-
1. Check whether the temperature of the water tank is consistent with the actual water temperature, if the temperature of the water tank shows 50 degrees, the water has been cold, indicating that the water tank temperature sensor is broken, just change the sensor.
2. Check whether the temperature setting of the water tank on the wire controller is too low, and the temperature of the water tank has reached the set temperature, so it will not be started.
3. If the outdoor fan does not rotate and the unit is faulty and shut down, the fault will be displayed on the control panel. Contact after-sales.
-
...How many degrees of downtime... Generally this is the most common.
Jump high voltage protection... The external machine is the host... If the external unit does not move, it will naturally not be heated.
That is, there is no hot water heated... Need to find someone to inspect and repair it. If it's usually good. Slowly it can't go up, it's just that the refrigerant is not enough, just add the refrigerant.
-
Haier air energy wind pressure failure is mainly to determine that the fan of the water heater cannot work normally, resulting in exhaust gas can not be discharged and oxygen is insufficient, and the water heater cannot work normally, and the wind pressure failure is prompted.
To troubleshoot, first of all, check whether there is debris in the smoke pipe, if not, you can press the reset function key of the water heater.
-
If you still can't get the water temperature up according to the customer service's requirements, you need to ask the maintenance personnel to go to the site to test it.
The temperature sensor is not a problem.
-
1. The installation location is a problem, the air energy water heater needs to be installed in a ventilated place, so that it can be installed on the balcony. Solution: Adjust the installation position or install a fan for ventilation.
2. The refrigeration dose is small, and the refrigerant is too low, which will also lead to too low temperature. Solution: Add refrigerant, generally R134A environmentally friendly refrigerant is better.
3. The capacity is small, and the small capacity will cause the water consumption to far exceed the capacity, resulting in slow heating speed. Solution: I would like to contact the manufacturer to replace the model or increase the host and water tank (split) next to the regret, generally 150L for 3 people, 200L for 4 people, if the water consumption is large and the bathroom is more, you can increase 50L more.
4. The heat exchange fin is dirty, and the heat exchange fin is dirty, resulting in slow heating and slow rise of water temperature. Solution: Clean the heat exchange fins regularly and keep the surroundings of the machine clean and tidy.
5. Scale factor, scale will appear in areas with hard water quality, and scale will also affect water temperature and temperature. Solution: Add water purification equipment or clean the heat exchanger regularly.
I will share here, if consumers encounter problems such as the water temperature of the air energy water heater is not high, the water outlet temperature cannot go up, etc., from the installation location problem, the refrigeration dose is small, the capacity is small, the heat exchange fin is dirty, and the scale factor is investigated one by one, and then solved, I hope you have comfortable and constant temperature hot water.
-
Summary. Hello, according to your problem, the reason why the water temperature of the air energy water heater cannot go up is that the insulation effect is poor, and the poor quality of the insulation layer of the air energy water heater will lead to the rapid loss of heat in the water tank.
A good insulation layer should be made of imported foaming materials, foaming at one time, foaming evenly, and the thickness of the insulation layer should be at least 55mm. In addition, if the water tank inlet and outlet valve port is not tightly sealed, or the insulation work in the hidden place is not in place, it will accelerate the heat loss, so that the user feels that the water temperature of the air energy water heater cannot go up.
Hello, according to your problem, the reason why the water temperature of the air energy water heater cannot go up is that the insulation effect is poor, and the poor quality of the insulation layer of the air energy water heater will lead to the rapid loss of heat in the water tank. A good insulation layer should be made of imported foaming materials, a chain of foaming, uniform foaming, and the thickness of the insulation layer should be at least 55mm.
In addition, the inlet and outlet valve ports of the water tank are not tightly sealed, or the insulation work in the hidden place is not in place, which will accelerate the heat loss and make the user feel that the water temperature of the air energy water heater cannot go up.
2: Refrigerant leakage or insufficiencyRefrigerant leakage or insufficiency will cause the empty pants to contain gas and the heat carrying capacity of the Huluxiao water heater is insufficient, the heating efficiency is reduced, and even the heating cannot be heated. If the water temperature of the air energy water heater cannot be raised due to this reason, the user needs to notify the after-sales personnel to come to the door for maintenance, supplement the refrigerant, and ensure the normal use of the hot air water heater.
