How to cool down a computer processor How to cool down a computer processor

Rapid cooling requires an electric fan, open the case cover and blow it directly, the temperature is immediate, but not a long-term solution.

If you want to do it once and for all, it's best not to believe in the so-called cooling software, which is nothing more than frequency reduction, but frequency reduction means that playing games will be stuck, this is a hard injury, and it needs to be solved by hardware, at most install a temperature and fan speed monitoring software like game plus.

Generally, when not playing games, it is normal for the CPU to be below 40 degrees, the graphics card to be below 40 degrees, the hard disk to be around 30 degrees, and the motherboard to be around 30 degrees, and the fan speed varies from individual to individual. If it is a large 3D game, the CPU and graphics card can reach 70 degrees or even higher, the hard disk is around 50 degrees, if the hard disk exceeds 70 degrees, there will be a risk of data loss and hard disk damage.

1: The radiator should be heat piped as much as possible, and the side blowing can blow most of the heat to the rear exhaust vent.

3: Increase the air duct fan in the case, Ma Yun has 30 pieces on the line, and the enhanced flow effect can quickly and effectively remove hot gas to avoid the heat island effect.

4: Check your CPU Thermal Power Consumption (TDP) online and buy a corresponding or higher specification heatsink.

1.Fan heat dissipation: The most common heat dissipation method in the computer host is to set up fans of different sizes in different positions such as the front and back, left and right of the host, and draw hot air from the inside of the host computer to achieve the heat dissipation effect through the blowing of the fan.

This method is relatively simple and inexpensive, but it needs to be cleaned and maintained regularly, otherwise the fan can easily be covered with dirt, resulting in reduced heat dissipation or failure.

2.Water cooling and heat dissipation: Water cooling is an advanced heat dissipation method for the host, which introduces fluid as the heat transmission medium, draws out the heat through the internal circulation system, and then dissipates the heat through the external heat dissipation equipment.

Compared to fan cooling, water cooling can dissipate heat more efficiently and can effectively reduce noise. However, the corresponding water cooling system is expensive and requires maintenance.

3.Heat dissipation sticker: Heat dissipation sticker is a relatively simple way to dissipate heat, which can conduct heat through materials such as copper, aluminum, etc., to quickly direct the heat out and reduce the temperature of the host.

This method can effectively improve the heat dissipation effect, but it is necessary to pay attention to the thickness and quality of the heat dissipation sticker, otherwise it will cause damage to the host components.

4.Large air-cooled radiator: A large-scale air-cooled radiator is generally composed of a radiator heat dissipation chip, a copper heat sink, an aluminum heat sink, etc., in which the fan will be relatively large, which can achieve a faster and more efficient heat dissipation effect.

This method is generally suitable for high-performance gaming PCs or other consoles that require strong cooling capabilities.

To sum up, the choice of which potato seed to dissipate heat needs to be decided according to your own use, budget and needs. Either way, regular maintenance and cleaning are required to ensure the heat dissipation effect and service life of the host.

If the computer is hot, it will affect the service life of the computer. Next, let's take a look at how to cool down your computer.

01 Computer configuration.

It is possible that the configuration of the computer does not match the load of the computer, which will also cause the computer to heat up easily.

02 Clean up the garbage.

If you don't clean up your computer's junk, it will also slow down your computer and make your computer hot, so it's important to clean up your computer's junk regularly.

03 Clear the cache.

In addition to cleaning your computer's junk regularly, you should also clean your computer's cache regularly.

04 Clean up the dust.

You should also regularly clean the dust of your computer, including its parts, and also cool your computer.

The computer should be cleaned regularly

After using the computer for a period of time, I unconsciously found that the temperature of the computer came up, and the "whirring" sound of the fan kept screaming, and the computer shut down directly after a certain extent. If this situation occurs, please go directly to the computer maintenance point and let the professional personnel give you a comprehensive cleaning of the inside of the computer, the ** ash cleaning is generally 30-50, depending on the difficulty of disassembling the computer. Remember:

You can learn how to clean the ash from others, and next time you can clean the ash yourself.

Be careful about computer hardware

After the hardware of the computer is upgraded, the overall performance may be improved, but in the case of the same CPU, increasing its processing speed will definitely increase the CPU problem. For example, adding a memory module to the computer, of course, we are browsing the web and other great changes, but the memory module is not the bigger the better, it depends on whether the computer's CPU can withstand it, otherwise it will burn out the computer. Recommendations:

Memory modules are added as appropriate with the advice of a professional.

Make good use of Optimizer

Optimizer may give the computer a comprehensive test, as well as the temperature detection, the temperature will be too high will alarm, the CPU, graphics card, hard disk temperature in real time display, more than this reasonable'The temperature will be displayed in red, which can give us a reference when we usually use it.

