stays in vivo interface), after upgrading boot stays in vivo interface), you can use the "system repair mode" to try to "rescue" the phone without losing data. Operation:

Press and hold the power button for 30 seconds or charge for 30 minutes before trying to turn it on, if it can be turned on, you don't need to go to the next step. It mainly excludes the situation of crash or no power. If the above operations still can't turn on normally, please press and hold the "Volume Up Button" + "Power Button" at the same time, and let go to enter Recovery after the phone screen turns on or vibrates (if you can't enter, you need to go to after-sales processing), and select "System Repair Mode" for system recovery.

Due to the large flashing package (about, it is estimated that the 4M network will take about 1 hour (it is recommended to connect the mobile phone to the charger to ensure that the power is sufficient). Click on "**Latest Version and Install", if the phone storage space is insufficient, it will prompt that the space is insufficient and it cannot be **.

How to use System Repair Mode:Enter recovery mode -- install the system software -- determine the latest version of the network update -- **latest version and install it, connect to the available wifi -- and install -- restart the upgrade package after it is successfully installed.

Ways to enter recovery mode:

1. Folding screen: Operate in the shutdown state, press and hold the "Power Button" and "Volume Plus Button" for about 5 seconds at the same time, enter fastboot mode, press the volume button to select "Enter Recovery", and press the power button to confirm the entry.

Devices listed after September: Press and hold the "Power Button" and "Volume Plus Button" at the same time for about 5 seconds in the shutdown state, enter fastboot mode, press the volume button to select "Enter Recovery", and press the Power button to confirm the entry.

3. NEX 3 NEX 3S: Press and hold the top round button for about seconds, then press and hold the volume plus button to enter fastboot mode, press the volume button to select "Enter Recovery", and press the power button to confirm the entry.

Models released before September: Press and hold the "Power button" and "Volume Plus button" at the same time for about 5 seconds in the shutdown state to enter recovery mode.

The function of vivo system repair is to fix some problems that occur in vivo mobile phones, so that the system works normally, and some hidden bugs can be restored to normal. It is relatively simple to operate, and the system can be repaired very quickly.

The vivo system repair method is as follows:

1. First of all, turn off the vivo phone, press and hold the power button, a power menu will appear, and click to turn it off.

Tuanqiao 2, then press and hold the power button + volume up button, a startup manager appears, press the volume down button to select to enter recovery, press the power button to confirm.

3. Wait for a while, select the installation system package, and press the power button to confirm.

5. Plug in the charger according to the prompts, and click OK after plugging it in to enter the repair system mode.

6. Then connect to the WiFi network, select the WiFi access point, enter the password, and click OK.

Summary. Hello yo dear, I will help you solve this problem The specific solution is as follows: In the system repair mode: you can connect the mobile phone to the wireless network ** firmware upgrade package to flash the system to repair the system (generally this mode is used when the mobile phone has a system failure).

1: Enter "Recovery Mode" and select "System Repair Mode" (Enter the method: Press and hold the volume up button after shutting down, and then press the power on button) Plug in the charger and click "Enter System Repair Mode";

3: The function of vivo system repair mode is to fix some problems that occur on vivo mobile phones, so that the system works in a normal state, and some hidden problems can be restored to normal. It is relatively simple to operate, and the system can be repaired very quickly.

Hope it helps

What is the system repair mode of vivo phone?

Hello dear, it is a pleasure to serve you. I am Mr. Xia in the Digital Zone, and I have provided consultation on the comprehensive life of Yukuan for a total of 3,800 potato banquet customers! I have seen your question, and I am sorting out the reply for you, please be patient and wait for about 2 minutes.

Hello yo dear, I will help you solve this problem The specific solution is as follows: In system repair mode: you can connect the mobile phone to the wireless network ** firmware upgrade package to repair the system Duan Fan (generally this mode is used when the mobile phone has a system failure).

1: Enter "Recovery Mode" and select "System Repair Mode" (Enter the method: Press and hold the volume up button after shutting down, and then press the power on button) Plug in the charger and click "Enter System Repair Mode"; 2:

Select "**Latest Version and Install"; Select "Available wifi and connect"; Select ** and install; ** Automatically repaired when completed, wait for the repair to complete. 3: The function of vivo system repair mode is to fix some problems that occur in vivo mobile phones, so that the system works normally, and some problems hidden in the hidden hail can be restored to normal.

It is relatively simple to operate, and the system can be repaired very quickly. Hope it can help you

vivo mobile phone in system repair mode: you can connect the mobile phone to the wireless network** firmware upgrade package to flash the system to repair the system (generally this mode is only used when the mobile phone has a system failure).

The function of vivo system repair mode is to fix some problems that occur on vivo mobile phones, so that the system works normally, and some hidden bugs can be restored to normal. It is relatively simple to operate, and the system can be repaired very quickly.

How to use System Repair Mode:

Enter recovery mode -- install the system software -- determine the latest version of the network update -- **latest version and install it, connect to the available wifi -- and install -- restart the upgrade package after it is successfully installed.

How to get out of recovery mode:

You can click "Restart" on the recovery mode interface to exit.

If you can't quit, try force restarting your phone or tablet, or use System Repair Mode to see if it can get back to normal.

1. Press and hold the power button of the mobile phone tablet to pop up the "Restart" option to turn it off;

2. Slide down at the top of the mobile phone screen to bring up the shortcut details page twice Swipe up at the bottom of the screen to enter the control center, and click the "Shut down and restart" switch;

3. Force restart the mobile phone and tablet; (It is recommended to use it when the phone is frozen or stuck).

Tablet, FunTouch OS and subsequent models: Press and hold the "Power button" + "Volume Down button" at the same time for more than 10 seconds;

Press and hold the top round button for more than 10 seconds to force restart the phone (applicable to NEX 3 NEX 3S);

FunTouch OS previous models: Press and hold the "Power Button" for more than 12 seconds.

If the above methods do not solve the problem, please bring your device and proof of purchase to the vivo customer service center.

Dispose. <>