This is the need for repair or after-sales service.
This can also happen if the water pressure is low.
-
1. The installation location is a problem, the air energy water heater needs to be installed in a ventilated place, and it should be installed on the balcony. Solution: Adjust the installation position or install fan ventilation.
2. The refrigeration dose is small, and the temperature will be too low. Solution: Add refrigerant, preferably R134A environmentally friendly refrigerant.
3. The capacity is small, and the water consumption will far exceed the capacity, resulting in slow heating speed. Solution: Contact the manufacturer to modify or increase the host and water tank (split type), generally 3 people 150L, 4 people 200L, if the water consumption is large, more bathrooms, you can add another 50L.
4. The heat exchange fin is dirty, and the heat exchange fin is dirty, resulting in slow heating and slow rise of water temperature. Solution: Regularly clean the heat exchange fins to keep the machine clean and tidy.
-
There may be several reasons why the water temperature of the air energy water heater is low and cannot go up:
The inlet water temperature of the air energy water heater is too low, resulting in the hot water temperature not reaching the set temperature. You can check whether the inlet pipe is unobstructed and whether there are problems such as cold water backflow.
The heating element of the air energy water heater is faulty, and the hot water cannot be heated properly. It is possible to check if the heating element is working properly and if it needs to be replaced.
The temperature sensor of the air energy water heater is faulty, causing the hot water temperature to not be adjusted properly. You can check if the temperature sensor is working properly and if it needs to be replaced.
The controller of the air energy water heater is faulty, resulting in the normal adjustment of the hot water temperature without a cover. You can check if the controller is working properly and if it needs to be replaced.
Solution: Check whether the inlet pipe is smooth, whether there are problems such as cold water backflow, and ensure that the inlet water temperature reaches the set temperature.
Check that the heating element is working properly and if it needs to be replaced.
Check that the temperature sensor is working properly and if it needs to be replaced.
Check that the controller is working properly and if it needs to be replaced.
If none of the above methods can solve the problem, it is recommended to contact a professional maintenance personnel for inspection and repair. At the same time, in order to avoid the occurrence of similar failures, it is recommended to regularly maintain and maintain the air energy water heater to avoid failures caused by long-term use.
First of all, choose a big brand, if the production brand does not have core technology, it will lack technical support, and it is easy to have quality problems. Secondly, look at the quality of the compression machine. Finally, there is the capacity of the air energy water heater. >>>More
The efficiency of gas water heaters is usually about 90% (condensing type can even exceed 100%), and the efficiency of electric water heaters is generally above 90% (but considering the primary energy power generation efficiency is 45%, the primary energy efficiency of electric water heaters is about 40%), the air energy water heater is an air source heat pump, and the heating coefficient is generally about 5 (which can be approximated as the efficiency is 500%), and it is estimated that it can reach 3 under low temperature conditions in winter. The overall efficiency is about 5% based on a heating coefficient of 220%. >>>More
Available in 150 or 200 litres.
The selection of air energy water heater capacity is mainly based on the amount of hot water. Generally speaking, each person needs about 50-60 liters of water per day, and customers can calculate according to the actual population of their own family, and in order to prevent various special factors such as visitors, they can choose a larger capacity tank according to the actual situation. >>>More
Founded in 2002, Guangdong Finney Technology Co., Ltd. is an international innovative enterprise focusing on new energy and environmental protection technology, the company integrates product research and development, production, sales and service, and is mainly engaged in air energy heat pumps, water purification, air purifiers and other products. Finney Technology's products in the commercial field involve room heating and refrigeration, domestic hot water, swimming pool constant temperature dehumidification and other equipment, among which the ultra-low temperature heat pump Polaris series replaces the traditional heating boiler, which has been recognized by the national achievement appraisal and has become a "haze" weapon in the northern region, and Finney has been awarded the "Top Ten Leading Brands in the Heat Pump Industry" for many years. [If you are interested, click here to learn more about it for free]. >>>More
Air energy water heaters.
Reason 1 for not starting: the motherboard is faulty, and the motherboard of the air energy water heater is loose, soldered, and burned, which may cause the unit to fail to start due to lack of power. The second reason why the air energy water heater does not start: refrigerant. >>>More