-
Anonymous users2024-02-06To be precise, no, refrigeration engine oil is mainly made of naphthenic base oils, and engine oils are mainly made of paraffin-based base oils. The viscosity of naphthenic base oils is not high enough, so when used on motorcycles, the viscosity changes greatly due to the increase in operating temperature, so that the benign lubrication effect cannot be maintained.
-
Anonymous users2024-02-05No, because it is used for air conditioners, and the nature is different.
Motorcycle lubricants require lubrication and heat dissipation.
Refrigeration oil requires mixed use and lubrication.
-
Anonymous users2024-02-04The donkey's head is not in the horse's mouth.
The most critical indicators of refrigeration oil are: miscibility with refrigerants, high and low temperature performance, no water, and high chemical inertness with refrigerants.
Whether it is possible to do it without water alone, most refrigeration oil is dead when it sees water and will hydrolyze; In addition, the working environment of refrigeration oil is sealed and does not come into contact with air.
The engine of the motorcycle is in contact with the air, and it oxidizes, and it sees water, and the refrigeration oil is not hit.
-
Anonymous users2024-02-03It depends on what kind of motorcycle it is, like the Legend 400 or something like that, if it's an ordinary motorcycle, like anything This can be used, both in winter and summer, because it is high, if you are sub-packed, it is recommended that you install 2t, then there will be no risk, and it is recommended to take a small brand to install 4t, low price. A good motorcycle will not add some unknown lubricating oil indiscriminately
-
Anonymous users2024-02-02The viscosity is too bad, don't use it.
If the 100 gauge or more can be used for a short period of time, the viscosity of the 46 gauge is too small, and the oil film thickness is not enough. Can't hang up the oil. It is easy to cause cylinder strain.
-
Anonymous users2024-02-01It can't be used, because the four-stroke motorcycle oil is an internal combustion engine oil, and the No. 46 steam turbine oil is an industrial oil, and if it is used, it will make the cylinder piston easy to generate carbon deposits and emit black smoke.
Steam turbine oil, also known as turbine oil, usually includes steam turbine oil, gas turbine oil, hydraulic steam turbine oil and antioxidant steam turbine oil, etc., which are mainly used for the lubrication of steam turbine oil and sliding bearings, reduction gears, governors and hydraulic control systems of the linkage unit. The functions of steam turbine oil are mainly lubrication, cooling and speed regulation.
Due to the characteristics of energy saving and power, the gas turbine oil is mixed with air (flue gas) by the action of high heat surface during operation, pumped and circulated at a considerable rate, and is used under high pressure, therefore, the gas turbine oil is required to have better high-temperature oxidation stability and wear resistance than the steam turbine oil.
-
Anonymous users2024-01-31Don't use a new car, if it's an old car. It doesn't cost much to buy a good bottle of engine oil, and it is not recommended for landlords. The lubrication effect is best when the turbine oil temperature is 40 degrees, and the temperature in the motorcycle cylinder is much higher than that.
After the freeze dryer has been working for a period of time, a layer of frost will form on the surface of the freezer evaporator. When the frost layer reaches a certain thickness, it will affect the endothermic effect of the evaporator. Generally, when the thickness of the frost layer is 4-6 mm, it is necessary to defrost. >>>More
The lyophilized product is put into the drying bin, the drying bin is connected with the condenser, the vacuum pump is connected with the drying bin and the condenser, the vacuum pump is opened, when the drying bin reaches the set pressure, the water volatilizes and is captured by the condenser, this process is sublimation. Sublimation, as the name suggests, refers to the direct conversion of a liquid from a solid state (ice) to a gaseous state, and then solidifies in a condenser. After that, the product is slowly warmed to remove the moisture completely. >>>More
Now even if you upgrade successfully, it is estimated that you can't see a few days of password and change, recently changed several times, I upgrade and upgrade are annoying, every time I have to spend money to let others to upgrade, now the satellite dish is estimated to be sold, decryption is too troublesome, this boss does not want to give me to take the solution, they are not unreasonable and said: "We are not a manufacturer, I still have a lot of goods not sold, and I will not be returned, who do I find?" ”
First of all: the upstairs guys are very irresponsible!
That's the case,Disclaimer,99% of copycat machines can be upgraded,The principle is to find out the chip combination of your copycat machine,Write the genuine bin file into the chip,Replace the original bin file that has not been upgraded,So that you can receive the genuine machine46+4 units; The principle is actually the same as swiping your phone! >>>More
Dear Lenovo users, hello! For this question of yours, you can refer to the Lenovo Technology Forum, which has the most complete technical questions, and there are professionals in the forum to answer your questions, and you can also communicate your questions with them. >>>More