How to charge your phone correctly?

If you are using a Huawei mobile phone, please pay attention to the following precautions in daily use to protect the mobile phone battery and prolong the service life

1.Please use the official standard charger to charge the battery to ensure that the charging voltage is stable and meets the standard, so as to avoid affecting the battery use.

2.Theoretically, keeping the battery in the middle range (e.g. 30%-80%) is more helpful for extending battery life, thus:

1) After the phone is fully charged, it is recommended that you unplug the charger to avoid charging for a long time or being in a high power state for a long time to accelerate the aging of the battery, so as to prolong the battery life.

2) If the mobile phone is idle for a long time, it is recommended to turn off the mobile phone and charge it regularly to maintain about 50% of the battery. If the phone is not used or charged for a long time, the battery may trigger over-discharge protection, resulting in abnormal charging or failure to charge.

3.Too high or too low a temperature can affect your phone's battery life, so:

1) Please try to avoid using your mobile phone in an environment with low temperature, high temperature or large temperature difference.

2) It is recommended that you try to avoid charging and using it for a long time, especially in high-power operation scenarios (such as watching, playing large games, etc.), at this time, the heating of the mobile phone will intensify, and charging and discharging for a long time at high temperature will accelerate the aging of the battery.

Do you know the misunderstandings of mobile phone charging, it's not too late to understand.

In the case of using the original charger, because of the current battery technology problems, it is best to control the power between 35% and 85%, so that the battery life can be improved in general, and do not use it while charging unless necessary, especially when charging and playing games, you can imagine that you can use it while charging, for example, 40% while charging and using, at this point, there will be frequent entry and exit, in and out, which will cause excessive loss in this area, It's actually bad for battery life. At present, basically 2 years to change the battery is already the norm, the number of battery cycles more than 500 times will drop the total power by more than 20%, that is to say, about 2 years you flush 100% of the power once a day, 2 years later, although your power seems to be charged to 100%, but the actual power is only about 80% of the amount of the new mobile phone, you will obviously feel that there is no resistance, at this time you need to replace the battery. If it is not the original charger, there are many problems, such as whether the protocol is matched, whether the data line can stabilize the current, etc., because the word count problem is not written here, if you have any questions about this, you can also send a private message.

1. Don't wait for the battery to run out before charging; Over-discharge will have a certain impact on the battery, and in severe cases, it may cause the device to fail to turn on normally, try to charge it in time when the power is too low;

2. It is recommended to use the original charger and data cable for charging; Non-original chargers may have various problems that may damage the battery and reduce the life of the battery;

3. When charging, try not to play while charging, at this time, it is easy to increase heating, easy to lose the battery, and shorten the service life of the battery;

4. After the charging is completed, please disconnect the power supply in time to avoid charging for a long time;

5. Avoid using the equipment in a high-temperature environment.

Proper charging of mobile phones is a prudent method:

1. Do not continue charging after full charge. Once the phone reaches 100 charges, it goes into "trickle-up" mode – staying fully charged. If you continue to charge, the mobile phone battery will be affected by the current current, and some chemical components will be damaged, affecting the efficiency of use.

2. Don't charge to 100. When a lithium battery is fully charged, the voltage inside the battery will rise, increasing the burden on the battery. Therefore, the mobile phone can be plugged and unplugged at any time, as long as it can be maintained normally so that the beam can be used.

3. You can connect your mobile phone at any time. As long as there is a power supply, the phone can be charged at any time. Because lithium batteries are commonly used in mobile phone batteries, plugging and unplugging the power supply multiple times will not affect the battery. When the phone is drained by 10 years, the charging effect is the best.

The correct way to maintain the battery

1. Develop good usage habits, don't wait until the power is completely out of power before charging, and don't overcharge continuously for a long time. It is best not to lower the battery level of the mobile phone when charging, which can protect the battery and prolong the life.

2. The whole process of mobile phone battery charging includes three stages: fast charging, continuous charging, and trickle charging. After the first two phases, although the system level shows 100, in reality the battery does not really reach saturation. At this point, the remaining capacity can only be replenished by a tiny pulse current, which usually takes 30-40 minutes.

When all three stages are completed, the battery can really reach a good state of power saturation. Third-party battery management software can be used to monitor the charging condition of the battery.

3. Try to use your mobile phone as little as possible when charging. Because the lithium battery is charged even if it is interrupted many times, it will not have much impact on the battery itself, so it is better to disconnect the power supply when you need to play ** or play games.

1. Don't wait for the power to run out before charging, over-discharge will have a certain impact on the battery, in serious cases, it may cause the device to fail to turn on normally, try to charge in time when the power is too low;

2. It is recommended to use the original charger and data cable for charging, non-original chargers may have various problems, which may damage the battery and reduce the service life of the battery;

3. When charging, try not to play while charging, at this time, it is easy to increase heating, easy to lose the battery, and shorten the service life of the battery;

4. After charging, please disconnect the power supply in time to avoid charging for a long time;

5. Avoid the use of equipment in a high temperature environment.

The correct way to charge your phone is to use the original charger and data cable, plug it into a power socket and connect it to the charging port of your phone. First of all, it is necessary to ensure that the charger and data cable are original accessories, and the output voltage and current of the charger meet the charging standards of mobile phones. Also make sure that the charger and charging cable are not damaged or cracked.

The plug should be plugged in firmly to avoid poor contact or loosening. Due to the composition characteristics of the lithium battery of the mobile phone, in order to avoid the aging of the battery, it is generally recommended to use the low-current charging mode for mobile phone charging, and stop charging when the power is less than 20%. In addition, it is important to note that in the process of using the mobile phone, do not charge and discharge frequently in a low power state, which will accelerate the aging of the battery.

The correct charging method can not only ensure the battery life and safety of the mobile phone, but also improve the charging efficiency and save charging time. In addition, if you don't use your phone for a long time, it's best to fully charge the battery and turn off the switch to charge it to avoid excessive consumption of battery power and improve the charging life of the battery. When charging, if you feel that the mobile phone screen is abnormally hot or the charging speed is slow, you can consider replacing the charger and data cable, and check whether the battery of the mobile phone is aging or has been used for too long.

In short, the correct way to charge the mobile phone is to use the original charger and data cable for low-current charging, avoid frequent charging and discharging in a low power state, charge regularly and replace the aging charger and data cable in time, in order to ensure the long-term use and health of the mobile phone's battery. <>