Introduction to the experience and learning methods of the second construction exam will take you to

Study method – the preparation process.

First of all, you should formulate a "study time plan" suitable for yourself according to your own situation, and secondly, focus on the key content.

The entire preparation process should be divided into three phases.

Introductory phase. Advanced Stage.

Verify the effectiveness of the review by doing mock questions. After doing the questions every day, you should summarize them, make notes on the key points of review and the questions you don't understand, and find out your weak links for consolidation and review.

Actual combat stage. In the sprint review stage, you should demand yourself according to the specified time and standards of the exam to find the test status.

Learning Methods - Summarize more and reflect more.

Don't take the question as a task, but dig deep into the knowledge and test points behind the question.

It is better to concentrate on doing a good set of test questions than to concentrate on doing a good set of test questions.

Learning method - the skill of answering the questions of the Imperial Family.

When doing multiple-choice questions, it is necessary to reasonably adopt methods such as "direct selection method", "elimination method" and "comparison method". At.

Multiple choice questions and fewer choices will be scored, and wrong choices will not be scored, so do not answer uncertain options.

Subjective questions are the type of questions with the highest score in the test paper, and they are more difficult. Most people think that the more words in the code, the better, whether they are on the side or not, write them first, and let the adjudicator find the answer by himself, which is not advisable and easy to backfire.

It should be particularly emphasized that many candidates start answering questions without even reading the requirements of the questions carefully in order to improve their speed when doing the questions. For example, a multiple-choice question stem requires the "best" answer, and there must be other alternative answers, and it would be a shame to lose points if you didn't see the stem.

pwd=2d72 Extraction code: 2d72 Resource content: analysis of real questions of one construction and two constructions, electronic books required for the new version of the exam, mind maps, mock exam papers, high-quality online courses, overcharge, general charge, pre-exam sprint, courseware, textbooks, brush question bank, all kinds of latest questions, 0 basic classes and other learning resources sharing, including construction engineering, highway engineering, railway engineering, civil aviation airport engineering, port and waterway engineering, water conservancy hail and hydropower engineering, municipal public works, communication and radio and television engineering, mining engineering, mechanical and electrical engineering, etc.

Step 1: Read through the book in two to three months: Make the most of your commute.

Many of my friends are very busy at work, and they have a lot of trivial things when they come home from work. Then the only time you can read is on the bus or subway to and from work. Don't be afraid of being embarrassed, you can't drive a car, so you can watch for nearly two hours a day to and from work (depending on your specific situation).

Step 2: Summarize the key points in about a month.

After reading through it, you can start to summarize the main points. There are many friends who are hesitant to sign up for classes, and I will briefly mention them here. If you have a foundation before or do not feel difficult when reading through the whole book, and you have a correct and efficient learning method, you can not register for classes; If you don't understand the basic concepts, and you are still confused after reading the whole book, you can consider enrolling in classes according to your own situation.

The purpose of registering for a class is to summarize the teacher's summary and analyze the key difficulties thoroughly, avoid taking the wrong road, and be targeted.

In short, the second step is to sort out the key points on the basis of reading through. This work can be done on weekends, depending on the individual, but it is best not to exceed four weeks.

Step 3: Two weeks to cut down the complex.

At this point, the key points have been summarized, so the next step is to streamline the key points. This step is very important and is the core content of the Constructor II exam review. Why?

Because the standard for us to take the second-level constructor test is the score, as long as the total score is 60%, you can pass, how to get the score, especially how to score the case questions of the practical subject, that is, to answer the score correctly!

And this step is simplified, and the focus of refining knowledge is to allow everyone to refine these "score points", and then memorize them accurately. As for the method of refining the scoring points, the best thing is to summarize from the past past papers. Then classify and sort out all the case questions, and then compare and sort out the standard answers to similar questions in this type of questions, summarize the "standard answer order", and pay attention to the keywords that will be involved in each standard answer, these are the scoring points!

On the one hand, this practice can summarize the key points of the answer, and on the other hand, it is convenient for future memorization and aimless review.

How to prepare for the practical subjects of Constructor II What should I pay attention to? Compared with the two public courses of regulation and management, the difficulty of the second construction practical course is relatively large, so what methods should be mastered when preparing for the practical subjects, and what should be paid attention to, the following Dali Education will give you a specific introduction.

