Why is broadband dropping every day? Why does my broadband keep dropping?

Broadband disconnection is generally caused by unstable network, you can restart the router to try.

1.There is a problem with the cat or router.

2.The crystal head of the network cable is loose and the contact is poor.

3.There is a problem with the network card.

Hello, you said that this situation is generally caused by carrier lines, cats, routers, etc.

1 The cat has been left open for a long time, it is very hot and hot, it is recommended to place the cat in a ventilated place as much as possible, and do not overlap with the router. so as not to overheath the temperature. It's really not good to recommend changing a cat with good performance (I hit ** to go to telecom, free to change).

2 Several computers share the network, because the router is too poor, others use P2P to watch movies, etc., it will drag the router to death, restart the router will be better, the long-term solution is to change to a better enterprise-level router.

3. The operator's computer room is far away from your home, beyond the ADSL distance, line failure, etc., then ask them to measure the signal strength and line situation (sometimes two lines, one can be connected to the Internet if one is broken, but the network speed is slow, easy to drop, ordinary people can't find it).

Please find the problem from the above points, I hope it can help you!!

I don't understand hi I !!

The circuit is aging and the crystal head is in poor contact.

NIC driver or aging problem (try to change the NIC and upgrade the NIC driver);

Router problem, not set up properly;

1. Restore factory settings;

2. Enter the route to reset the settings; （admin）

3. Enter the account password provided by Telecom; (Save).

4. Restart your computer.

It may be that there is a problem with the line or the crystal head on your side and the interface, you can try it again.

Remove the routing try, do not report the broadband fault, do not change the cat, the voltage is unstable. That's all there is to it.

If you are using Tietong, it is normal for the connection to drop. If it is something else, then you check if the following joints are slippery

It's a hot summer, the temperature is high, don't you feel hot? You put me here and don't care about us; The temperature of my chip is above 40 degrees, the temperature of the hard disk is higher than 45 degrees, and the temperature of the network card is more than 80 degrees; Can you work in such an environment? You still have a fan or an air conditioner or something, do you mind my business?

The same goes for our devices (devices are: cats, routers, network switches, hubbles, computers, etc.) that feel hot and can't work for you anymore; You can't go to the Internet, you look for masters in the north and south, don't cool me down, you can't find anyone (or replace cats, routers, etc.), because our brothers have the same temper, if you don't cool us down, we will strike!

You may wish to take a look at the following methods, and use measures that you feel are acceptable to reduce the temperature of my (equipment) working environment, I promise: continue to serve your elderly.

A: Users who often surf the Internet for up to half a year should open the shell of the device after the power is off and clean up the dust inside the device.

b: Place the equipment in a safe place for people, open the lid of the equipment, use air convection to strengthen contact with the air, and naturally dissipate heat;

c: Install a micro fan to the equipment to increase the convection of air and force heat dissipation;

D: If you are doing IT, I suggest that you install a heat sink on the heating part of the device after disconnecting the power supply.

e: After the equipment is disconnected from the power supply, use a 3mm drill bit to drill many holes up and down the equipment to strengthen the air convection flow and improve the heat dissipation conditions;

f: To ventilate and dry the equipment, it is best to make an insulated heat dissipation bracket (there are also notebooks on the market) to support the equipment for natural heat dissipation;

H: Let the adsl cat sync first: power off the cat and restart it.

i: The software settings are reasonable, so that 3 do not install: do not install informal software, do not install P2P (occupy resources) software, and do not install infrequently used software. Turn off all unnecessary network connections, such as Thunderbolt BT Donkey, etc.;

j: Optimize the network Personally, I recommend using some gadgets such as Super Bunny, Optimizer or 360, etc.

K: At least one valid anti-virus software should be installed on your computer.

l: NIC problem: The NIC has appropriate bandwidth and stable operation.

As long as you take care of our brothers (routers, cats, Hubble, network switches and their computers), our brothers promise to truly do: "You respect me, I respect you" for your faithful service. Otherwise, ride a donkey and read the record book--- let's see!

Thank you for adopting my answer!

Thank you: friend!

It should be an issue with the router.

There are many reasons why broadband drops:

1. Line problems: the residential area is relatively old, the telecom lines are aging, and the signal attenuation is more serious when accessing the telecom optical module!

2. Contact problems: poor contact between the crystal head and the first line, poor contact with the telecom terminal!

3. Telecom setting problem: This situation will not occur in general, but there is a certain possibility!

4. System problems: slow data processing, resulting in packet loss, excessive loss of data packets resulting in redundancy and disconnection!

Check the outer edge of the network cable to see if there is oxidation If it is intact, then directly redo the crystal head! The quality of the crystal head is not good, and it will always fall off if it is loose.