125 Knight Car How to Drive High Score Short Answer

I'm really afraid of turning off the ignition, so give more oil before putting the clutch: 1 First hang up the first gear, so that the engine speed reaches more than 2000 rpm (it can be higher, but it must not exceed 4000 rpm), and then slowly put the adjuster, (the key is that the throttle control of the right hand is in place and the clutch should be put slowly) 2 After walking, hold the clutch with the left hand, then collect the oil with the right hand, and then hang into the second gear, then give oil with the right hand, put the clutch with the left hand (put it slightly faster than the first gear) and so on You'll be able to become proficient in no time, but a word of caution is a reminder: stay safe when driving!

That's true for people who have just learned, and so am I. But there are more than ten years of driving experience.

The most difficult thing to learn to drive is what you said, the clutch and throttle are difficult to grasp, and the clearance of no car is different, you can only test the car and grope, in fact, it is the same procedure, you also know that start-fool-refuel-loosen the clutch-look ahead.

If you always turn off, then it must be that you release the clutch fast, don't start too quickly, slowly let go of the clutch and hear the engine sound is a little difficult or change the sound, you can add a little oil to let go of the clutch at a slightly faster speed, and there is also a way is to start with your feet to help a force, coasting is very smooth start No, when changing gears, you must master the speed of each gear, so as not to hold the car or run forward.

In short, it's all about a process to get familiar with you"Baby"Yes, if you find out his temper, you can control him flexibly, just like a horse. I'm sure you'll find fun, I'm sure.

I'm not a professional, but I hope it helps.

I've used two of them, and it feels pretty good, full of horsepower, and it's okay to start.

However, I haven't heard of any driving skills that require special attention.

Step 1: Ignition in neutral gear.

Step 2: Hold the clutch with your left hand and don't let go of it yet.

Step 3: Hang the gear, of course, hang a gear at the start, so that it is not easy to turn off.

By the time you've completed the above four steps, your car is already moving.

Motorcycle 125 now has very few cycle gears, and it is generally the International Party [Plum Blossom Gear].

If it's a new car, it could be an improved product that removes the way the old car is in gear.

For example, a lot of old cars are like slowly unplugging the clutch and the car will walk, but the one I used most recently.

But you have to slowly drive a little bit of the car away, and then you have to let go of it all.

In the past, there would be no problem with how long you want to loosen the ordinary old car, but now there will be a clasp [click] I asked a professional.

This is said to reduce friction plate loss. Speechless.

It's really hard to say the driving skills The functions of each car are not the same You don't have a clear hint It's not good to give you a direct answer What I can say is the gear, because I have ridden a friend's car ** The same is true.

Yamaha is an international gear, step one, hook two, hook three, hook four, hook five. That is, the first gear is stepped on first, and the second gear is hooked up, and then the gear must be added and hooked again, and so on.

It's like learning to ride a bicycle, you can only understand it when you actually do it, you can never learn it on paper, find a car, don't be afraid. Note: Wear a helmet and start with a small throttle.

1-n-2-3-4-5.This gear is popular now. In neutral, it's 1st gear forward and 2nd gear backward.

Generally, it is added after and subtracted before. For example, starting, you start in 1st gear, grasp the clutch (there are many cars now, you can't ignite without grabbing the clutch), after ignition. At 3000 rpm, slowly release the clutch (this clutch has to be slowly groped by yourself, and the speed of the clutch is related to the tightness of your clutch line).

After starting, blast down the oil to raise the speed, and then increase the gear. That's it. These things are like swimming, and you have to practice more on your own.

Also, if you're a newbie, don't be too fast. Don't look at the computer, no matter what gear you are in, it's absolutely OK to keep the revs at 4000 rpm

1.In this case, you need to brake and slow down first, reduce the speed to a speed that you can grasp and adapt to the road conditions, and then reduce the gear to a gear that matches the speed of the car, generally using 2nd or 3rd gear.

2.At this time, don't use a gear, a gear is only used to start or go on a very rough slope, as long as it is not suitable to use a gear after starting, as you said in this case, use 2 gears on the line, relative to 1 gear, 2 gears should be much more stable, with 2 gears of small throttle low speed, it is not easy to channel.

According to the inscription "The speed of car A is 125% of car B", the speed ratio of A and B is 125% 1, so the ratio of time they have traveled is 1

125%, according to "After the two cars meet, car B travels for 20 hours to reach place A". Then it can be seen that it takes 20 hours for B to reach place A, and it takes 20 125% = 16 hours for A. This 16 hours is the time when they meet. Got it!

Answer: Let the speed of car B be x, the speed of car A is 125% x, and the two cars will meet in y hours. then xy+125%xy=xy+20x.

"xy" refers to the distance traveled when car B meets, "125%xy" refers to the distance traveled when car A meets, "xy+125%xy" refers to the distance between nails A and B, the second "xy" refers to the distance traveled by car B when they meet, "20x" refers to the distance traveled in 20 hours after car B meets, and "xy+20x" refers to the distance between nails A and B. "The "xy" on both sides of the equal sign can be reduced to "125%xy=20x", and then the "x" is divided to calculate the result, y is 16> so the final answer is 16.

For example, two cars A and B drive opposite each other from A and B at the same time, the speed of A is 125 of B, and after the two cars meet, Car B travels for 20 hours to reach A.

How many hours do they meet?

Solution: Let the speed of b x, then the speed of a is that when A meets, the distance traveled is: , which is exactly equal to the distance that car B takes 20 hours to reach place A.

The time they met: 20x hours).

If you're satisfied with my simplest answer, please give it points.

Solution: If the speed of car B is v kilometers per hour, then the speed of car A is kilometers per hour, and they meet in t hours, and the distance between A and B is S kilometers.

Because A and B drive opposite each other from A and B at the same time, when they meet, the distance of car A and the distance of car B are equal to the distance between car A and B.

The equivalence relation for this column is: s =

And because car B continues to drive for 20 hours to reach place A after the encounter, it takes car B to reach place A from place B (t+20) hours.

From this column equivalence relation: s =v(t+20)(2)(1)(2)Simultaneous get:

Divide both sides of the equation by v at the same time, and solve t=16

Mine is the Diamond Leopard, the international file, the gear is like this, you can refer to mine. Stepping forward is a first gear, and then you can't step on it, pick it to the sky (your gear lever is stepped on front and back, and mine is only half of yours, that is, step forward on that half) half is neutral, pick half is the second gear, and then pick the third gear, you can pick up the fifth gear, step forward when downshifting, you can step on the first gear all the way, and then step back half is neutral. You can step directly backwards from neutral to second gear, or you can step forward from second gear to neutral, in addition, the international gear is not circulating, and you can't pick it directly from the highest gear to neutral.

Assuming that the speed of the truck per hour is x kilometers, the following equation can be derived:

80*5-x*5=125

80: The speed of the car.

5: The time traveled.

x: The speed of the truck.

125: The car travels more distance than the van.

Solve the above equation:

400-5x=125

400-125=5x

275=5x

x=55

The fuel injector is blocked, and there is no way to fix this, only to change the fuel injector. The fuel injector is not cheap, so let's go to the car 4S to clean it first.

It's better to give it to a professional repairman, you just have to pay.

I don't know if the motorcycle has a gasoline pump to look at it, a gasoline filter, and a fuel injector.

The person stands up, clamps the seat cushion between his legs, and then adds the throttle, "slightly increase", the speed is not too fast (about 40-60km h), and then clench the handle with both hands and slowly lift it up (slowly upward, otherwise it will be very dangerous).