1.Make a scientific and reasonable study plan.

1) Time allocation: The time allocation of professional practice courses and two basic courses should be reasonable;

2) Stage plan: course learning + textbook study + exercise practice + mock exam training.

2.Regularly sort out, digest, practice, and summarize the knowledge points learned.

1) When the knowledge accumulation reaches a certain level, it is necessary to sort out, merge, simplify and integrate, and only in this way can candidates use the knowledge points more flexibly during the exam. The specific methods are: "summarizing and recalling", "in-depth thinking", "forming a knowledge system", "simplifying the knowledge system", etc.

2) Change the order in which the course chapters are learned. When you start studying, you can study your favorite chapters or study the chapters with higher scores first, so that it is easy to have learning experience and satisfaction. In addition, it can be learned in accordance with the specific procedures of the project, such as bidding, bidding, bidding, construction preparation, construction and management (quality, schedule, cost, safety, contract), quality acceptance, etc.

3.Do the exercises.

1) Do more real questions and exercises with high gold content, and learn to draw inferences from one case to another.

2) Don't let go of the mistakes that often go wrong; For weak links, it is necessary to carry out targeted "special training".

Practical Exam Preparation Tips:

1.Multiple choice questions: It is necessary to carefully review the questions, identify the pitfalls, and understand the meaning of the questions, and the time for each question is generally controlled to about 1 minute.

2.Multiple-choice questions: It must be noted that it is necessary to select "2-4 options that match the topic", and those who miss each choice have 1 correct score, and 0 points are awarded for the wrong items.

3.Case questions: Practical case questions are more comprehensive and not as single as the points examined in multiple-choice questions.

For example, the ability to read professional drawings, the ability to summarize construction technology, the ability to identify the "sound outside the strings" of knowledge points, and even the ability to expand knowledge points outside the textbook are examined. The case questions are difficult, demanding, and the exam time is urgent, and candidates can only give full play to the knowledge points if they are proficient in them. Therefore, when candidates encounter difficult questions in the examination room, they should have the courage to try and be good at analyzing and thinking from all angles.

Sometimes the answer can be derived through "common sense", but it must also be judged based on basic knowledge.

4.If the candidate is able to complete the test paper in advance, he must check it carefully. If you are not sure, respect the original choice.

5.Allow about 20 minutes to apply the card, the method of painting the card is correct, calmly, and prevent the wrong application.

6.The answers to the case questions should be written in the designated answer area, and the paper should be as neat and organized as possible.

Practical subjects are more difficult than public courses, but as long as you use the right methods and persist in your studies, you can pass the course. The essence of the word: grab the base score.

It can be said that the basic score cannot be lost; For difficult questions, get a little point, which adds up to enough. Practical questions and answers, have tested "five cards and one map", tested "four do not let go", tested "safety accident level", tested "cost accounting three synchronization", and tested "three inspection system", such a score question, there are still many people who make mistakes.

The first step is to learn the exam 100 intensive lecture class, this course is the teacher page by page to teach the textbook, for everyone to lay the foundation, such as to distinguish the employer contractor, the contractor, the construction unit, such as bidding and bidding, such as foundation pit formwork support. Don't look at these concepts as simple, they may not be understood by beginners. The intensive class is to let everyone understand the concept, and the teachers in key places will also let everyone write and draw.

The second step is to learn the exam 100 crash course, this stage is the most important, and the number will be very small. It is to talk about key knowledge points, and there will be summaries at this stage, such as the construction municipal administration likes to take the "five cards and one picture", and the teacher will definitely let you memorize it. For example, if the mechanical and electrical department likes to test the "three inspection system", the teacher will definitely talk about it.

At this stage, in fact, the knowledge points need to be memorized.

In the third step, it is recommended to focus on the special class of 100 cases of the exam. It is suitable for all candidates, focusing on the classic cases of the common examination, the famous teacher teaches the method of quick problem solving, and the answer directly sets the template, so that you can easily get points!

The fourth step is to do the past questions, and do the past questions more than three times.

There is not much time left before the exam, and students who are ahead of the progress should check and fill in the gaps, and return to consolidate the knowledge points according to the wrong questions; Students with a weak foundation should first adjust their mentality, don't panic, plan their study plan reasonably, and then digest and thoroughly digest each knowledge point according to the plan, and strive to pass it once this year.

