-
It may be caused by the low signal quality in your area, and you can go to an open place outside to make a call**.
Check if there is any blocking software installed, and then see if there is a problem with the settings, if there is a new setting of blocking, then check the SIM card, and restart the phone. If you can't change a card to try it, and then replace it with the original card, the mobile phone is always busy with the network and basically solved, and there is a situation where the first one does not work, due to problems with the system software, you can flash the phone to solve the busy network. If the service line is too busy, or the phone is not in the network coverage area, the signal cannot be connected, so the phone will also show that the network is busy.
-
There are many reasons for this: it may be that the service party's business is really busy, but this reason is unlikely, the biggest possibility is that the signal transmitter inside your mobile phone is corroded by water, if it is cleaned, it will be better, but you have been shelving it for too long, it seems that the best option is to repair it. Good luck!!!
-
1. Your mobile phone transmitter is broken or blocked by a shielded object.
2. The network is temporarily busy, resulting in some users unable to log in immediately, so you can just wait, or shut down and restart.
3 It may be that the rain has corroded the signal receiver, it is recommended that you go to customer service to check it, if it is a new one, you can also enjoy free inspection or paid replacement of a new machine.
Go ahead, time waits for no one.
-
The part that emitted the signal is boiled in water, so hurry up and clean it, it will be even worse if you use it again.
-
It may be that the receiver is flooded, and on the other hand, it may be the reason why the service side is busy.
-
Hello, the phone showing that the network is busy may be caused by the following reasons:1Unstable network signal:
When the signal is unstable in your area, your phone will show that the network is busy. This may be due to the fact that the coverage of the Shinsesun is small in your area, or there is signal interference in your area. 2.
Network congestion: When many people are using the same network at the same time, the network becomes congested, resulting in a busy network. This could be due to the fact that your area is densely populated, or that there is a large event in your area, etc.
3.Problems with mobile phone software: When there is a problem with your phone software, it can also cause the network to be busy.
This could be due to the low system version of your phone, or the presence of a virus on your phone, etc. 4.Carrier Issues:
When there is a problem with the carrier you are using, it can also cause the network to be busy. This could be due to things like network maintenance or upgrades from the carrier. Workaround:
1.Try moving to an area with a better signal, or wait for the signal interference to go away. 2.
Try using the network during off-peak hours, or use a different network. 3.Update your mobile app, or clear your phone's cache.
-
Hello dear and happy to answer for you. What is the reason why the mobile phone shows that the server is busy: 1. Check whether there is any interception software installed in the first case, and then see if there is a problem with the settings, if there is a new setting to intercept, then check the SIM card and restart the phone.
If you can't change a card to try it, and then replace it with the original card, the mobile phone is always busy with the network. 2. In the second case, if the first case does not work, due to the problem of the system software, you can flash the machine to solve the busy network; 3. The third is because the service line is too busy, or the mobile phone is not in the network coverage area, and the signal cannot be connected, so the mobile phone will also show that the network is busy. That's all my reply, I hope it can help you.
-
System failure. Luo pinyin: luò lào, phonetic
The radical is 6 strokes outside the department, and the total strokes are 9 strokes.
Basic literal meaning. 網 (網) luò (
1. Something like a net: the head of the network. Meridian. Venation. Internet. Tangerine.
2. Wrap it with a mesh and shroud: envelope.
3. Winding: winding. Winding. Winding.
4. Continuous, front and back: Luo acupoint (acupuncture point classification name). Continuous. Streams. Contact.
Other Meanings. 網 (網) lào (
Yitong (一), which is used for some colloquial words.
-
<>1. Check whether the interception software is installed in the first case, and then see if there is a problem with the settings, if there is a new setting to intercept, then check the SIM card and restart the phone. If you can't change a card to try it, and then replace it with the original card, the mobile phone is always busy with the network.
2. In the second case, if the first case does not work, due to the problem of the system software, you can flash the machine to solve the busy network;
3. The third is because the service line is too busy, or the mobile phone is not in the network coverage area, and the signal cannot be connected, so the mobile phone will also show that the network is busy.
-
The mobile phone shows that the network is busy, and the reasons why the network is busy often occur when the mobile phone dials **: weak signal in the call environment, quality failure of the mobile phone card (SIM card) and problems with the insertion of the mobile phone card. 1. The signal of the call environment is weak.
When dialing from a mobile phone, the network is often busy, which is caused by a weak communication signal between one of the two parties to the call. In this case, both parties should switch to a wide place with a stronger signal before making the call. 2. The quality of the mobile phone card (SIM card) is faulty.
The use of an unqualified SIM card (SIM card) will lead to this problem, and you need to go to a regular business office to replace the qualified SIM card. 3. There is a problem with the insertion of the mobile phone card. If the mobile phone is used for a long time, or if it has been dropped or bumped, the mobile phone card slot and the mobile phone card will be misaligned, resulting in the mobile phone card not being able to fully fit the card slot.
When the mobile phone card that does not fit the card slot is dialed, it will prompt that the network is busy, and you need to go to a regular repair mobile phone store to check and replace the mobile phone card slot.
-
1.Cellular network issues. Workaround: Restart the network or change the network.
3.The phone is malfunctioning or stuck. Solution: Restart your phone or restore it to factory settings.
-
Each base station has capacity. It's like a bowl can only hold so much water. If the network is busy, relevant personnel can find it on the network optimization platform and send someone to expand the capacity. If you do this for a long time, call customer service.
Generally, there are three reasons, one is that there are too few wireless channels in the mobile base station you are in or too many people are playing, resulting in insufficient channels.
The second is that your mobile phone card is set up as an IP ** card by the mobile operator, and every time you call**, you actually hit IP**, that is, we have an IP routing code such as 17951 to save money before we call**, and dial this kind of **. Especially at night, the IP routes are busy, so you will often hear the prompt that the network is busy.
The first two are negative, and the transmission channel between the base station and the exchange office is not enough and prompts busy.
I'm using a simple analogy, so I didn't use too technical jargon, and I hope you understand.
If you feel that there is a problem with your phone, you change your card to your friend's phone for a day to try it out, or lend your phone to your friend, if this problem still occurs frequently, it is a problem with the phone. It is best if your friend can stay away from you, not at the same base station, and you can also ask your neighbor if you have this situation when they play ** (it is best to be in the same number segment with you). This way you can tell if it's a problem with your phone.
There is also a bad signal in your house.
Check the Network status, look for the Network area with a good signal, and log in again.
1. It may be that the screen is broken, or it may be because of a chip problem. >>>More
If you are using a vivo mobile phone, the screen failure solution: >>>More
Tingling in urine is usually caused by a urinary tract infection. In addition, inflammation of the prostate can also cause corresponding conditions.
1. Aging of age, aging is the most important cause of ataxia, with the continuous growth of age, the human body's various functions are gradually decreasing, so that the body's immunity is weakened, and eventually leads to the occurrence of diseases. >>>More