How to wire the home projector and how to arrange the socket of the home projector?

The screen size is inches "inches", diagonally in length. 1 inch = centimeter. See how big the screen can fit on the wall. The lens of the projector is adjustable, for example: 40-200 inches. The installation distance also has a certain range, which may not be very accurate.

Installation: It can be hoisted or placed on a table (without installation).

When installing a projector at home, it is generally necessary to reserve four sockets.

1. The power socket of the projector needs to be reserved, and the closer it should be to the machine, the better, as shown in the figure below.

2. The curtain power socket needs to be reserved, as shown in the figure below.

1.First of all, determine the location of the projector, generally placed in the living room or the audio-visual vertical room, a certain distance from the wall. 2.

4.Plug the projector's audio cable into the speaker's audio input. 5.

Install the remote control battery of the projector and test whether it can be used normally. 6.Adjust the projection angle and focal length of the projector as needed to make the picture clear and bright.

7.Finally, place the projector's remote control in an easily accessible place for daily use.

You need a VGA cable, and if it's a network-shared projector, you also need a network cable.

Home-installed projectors are arranged with different cables according to different needs, generally as follows:

2. If you need to connect the set-top box to the projector, you can also add a coaxial cable, 75 3 or 75 5, you need to weld the shower heads at both ends.

Power cable, VGA cable, as long as these two wires are fine.

If you want to connect the set-top box to the projector, you can also add a coaxial cable (75-3 or 75-5) and weld the lotus head on both ends. (The current set-top box generally has a VGA interface, and it depends on your personal consideration whether to add this line.) ）

Not necessarily cheap hundreds expensive tens of thousands.

When installing a projector at home, it is generally necessary to lay out four sockets.

The socket of the curtain is often opened on the top, and if the projector is also hoisted, it is to leave two sockets on the top. This will make it more convenient for us to use.

In terms of wiring, there are two different ways to choose from: open wire and dark line.

Walking the bright line is to let the line be exposed to the outside to see the place, although a little messy, but it is convenient to set up, suitable for the small partners who have been hardcovered; To take a dark line is to make a groove in the wall and hide the line in the wall or ground.

Therefore, the buried dark line is to dig the wall and plan, which is suitable for users who are still in the decoration stage. There are a total of three projector socket wiring to consider, including two HDMI cables and one audio cable, corresponding to the input and output of the projector respectively.