Because the practical knowledge points are very miscellaneous and messy, it is important to write down the knowledge framework of the whole book in your mind. A table of contents is the best framework for knowledge. With this knowledge framework, every knowledge point we learn in the future is to add branches and leaves to the framework, be organized, have ideas, be neat, and not messy.

Memorizing the table of contents is a matter of twice the result with half the effort.

Including intensive classes, sprint classes, and exercise classes. These courses are available on the exam 100, buy a full-subject ** class, a few hundred yuan, and you can retake it for free for a year, which is very cost-effective! Don't go to buy pirated copies online, pirated copies are very miscellaneous, and the watermark is messy, there are no handouts, some of the information is incomplete, and the time and effort to find pirated copies outweigh the losses.

The crash course is a refinement and summary of key content and high-frequency test points, and it is a key course that can be passed. The exercise class is mainly to check and fill in the gaps and practice the feel. From ancient times to the present, from childhood to adulthood, our learning method is to hold a book and listen to the teacher.

The real questions are the main ones, and the exercises are supplemented. There are 5-10 years of past papers on Exam 100, and the last three or four years are preferred. It is possible to retake the knowledge points that have been tested, and the quality of the real questions is the highest.

It is normal to do each set of past papers three or four times. The main purpose of the exercises is to test your own learning results, check and fill in the gaps, and grasp them in time if you don't know what you don't know. At the same time, it is also a practice.

If you follow the above methods, you will definitely pass the second construction practical exam. The essence of Erjian is not, study for two hours a day, persist until the exam, and ensure that you can pass the exam.

You can click on my avatar to follow, which has the experience sharing of students.

Before the start of the preparation for the second construction exam, it is necessary to clarify the time schedule, and it is expected that at least three rounds of review will be conducted.

The sooner you prepare for the exam, the better, at least three months before the Constructor II exam. At least 2 hours a day should be devoted to studying, and the fragmented time should also be used wisely. Having a clear and reasonable plan has a greater decisive role in the efficiency of the preparation and review of the second construction.

Textbooks are the foundation of the exam, after browsing the textbooks of the second construction, you must sort out the structure of the textbooks, summarize the knowledge points in modules, and combine the questions of the second construction to understand the knowledge. At this time, the summary is not based on the handouts, notes, etc. obtained somewhere, but the content summarized based on one's own understanding of the textbook, and a lot of knowledge in the second-level constructor exam can only be digested by chewing on oneself.

In the process of preparing for the exam, almost all of us will watch online classes or take offline classes. Classes are passive reception of knowledge, and self-study after class is active absorption, and the combination of the two will have better results. Even if the teacher speaks well, it is difficult to fully absorb it if you don't think about it after class.

It is necessary to take notes from time to time, be good at summarizing and summarizing, and try to learn from the past when reviewing, so as to improve the learning efficiency in the preparation for the second construction exam.

The real questions are the most reflective of the difficulty and scope of the Erjian exam in previous years, and are the most referenced. For people in the non-construction industry, because of the lack of use of book knowledge, they can only practice more real questions of the second construction to strengthen their mastery of the test center. If you spend a lot of time doing it, it is very likely that you will not be able to complete all the questions within the specified time, so when preparing for the second construction exam, you must do more sets of questions and know the time allocated for each question type.

The mock test is a test of your previous learning achievements so that you can know your level during the preparation stage.

Every Erjian test preparer should prepare their own mistake book, and they should use it from the beginning of the question. Mistakes are often the weak points of your knowledge, and you should understand the reasons for your mistakes in each question, summarize the test points that are easy to make mistakes, and focus on consolidating these points in the final round of review. In the second-level constructor exam, it is more about the mastery of the method, rather than "memorizing more liquid and making trouble", especially the case questions, you can't just read and memorize, but you must be able to make it independently, and summarize your own methods from the wrong questions.

The second-level constructor does not need to worry about preparing for the exam, and comes directly to the exam 100 platform, which has a large number of chapter exercises, mock test questions and real questions from previous years, to help you use fragmented time, all subjects, single subject ** class, through the teacher's professional guidance, learning to achieve twice the result with half the effort.