Replace the grease

Silicone grease aging causes the thermal conductivity to be greatly reduced, in fact, many people don't know that there is a thermal grease link between the processor and the cooling fan, the biggest role of silicone grease is to better link the processor chip and the cooling fan together, to achieve the best heat dissipation and thermal conductivity environment, but the notebook is practical for a long time, and the hot-cold-hot situation causes the aging of silicone grease, and the thermal conductivity of the aging silicone grease is greatly reduced, not only can not conduct heat better, It even hinders the transfer of processor heat to the cooling fan, which is also one of the reasons for the high heat generation of the notebook.

Solution: Replace silicone grease, the premise is to replace the silicone grease with relatively high purity, the notebook has high design requirements, so the silicone grease is different from the desktop, the original silicone grease must be very good, but basically can not be bought, so it is recommended that you buy imported high-purity silicone grease, a needle is about 40-60 yuan, you can also go to a special maintenance station and after-sales replacement silicone grease.

1. Open the chassis to clean up the dust, which will cause the components to conduct heat difficult.

2. Install new heat dissipation equipment. Such as fans, water cooling modules, etc.

3. Use overclocking software to downclock the CPU or graphics card.

4. Take a sealed ice pack and place it on top of the case.

5. You can turn on the fan of the chassis board and point and blow it, and reduce the indoor temperature.

6. Change to a case with better heat dissipation, or put the case in an open and ventilated place, and do not place it in a closed corner.

On the one hand, it actively dissipates heat for the CPU. On the other hand, the ambient temperature should be lowered. So generally speaking, change to a better heat sink, such as one with a heat pipe.

Reapply silicone or something. The ambient temperature is to add a system fan, or you can directly open the side panel and take a fan to blow, the effect will be obvious. Do not place the chassis in a sealed space.

Heat dissipation is a big knowledge, and it is currently done according to Intel's standards, if you are interested, you may send it to you to see.

To optimize the system first, you can use 360 to close the programs and processes that are not used, streamline the processes and programs of booting, and then try the temperature; If it is still high, you can clean the machine, and if you have difficulty cleaning yourself, you can go to professional maintenance.

Take the laptop apart, get rid of the dust inside the heatsink (to be clean), and then remove the silicone grease from the CPU and graphics card. Replace with a new silicone grease.

Let's take a look at the environment you're in, whether it's also very hot

Look at the temperature of your computer is usually a bit high, it is estimated that the heat dissipation of the computer is not good, see if there is too much dust?

Clean up the things next to the computer, don't affect the heat dissipation, don't block the wind Put the four corners of the computer high, which is empty under the computer, you can improve the heat dissipation efficiency, if it still doesn't work, it is recommended to disassemble the computer and do it

1 Physical cooling Keep the back of the computer case a little further away from the wall and keep a ventilated space2 If this happens to the new computer, check whether the fan is normal, and check whether the fan is covered by dust to affect the cooling effect.

3 Dust the entire chassis and check whether the motherboard is bulging.

4 The high temperature has little to do with the memory module, but in view of the fact that the temperature only rises when playing a game, try to replace the memory module after the above situation is ruled out.

Isn't there a miniature water-cooled air conditioner now! The power is more than 100 W, the refrigeration capacity is more than 300 W, and the size is very small.

1.The computer case is hot, mainly because the CPU is too hot.

Sometimes, in the summer, the CPU can even reach 90 degrees Celsius, which will cause the computer to shut down automatically. So the stuck point is not serious.

2.The easiest way, and the most cost-effective, is to place the computer in a ventilated place, or near an air conditioner, to physically cool down.

3.In the "Control Panel" of the Windows system, there is a "Power Options", open it, you can see that the "Power Usage Scheme" option has "Minimum Battery Mode", "Home Office", "Portable Pocket" and other options. When we change the solution from "home office" to "portable pocket-sized", we will find that the CPU voltage of the computer is reduced, the power is also reduced, and the heat generation is also reduced, so as to improve the heat dissipation of the computer.

Hello: I have a way to solve this problem that seems to be the best at the moment, you can try ——— rub alcohol!!

1 We know from physics that liquids absorb heat (take away the heat from the surface) when they evaporate, and this can also be confirmed in daily life - you will feel cool when you apply liquid on your hands, and you will feel cold when you are covered in water after taking a shower!

2 That's when you might think of applying water! But applying water is not the best way, alcohol is characterized by being very volatile (that is, evaporating), the faster it evaporates, of course, the faster it takes away the heat, you can try to apply different liquids to your hands, the coolest with alcohol.

3 And that's not all, if you want the alcohol to evaporate faster, blow (the faster the air flow on the surface of the liquid, the faster it evaporates).

Using the method I said, rubbing the alcohol and blowing again, you will find that the computer is very cold in less than 8 minutes.

Is the laptop heat dissipation not good? Don't worry, look here, the results are fast.

The main thing is that the ambient temperature drops down, if you can't do it, open the side cover of the case, find a fan to blow on the case.